Fracture Energy Reduction Caused by Water at the Crack Front of an Aluminum/Epoxy Resin Interface
Open Access
Abstract
A detailed understanding of interface degradation in humid environments is essential for improving the reliability of adhesive bonding technologies. Water absorption within the adhesive layer significantly affects joint strength, a factor considered to be long-term degradation. However, even if water does not approach the interface from the inside due to absorption, it can reach the interface from the outside through the crack tip and instantaneously affect the fracture behavior of the interface, highlighting the need to investigate short-term degradation mechanisms. In this study, the effect of water at the aluminum/epoxy resin interface on crack propagation was quantitatively evaluated by measuring the mode I energy release rate through double cantilever beam (DCB) tests. By changing the surface condition of the adherend, interfacial and cohesive failures were achieved, and DCB tests were conducted in air and underwater conditions to compare the effect of water on the fracture energy. Results showed that the interfacial fracture energy decreased by more than 50% when the crack propagated in water, but no significant reduction was observed in the cohesive fracture energy. The decrease in interfacial fracture energy in the presence of water indicates the immediate disruption of chemical bonding.Keywords
Funding Information
- Japan Society for the Promotion of Science (JP25K07496)
This publication has 45 references indexed in Scilit:
- Experimental measurement of moisture distribution in the adhesive layer using near‐infrared spectroscopyJournal of Applied Polymer Science, 2023
- Prediction of moisture diffusion and failure in glass/steel adhesive jointsGlass Structures & Engineering, 2022
- Effect of cyclic aging on mode I fracture energy of dissimilar metal/composite DCB adhesive jointsEngineering Fracture Mechanics, 2022
- Using digital image correlation to automate the measurement of crack length and fracture energy in the mode I testing of structural adhesive jointsEngineering Fracture Mechanics, 2021
- A review of the relationship between design factors and environmental agents regarding adhesive bonded jointsJournal of the Brazilian Society of Mechanical Sciences and Engineering, 2021
- Design of Adhesive Joints Under Humid Conditions2013
- A new data reduction scheme for mode I wood fracture characterization using the double cantilever beam testEngineering Fracture Mechanics, 2008
- Modelling anomalous moisture uptake, swelling and thermal characteristics of a rubber toughened epoxy adhesiveInternational Journal of Adhesion and Adhesives, 2005
- Spatially resolved measurements of the diffusion of water in a model adhesive/silicon lap joint using FTIR-transmission-microscopyInternational Journal of Adhesion and Adhesives, 2004
- A generalized theory of fracture mechanicsJournal of Materials Science, 1974