Characterization of Magnetic Losses in the Transformer Tank Steel
- 29 December 2015
- journal article
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Magnetics
- Vol. 52 (5) , 1-4
Abstract
The transformer tank is normally built of construction steel and has relatively large thickness of 1.2 mm for distribution up to 12 mm for large power transformers. In such thick materials, skin effect becomes much more significant than thin materials due to both frequency and non-linearity. The flux density in the tank can vary in a wide range of some mT to 1800 mT (in the case of having high zero sequence flux) leading to a large variation in the permeability and, consequently, in skin depth. Since the losses are high, the temperature rise can also be a main problem influencing the conductivity that must be considered in the loss calculations. The main contribution of this paper is to study the magnetic losses in the transformer tank steel through the measurements and finite difference-based numerical calculations. Using the loss separation principle, different loss mechanisms are investigated, and the behavior of each at the different level of inductions and frequencies is studied.Keywords
This publication has 10 references indexed in Scilit:
- Modeling of Temperature Effects on Magnetic Property of Nonoriented Silicon Steel LaminationIEEE Transactions on Magnetics, 2015
- Calculation of off-core inductance in dual-circuit model of transformer2014
- Accounting for the Influence of the Tank Walls in the Zero-Sequence Topological Model of a Three-Phase, Three-Limb TransformerIEEE Transactions on Power Delivery, 2014
- Topology-Correct Reversible Transformer ModelIEEE Transactions on Power Delivery, 2012
- Loss Separation in Nonoriented Electrical SteelsIEEE Transactions on Magnetics, 2010
- Viscosity-based magnetodynamic model of soft magnetic materialsIEEE Transactions on Magnetics, 2006
- Transformer Modeling for Low- and Mid-Frequency Transients—A ReviewIEEE Transactions on Power Delivery, 2005
- Transformer Engineering2004
- Physical interpretation of induction and frequency dependence of power losses in soft magnetic materialsIEEE Transactions on Magnetics, 1992
- General properties of power losses in soft ferromagnetic materialsIEEE Transactions on Magnetics, 1988