The critical width-height ratio of finite soil behind retaining wall considering the compaction degree of fill under RB mode
Open Access
- 8 January 2025
- journal article
- Published by JVE International Ltd. in Journal of Measurements in Engineering
- Vol. 13 (2) , 344-361
Abstract
The compaction degree of fill is an important index for quality control of slope support engineering. Aiming at the influence factor of the compaction degree of fill, the effect of the compaction degree of fill on the characteristics of active fracture surface and the critical width-height ratio of finite soil under the RB model was investigated through laboratory model test and numerical simulation. The primary research findings are as follows: (1) Under RB mode, the active fracture surface of fill is an inclined plane that does not pass through the heel of the wall, and there are often multiple nearly parallel fracture planes in the fractured body. The active fracture surface of semi-infinite soil is between the movable retaining wall and the fill surface, and the finite soil is between the movable retaining wall and the fixed retaining wall. (2) For the loose finite soil ( λ = 81 %), the upper point of the active fracture surface gradually moves upward from the fixed retaining wall to the fill surface with the increase of the compaction degree of the fill, the active fracture surface gradually becomes steeper, and the finite soil gradually changes into semi-infinite soil. (3) For loose semi-infinite soil ( λ = 81 %), with the increase of compaction degree, the active fracture surface gradually becomes steeper, but the soil between the two walls is still semi-infinite. (4) Under the RB model, the critical width-height ratio of actively destroyed finite soil decreases linearly with the increase of compaction degree. After fitting, the empirical equations of the experimental and simulated values of the critical width-height ratio considering the compaction degree of the fill are given respectively. (5) Under the RB model, the active failure mechanism of fill is similar to the push slide of slope, and the development process of active failure surface is top-down sliding layer by layer. The research in this paper shows that the compaction degree of fill is an important factor affecting the characteristics of the fracture surface and the critical width to height ratio of the finite soil, and it is an important index to define the finite or semi-infinite state of the soil behind the wall.Keywords
This publication has 18 references indexed in Scilit:
- Spatial earth pressure analysis of clayey fill behind retaining wall in V-shaped gully terrainSoils and Foundations, 2024
- DEM simulations of particle dissolution effects on the passive earth pressure of retaining wallsEngineering Geology, 2024
- Calculation method for static and seismic active earth pressure on counterweight retaining walls under translation based on two critical slip surfacesTransportation Geotechnics, 2024
- Active earth pressure of narrow cohesionless backfill on balance weight retaining walls rotating about the bottomStructures, 2024
- Seismic active earth pressure in nonhomogeneous and anisotropic soilsComputers and Geotechnics, 2024
- Study on active earth pressure of narrow backfill of balance weight retaining wall under translational displacement modeDevelopments in the Built Environment, 2024
- Analytical solution for displacement-dependent active earth pressure considering the stiffness of cantilever retaining structure in cohesionless soilComputers and Geotechnics, 2024
- LEAP centrifuge tests on retaining walls at Cambridge UniversitySoil Dynamics and Earthquake Engineering, 2024
- An experimental study of the active failure mechanism of narrow backfills installed behind rigid retaining walls conducted using Geo-PIVActa Geotechnica, 2022
- A Numerical Study of the Active Earth Pressure on a Rigid Retaining Wall for Various Modes of MovementsSoil Mechanics and Foundation Engineering, 2016