Instability of Pressure Relief Valves in Water Pipes
- 1 August 2010
- journal article
- Published by ASME International in Journal of Pressure Vessel Technology
- Vol. 132 (4) , 041308
Abstract
Pressure relief valves in water pipes are known to sometimes chatter when the inlet pressure slightly exceeds the set pressure. While these devices are responsible for numerous fatigue issues in process industries, there is a relatively low number of technical publications covering their performance, especially in heavy fluid applications. The present study is intended as a contribution to the understanding of pressure relief valve dynamics, taking into account fluid-structure interactions. A series of tests were performed with a water relief valve in a test rig. Adjusting the set pressure of the valve to about 30 bars, an upstream pressure varying from 20 bars to 35 bars was imposed, so that the valve opened and the water flow varied from a few to about . During the tests, the pipe was equipped upstream and downstream of the valve with static pressure sensors and a flowmeter, the disk lift was measured with a laser displacement sensor, and the spring force was recorded simultaneously. Several fluctuating pressure sensors were also installed in the inlet pipe. Static instability is investigated by comparing the spring force to the hydraulic force. Dynamic instability is observed and it is shown that the resonant behavior of the disk generates an apparent negative pressure drop coefficient at some frequencies. This negative pressure drop coefficient can trigger a dynamic instability in a manner similar to the negative damping effect in leakage-flow vibrations.
Keywords
This publication has 10 references indexed in Scilit:
- An experimental method for validating compressor valve vibration theoryJournal of Fluids and Structures, 2006
- Experimental Examination of Unsteady Friction Models for Transient Pipe Flow SimulationJournal of Fluids Engineering, 2006
- Impedance and stability characteristics of a relief valveProceedings of the Institution of Mechanical Engineers, Part I: Journal of Systems and Control Engineering, 2002
- Validated sizing rule against chatter of relief valves during gas serviceJournal of Loss Prevention in the Process Industries, 2001
- Flow Induced Vibration of Power and Process Plant Components2001
- Analysis of safety relief valve chatter induced by pressure waves in gas flowJournal of Loss Prevention in the Process Industries, 1998
- Liquid flow through safety valves: Diameter ratio effects on discharge coefficients, sizing and stabilityJournal of Loss Prevention in the Process Industries, 1996
- Practical flow duct acousticsJournal of Sound and Vibration, 1988
- Flow-Induced Vibration in Safety Relief ValvesJournal of Pressure Vessel Technology, 1986
- A Theoretical Model for Self-Excited Vibrations in Hydraulic Gates, Valves and SealsJournal of Pressure Vessel Technology, 1980