Determination of Calibration Factors of the Hole Drilling Method for Orthotropic Composites using an Exact Solution
- 1 October 2007
- journal article
- research article
- Published by SAGE Publications in Journal of Composite Materials
- Vol. 41 (19) , 2293-2311
Abstract
The hole drilling method has been used for measurement of the residual stresses in various materials. The released strains measured by the hole drilling method are converted to residual stresses using calibration factors. There is a standard for the hole drilling method for isotropic materials. Also for orthotropic materials, there are various methods for converting the released strains to residual stresses. In these methods the numbers of calibration factors vary from two to nine (a three by three matrix). In this article, calibration factors of the orthotropic plates are determined based on an exact solution method. For this purpose, assuming a plane stress condition, stresses and strains around the area under a rosette strain gage mounted to an orthotropic plate are calculated. A hole in the center of the rosette strain gage changes the distribution of the stresses and strains. Using the closed form solution proposed in this research the released strains and the calibration factors are calculated, and the residual stresses are found. Also, calibration factors for any orthotropic material with any level of orthotropy are calculated. These factors are independent of the loading and depend on the material properties of orthotropic materials and the ratio of the rosette diameter to the hole diameter. The material properties and the ratio of the rosette diameter to the hole diameter are considered in the equations, therefore there is no need for presenting the results in tabular form or any interpolations. The results for an orthotropic unidirectional ply made of carbon/epoxy are presented. Also, the calibration factors for three different unidirectional composites are calculated. The results obtained from the proposed closed form solution are compared with the simulated hole drilling method. A good agreement between the results shows the reliability of the closed form solution presented in this study.Keywords
This publication has 10 references indexed in Scilit:
- Simulation of Central Hole Drilling Process for Measurement of Residual Stresses in Isotropic, Orthotropic, and Laminated Composite PlatesJournal of Composite Materials, 2007
- Theoretical and Experimental Studies on Residual Stresses in Laminated Polymer CompositesJournal of Composite Materials, 2005
- Measurement of residual stress in thick section composite laminates using the deep-hole methodInternational Journal of Mechanical Sciences, 2005
- Influence of experimental parameters on determination of residual stress using the incremental hole-drilling methodComposites Science and Technology, 2004
- Determination of Residual Stress in Composite Laminates Using the Incremental Hole-drilling MethodJournal of Composite Materials, 2003
- Finite element analysis of calibration factors for the modified incremental strain methodThe Journal of Strain Analysis for Engineering Design, 2003
- A new calculation procedure for non-uniform residual stress analysis by the hole-drilling methodThe Journal of Strain Analysis for Engineering Design, 1998
- Residual-stress measurement in orthotropic materials using the hole-drilling methodExperimental Mechanics, 1994
- Use of displacement data to calculate strain gauge response in non‐uniform strain fieldsStrain, 1993
- Determination of calibration constants for the hole-drilling residual stress measurement technique applied to orthotropic composites—Part I: Theoretical considerationsComposite Structures, 1987