Performance enhancing for a highly loaded tandem cascade by endwall incoming vortex–corner separation interaction
- 26 May 2021
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science
- Vol. 235 (23) , 6833-6846
Abstract
In highly loaded tandem compressor cascades, corner separations can still exist. In order to eliminate corner separations in highly loaded tandem compressor cascades, incoming vortex–corner separation interaction mechanism was investigated. Different schemes of the vortex generators, which located at different pitchwise locations and could generate vortexes with different rotation directions, were designed and investigated numerically. Results show that, severe corner separation occurred at the front blade passage of the tandem cascade; by utilizing flow control method of incoming vortex–corner separation interaction, the corner separation could be reduced significantly. The optimal control effect of incoming vortex on corner separation was achieved with anticlockwise rotation and the vortex generator is located right ahead of the leading edge of tandem cascade, a maximum loss coefficient reduction of 21.8% being achieved. Different from single blade configuration, the boundary layer of tandem cascade was regenerated at rear blade suction surface due to the injection flow from blade gap between the two blades. Though corner separations could be reduced at both conditions, the loss of tandem cascade with clockwise incoming vortex is higher than that with anticlockwise vortex, and a smaller corner separation region at suction surface was achieved by utilizing clockwise vortex. The mechanism was that anticlockwise incoming vortex reduced the corner separation but increased secondary flow, while clockwise vortex enhanced passage vortex and decreased secondary flow. For clockwise incoming vortex near pressure surface, the vortex would be divided into two parts at the leading edge of rear blade, one would go through the blade gap and deteriorate flow fluid near rear blade suction surface, the other flowed downstream along pressure surface. The rotation direction of different incoming vortexes became the same as the passage vortex at rear blade passage of tandem cascade, which was mainly due to the effect of secondary flow.Keywords
Funding Information
- National Natural Science Foundation of China (51806174)
- the Fundamental Research Funds for the Central Universities of China (G2018KY0303)
- Natural Science Foundation of Shaanxi Province (2019JQ-137)
This publication has 33 references indexed in Scilit:
- Numerical Study of the Effect of Secondary Vortex on Three-Dimensional Corner Separation in a Compressor CascadeInternational Journal of Turbo & Jet-Engines, 2016
- Numerical Analysis on Axial Compressor Stage Performance With Vortex Generators2015
- Numerical and Experimental Investigations of the Three-Dimensional-Flow Structure of Tandem Cascades in the Sidewall RegionJournal of Fluids Engineering, 2014
- Control of separations in a highly loaded diffusion cascade by tailored boundary layer suctionProceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, 2013
- Numerical and experimental investigation of an axial compressor flow with tandem cascadeJournal of Thermal Science, 2012
- Effects of Vortex Generator Application on the Performance of a Compressor CascadeJournal of Turbomachinery, 2012
- A Criterion for Axial Compressor Hub-Corner StallJournal of Turbomachinery, 2008
- Compressor Stability Enhancement Using Discrete Tip InjectionJournal of Turbomachinery, 2000
- Aerodynamic characteristics of strake vortex flaps on a strake-wing configurationJournal of Aircraft, 1994
- The 1993 IGTI Scholar Lecture: Loss Mechanisms in TurbomachinesJournal of Turbomachinery, 1993