On-Chip Fast Signal Generation and Low-Power SAR ADC for SiPM Readout
- 31 January 2023
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 70 (3) , 245-253
Abstract
This paper presents an on-chip fast signal generator and a successive-approximation-register (SAR) analog-to-digital data converter (ADC) for silicon photomultiplier (SiPM) readout applications. The high-pass filter (HPF)-based fast-signal generator sharpens the rising edge of the standard SiPM output signal reducing time jitter due to the dark counts of the detector. It is implemented by leveraging the equivalent resistance of the current mirror transistor and the AC-coupling capacitor between the current mirror and the current discriminator to avoid hardware and power consumption overhead. Compared with off-chip solutions, the on-chip approach eliminates the packaging pins and high-speed buffers needed for carrying the fast signals reducing packaging complexity and power consumption of the readout system. The energy quantizer utilizes the SiPM charge integrator as the ADC track-and-hold (T/H) circuit to improve the front-end power efficiency. The fast signal generator and the SAR ADC are implemented in a current-mode application-specific integrated circuit (ASIC) designed in a 0.18 μm CMOS technology. Measurement results show that the on-chip fast signal generator is effective in improving the timing performance of the readout system. The timing resolutions are measured using SensL’s 3×3 mm 2 SiPM device with a terminal capacitance of 850 pF using an ultrashort laser pulser. Measurement results show that the fast signal generator improves the timing resolution by 23.4% compared with timing measurement using the standard output signal when the output charge is 300 pC. The ASIC achieved a measured ADC signal-to-noise-distortion ratio (SNDR) of 53.08 dB and a spurious-free dynamic range (SFDR) of 62.74 dB at 1 MS/s and a maximum front-end gain non-linearity of 3.3% over 20-800 pC input charge range while dissipating 4.1 mW of power from a 1.8 V supply.Keywords
This publication has 26 references indexed in Scilit:
- Development of a 64-Channel Readout ASIC for an SSPM Array for PET and TOF-PET ApplicationsIEEE Transactions on Nuclear Science, 2016
- A 30-ns recovery time, 11.5-nC input charge range, 16-channel read-out ASIC for PET application2015
- STiC — a mixed mode silicon photomultiplier readout ASIC for time-of-flight applicationsJournal of Instrumentation, 2014
- A Fully Digital 8$\,\times\,$16 SiPM Array for PET Applications With Per-Pixel TDCs and Real-Time Energy OutputIEEE Journal of Solid-State Circuits, 2013
- A fast preamplifier concept for SiPM-based time-of-flight PET detectorsNuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 2012
- Optimizing timing performance of silicon photomultiplier based scintillation detectors2012
- TIMPIC-II: The second version time-based-readout ASIC for SSPM based PET applications2012
- Silicon photomultipliers for high energy physics detectorsJournal of Instrumentation, 2011
- Optimization of a LSO-Based Detector Module for Time-of-Flight PETIEEE Transactions on Nuclear Science, 2010
- Positron emission tomography: An overviewJournal of Medical Physics, 2006