Abbas H. Hasan
Research Subjects
Abbas H. Hasan has a total of 34 co-authors. Here are the top co-authors by number of shared publications:
Abdelwahid Azzi
Faculty of Mechanical and Process Engineering, University of Sciences and Technology Houari Boumedien, Algiers, Algeria
4 shared publications- Ammar Zeghloul
Faculty of Mechanical and Process Engineering, University of Sciences and Technology Houari Boumedien, Algiers, Algeria
4 shared publications Hiba Bouyahiaoui
4 shared publicationsShara K. Mohammed
3 shared publications- Abdelsalam Al Sarkhi
Mechanical Engineering Department, Center for Integrative Petroleum Research, King Fahd University of Petroleum & Minerals, Dhahran, Saudi Arabia
2 shared publications - Abdelwahid Azzi
Faculty of Mechanical and Process Engineering, Université des Sciences et de la Technologie Houari Boumediène, BP 32 El Alia, Algiers 16111, Algeria
2 shared publications
Latest Publications
- 3 August 2020
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science
- Vol. 235 (9) , 1567-1584
Theoretical study and experimental measurement of the gas liquid two-phase flow through a vertical Venturi meter
An accurate two-phase flow rate measurement is essential in many applications and industries such as; oil/gas, chemical, pipeline transportation and nuclear industry. This paper presents the findings obtained from two-phase flow rate measurements using Venturi meters coupled with conductance probe sensors. The measurement system and presented methodology can be used to directly and continuously measure the mass flow rate of gas-liquid flows without any need for using a separator. Most of the available data in literature on mass flow rate using Venturis in gas-liquid two phase flows are limited/valid to a certain flow regime. However, the experimental data presented in this paper covered a wide range of flows (i.e. bubbly, slug and churn flows). Three Venturis with different diameter ratios, β = 0.40, β = 0.55 and β = 0.75 have been employed using an air-water vertical test section. The effect of the Venturi’s geometry on the flow behaviour was also evaluated. The average void fraction and void fraction time series have been measured along the test section by nine different conductance probe sensors covering the convergent, throat and divergent sections. In addition, the two-phase pressure drop across the Venturi was measured. Moreover, a new correlation for the gas-liquid slip ratio was proposed in this paper, which is necessary for calculating the two-phase mass flow rate. The proposed slip ratio correlation showed more accuracy than the ones available in literature. It was found that the correlation proposed by Chisholm to predict the two-phase mass flow rate in Venturis with a diameter ratio, β = 0.55, shows the best accuracy among others such as; Murdock, Lin, James and Zhang correlations.
- 3 August 2020
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science
- Vol. 235 (9) , 1567-1584
Theoretical study and experimental measurement of the gas liquid two-phase flow through a vertical Venturi meter
An accurate two-phase flow rate measurement is essential in many applications and industries such as; oil/gas, chemical, pipeline transportation and nuclear industry. This paper presents the findings obtained from two-phase flow rate measurements using Venturi meters coupled with conductance probe sensors. The measurement system and presented methodology can be used to directly and continuously measure the mass flow rate of gas-liquid flows without any need for using a separator. Most of the available data in literature on mass flow rate using Venturis in gas-liquid two phase flows are limited/valid to a certain flow regime. However, the experimental data presented in this paper covered a wide range of flows (i.e. bubbly, slug and churn flows). Three Venturis with different diameter ratios, β = 0.40, β = 0.55 and β = 0.75 have been employed using an air-water vertical test section. The effect of the Venturi’s geometry on the flow behaviour was also evaluated. The average void fraction and void fraction time series have been measured along the test section by nine different conductance probe sensors covering the convergent, throat and divergent sections. In addition, the two-phase pressure drop across the Venturi was measured. Moreover, a new correlation for the gas-liquid slip ratio was proposed in this paper, which is necessary for calculating the two-phase mass flow rate. The proposed slip ratio correlation showed more accuracy than the ones available in literature. It was found that the correlation proposed by Chisholm to predict the two-phase mass flow rate in Venturis with a diameter ratio, β = 0.55, shows the best accuracy among others such as; Murdock, Lin, James and Zhang correlations.
- 1 January 2020
- Published by Elsevier in Journal of Natural Gas Science and Engineering
- Vol. 73
Vertical upward and downward churn flow: Similarities and differences
- 1 January 2020
- Published by Elsevier in Journal of Natural Gas Science and Engineering
- Vol. 73
Vertical upward and downward churn flow: Similarities and differences
- 1 November 2019
- Published by Elsevier in International Journal of Multiphase Flow
- Vol. 120
Dynamics of flow transitions from bubbly to churn flow in high viscosity oils and large diameter columns
- 1 November 2019
- Published by Elsevier in International Journal of Multiphase Flow
- Vol. 120
Dynamics of flow transitions from bubbly to churn flow in high viscosity oils and large diameter columns
- 4 October 2019
- Published by ASME International in Journal of Fluids Engineering
- Vol. 142 (2)
Experimental Investigation of the Vertical Upward Single- and Two-Phase Flow Pressure Drops Through Gate and Ball Valves
This paper presents an experimental investigation of the pressure drop (DP) through valves in vertical upward flows. Experiments were carried out using a 1¼″ (DN 32) ball and gate valve. Five opening areas have been investigated from fully open to the nearly fully closed valve, using air with a superficial velocity of 0–3.5 m/s and water 0.05–0.91 m/s. These ranges cover single-phase and the bubbly, slug and churn two-phase flow regimes. It was found that for the single-phase flow experiments, the valve coefficient increases with the valve opening and is the same, in both valves, for the openings smaller than 40%. The single-phase pressure drop increases with the liquid flowrate and decreases with the opening area. The two-phase flow pressure drop was found considerably increased by reducing the opening area for both valves. It reaches its maximum values at 20% opening for the ball valve and 19% opening for the gate valve. It was also inferred that at fully opening condition, the two-phase flow multiplier, for both valves, has been found close to unity for most of the tested flow conditions. For 40 and 20% valve openings the two-phase multiplier decreases in the power-law with liquid holdup for the studied flow conditions. Models proposed originally for evaluating the pressure drop through an orifice in single-phase and two-phase flows were also applied and assessed in the present experimental data.
- 4 October 2019
- Published by ASME International in Journal of Fluids Engineering
- Vol. 142 (2)
Experimental Investigation of the Vertical Upward Single- and Two-Phase Flow Pressure Drops Through Gate and Ball Valves
This paper presents an experimental investigation of the pressure drop (DP) through valves in vertical upward flows. Experiments were carried out using a 1¼″ (DN 32) ball and gate valve. Five opening areas have been investigated from fully open to the nearly fully closed valve, using air with a superficial velocity of 0–3.5 m/s and water 0.05–0.91 m/s. These ranges cover single-phase and the bubbly, slug and churn two-phase flow regimes. It was found that for the single-phase flow experiments, the valve coefficient increases with the valve opening and is the same, in both valves, for the openings smaller than 40%. The single-phase pressure drop increases with the liquid flowrate and decreases with the opening area. The two-phase flow pressure drop was found considerably increased by reducing the opening area for both valves. It reaches its maximum values at 20% opening for the ball valve and 19% opening for the gate valve. It was also inferred that at fully opening condition, the two-phase flow multiplier, for both valves, has been found close to unity for most of the tested flow conditions. For 40 and 20% valve openings the two-phase multiplier decreases in the power-law with liquid holdup for the studied flow conditions. Models proposed originally for evaluating the pressure drop through an orifice in single-phase and two-phase flows were also applied and assessed in the present experimental data.
- 1 July 2019
- Published by Elsevier in International Journal of Multiphase Flow
- Vol. 116, 1-14
Gas rising through a large diameter column of very viscous liquid: Flow patterns and their dynamic characteristics
- 1 July 2019
- Published by Elsevier in International Journal of Multiphase Flow
- Vol. 116, 1-14
Gas rising through a large diameter column of very viscous liquid: Flow patterns and their dynamic characteristics
- 1 April 2019
- Published by Elsevier in Flow Measurement and Instrumentation
- Vol. 66, 67-78
Thin film thickness measurements in two phase annular flows using ultrasonic pulse echo techniques
- 1 April 2019
- Published by Elsevier in Flow Measurement and Instrumentation
- Vol. 66, 67-78
Thin film thickness measurements in two phase annular flows using ultrasonic pulse echo techniques
- 1 September 2018
- Published by Elsevier in Progress in Nuclear Energy
- Vol. 108, 428-437
Experimental study of the characteristics of an upward two-phase slug flow in a vertical pipe
- 1 September 2018
- Published by Elsevier in Progress in Nuclear Energy
- Vol. 108, 428-437
Experimental study of the characteristics of an upward two-phase slug flow in a vertical pipe
- 1 March 2018
- Published by Elsevier in Journal of Petroleum Science and Engineering
- Vol. 162, 12-21
Experimental investigation of a vertically downward two-phase air-water slug flow
- 1 March 2018
- Published by Elsevier in Journal of Petroleum Science and Engineering
- Vol. 162, 12-21
Experimental investigation of a vertically downward two-phase air-water slug flow
- 1 March 2018
- Published by Elsevier in International Journal of Multiphase Flow
- Vol. 100, 16-29
Churn flow in high viscosity oils and large diameter columns
- 1 March 2018
- Published by Elsevier in International Journal of Multiphase Flow
- Vol. 100, 16-29
Churn flow in high viscosity oils and large diameter columns