Qingjun Fan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Qingjun Fan has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
Jinghong Chen
Department of Electrical Engineering, University of Houston, Houston, TX, USA
3 shared publications- Hao Deng
Department of Electrical and Computer Engineering, University of Houston, Houston, TX, USA
2 shared publications - Yulang Feng
Department of Electrical and Computer Engineering, University of Houston, Houston, TX, USA
2 shared publications - Andrew Renshaw
University of Houston
1 shared publication Esko Mikkola
Alphacore Inc., Tempe, AZ, USA
1 shared publication- Jinghong Chen
School of Public Health, Health Science Center, NHC Key Laboratory of Environment and Endemic Diseases, Xi’an Jiaotong University, Xi’an, China
1 shared publication
Latest Publications
- 31 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 70 (3) , 245-253
On-Chip Fast Signal Generation and Low-Power SAR ADC for SiPM Readout
This paper presents an on-chip fast signal generator and a successive-approximation-register (SAR) analog-to-digital data converter (ADC) for silicon photomultiplier (SiPM) readout applications. The high-pass filter (HPF)-based fast-signal generator sharpens the rising edge of the standard SiPM output signal reducing time jitter due to the dark counts of the detector. It is implemented by leveraging the equivalent resistance of the current mirror transistor and the AC-coupling capacitor between the current mirror and the current discriminator to avoid hardware and power consumption overhead. Compared with off-chip solutions, the on-chip approach eliminates the packaging pins and high-speed buffers needed for carrying the fast signals reducing packaging complexity and power consumption of the readout system. The energy quantizer utilizes the SiPM charge integrator as the ADC track-and-hold (T/H) circuit to improve the front-end power efficiency. The fast signal generator and the SAR ADC are implemented in a current-mode application-specific integrated circuit (ASIC) designed in a 0.18 μm CMOS technology. Measurement results show that the on-chip fast signal generator is effective in improving the timing performance of the readout system. The timing resolutions are measured using SensL’s 3×3 mm 2 SiPM device with a terminal capacitance of 850 pF using an ultrashort laser pulser. Measurement results show that the fast signal generator improves the timing resolution by 23.4% compared with timing measurement using the standard output signal when the output charge is 300 pC. The ASIC achieved a measured ADC signal-to-noise-distortion ratio (SNDR) of 53.08 dB and a spurious-free dynamic range (SFDR) of 62.74 dB at 1 MS/s and a maximum front-end gain non-linearity of 3.3% over 20-800 pC input charge range while dissipating 4.1 mW of power from a 1.8 V supply.
- 31 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 70 (3) , 245-253
On-Chip Fast Signal Generation and Low-Power SAR ADC for SiPM Readout
This paper presents an on-chip fast signal generator and a successive-approximation-register (SAR) analog-to-digital data converter (ADC) for silicon photomultiplier (SiPM) readout applications. The high-pass filter (HPF)-based fast-signal generator sharpens the rising edge of the standard SiPM output signal reducing time jitter due to the dark counts of the detector. It is implemented by leveraging the equivalent resistance of the current mirror transistor and the AC-coupling capacitor between the current mirror and the current discriminator to avoid hardware and power consumption overhead. Compared with off-chip solutions, the on-chip approach eliminates the packaging pins and high-speed buffers needed for carrying the fast signals reducing packaging complexity and power consumption of the readout system. The energy quantizer utilizes the SiPM charge integrator as the ADC track-and-hold (T/H) circuit to improve the front-end power efficiency. The fast signal generator and the SAR ADC are implemented in a current-mode application-specific integrated circuit (ASIC) designed in a 0.18 μm CMOS technology. Measurement results show that the on-chip fast signal generator is effective in improving the timing performance of the readout system. The timing resolutions are measured using SensL’s 3×3 mm 2 SiPM device with a terminal capacitance of 850 pF using an ultrashort laser pulser. Measurement results show that the fast signal generator improves the timing resolution by 23.4% compared with timing measurement using the standard output signal when the output charge is 300 pC. The ASIC achieved a measured ADC signal-to-noise-distortion ratio (SNDR) of 53.08 dB and a spurious-free dynamic range (SFDR) of 62.74 dB at 1 MS/s and a maximum front-end gain non-linearity of 3.3% over 20-800 pC input charge range while dissipating 4.1 mW of power from a 1.8 V supply.
- 18 March 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Very Large Scale Integration (VLSI) Systems
- Vol. 30 (5) , 625-633
A 5-GS/s 6-Bit 15.07-mW Flash ADC With Partially Active Second-Stage Comparison and 2× Time-Domain Interpolation
This article presents a 5-GS/s 6-bit flash analog-to-digital converter (ADC) in a 28-nm fully depleted silicon-on-insulator (FDSOI) CMOS process. The ADC jointly employs partially active second-stage comparison and $2\times $ time-domain latch interpolation (TDI) to reduce power consumption and avoid extensive calibrations. To enhance the conversion speed of the second-stage structure, the stringent timing constraint is resolved by a 25%–75% duty-cycle clock scheme, a 0.5-bit redundancy in the first comparison stage, and an embedded second-stage slice selection logic. The bandwidth requirements of the track-and-hold (T/H) and T/H buffer under the 25%–75% duty-cycle clock are analyzed. An on-chip successive-approximation (SA)-based comparator offset calibration scheme utilizing FDSOI back-gate bias is also developed, providing sufficient calibration range without impairing comparator speed. The measured prototype achieves a signal-to-noise and distortion ratio (SNDR) of 32.8 dB and a spurious-free dynamic range (SFDR) of 41.82 dB at Nyquist frequency while consuming 15.07 mW power, translating into a Walden figure-of-merit (FOM) of 84.5 fJ/conversion-step.
- 18 March 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Very Large Scale Integration (VLSI) Systems
- Vol. 30 (5) , 625-633
A 5-GS/s 6-Bit 15.07-mW Flash ADC With Partially Active Second-Stage Comparison and 2× Time-Domain Interpolation
This article presents a 5-GS/s 6-bit flash analog-to-digital converter (ADC) in a 28-nm fully depleted silicon-on-insulator (FDSOI) CMOS process. The ADC jointly employs partially active second-stage comparison and $2\times $ time-domain latch interpolation (TDI) to reduce power consumption and avoid extensive calibrations. To enhance the conversion speed of the second-stage structure, the stringent timing constraint is resolved by a 25%–75% duty-cycle clock scheme, a 0.5-bit redundancy in the first comparison stage, and an embedded second-stage slice selection logic. The bandwidth requirements of the track-and-hold (T/H) and T/H buffer under the 25%–75% duty-cycle clock are analyzed. An on-chip successive-approximation (SA)-based comparator offset calibration scheme utilizing FDSOI back-gate bias is also developed, providing sufficient calibration range without impairing comparator speed. The measured prototype achieves a signal-to-noise and distortion ratio (SNDR) of 32.8 dB and a spurious-free dynamic range (SFDR) of 41.82 dB at Nyquist frequency while consuming 15.07 mW power, translating into a Walden figure-of-merit (FOM) of 84.5 fJ/conversion-step.
- 28 April 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 55 (8) , 2082-2093
A Time-Interleaved SAR ADC With Bypass-Based Opportunistic Adaptive Calibration
- 28 April 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 55 (8) , 2082-2093
A Time-Interleaved SAR ADC With Bypass-Based Opportunistic Adaptive Calibration
- 1 September 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Solid-State Circuits Letters
- Vol. 2 (9) , 99-102
A 1-GS/s 8-Bit 12.01-fJ/conv.-step Two-Step SAR ADC in 28-nm FDSOI Technology
- 1 September 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Solid-State Circuits Letters
- Vol. 2 (9) , 99-102
A 1-GS/s 8-Bit 12.01-fJ/conv.-step Two-Step SAR ADC in 28-nm FDSOI Technology