YWYuxing Wang

Yuxing Wang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Yuxing Wang has a total of 5 co-authors. Here are the top co-authors by number of shared publications:

  • Haixing Cai

    3 Yueyang Baili Survey Technology Co., Ltd., Hunan Province, Yueyang, China

    1 shared publication
  • Xiaohong Liu

    1 College of Civil Engineering and Architecture, Hunan Institute of Science and Technology, Yueyang, China

    1 shared publication
  • Yasi Ye

    2 Hunan Provincial Communications Planning, Survey and Design Institute Co., LTD, Changsha, China

    1 shared publication
  • Yongqing Zeng

    2 College of Civil Engineering and Architecture, Hunan Institute of Science and Technology, Yueyang, China

    1 shared publication
  • Yuchen Liu

    1 College of Civil Engineering and Architecture, Hunan Institute of Science and Technology, Yueyang, China

    1 shared publication

Latest Publications

  • Open Access

    The critical width-height ratio of finite soil behind retaining wall considering the compaction degree of fill under RB mode

    by Xiaohong Liu, Yuxing Wang, Yongqing Zeng, Yasi Ye, Yuchen Liu, Haixing Cai

    The compaction degree of fill is an important index for quality control of slope support engineering. Aiming at the influence factor of the compaction degree of fill, the effect of the compaction degree of fill on the characteristics of active fracture surface and the critical width-height ratio of finite soil under the RB model was investigated through laboratory model test and numerical simulation. The primary research findings are as follows: (1) Under RB mode, the active fracture surface of fill is an inclined plane that does not pass through the heel of the wall, and there are often multiple nearly parallel fracture planes in the fractured body. The active fracture surface of semi-infinite soil is between the movable retaining wall and the fill surface, and the finite soil is between the movable retaining wall and the fixed retaining wall. (2) For the loose finite soil ( λ =   81 %), the upper point of the active fracture surface gradually moves upward from the fixed retaining wall to the fill surface with the increase of the compaction degree of the fill, the active fracture surface gradually becomes steeper, and the finite soil gradually changes into semi-infinite soil. (3) For loose semi-infinite soil ( λ =   81 %), with the increase of compaction degree, the active fracture surface gradually becomes steeper, but the soil between the two walls is still semi-infinite. (4) Under the RB model, the critical width-height ratio of actively destroyed finite soil decreases linearly with the increase of compaction degree. After fitting, the empirical equations of the experimental and simulated values of the critical width-height ratio considering the compaction degree of the fill are given respectively. (5) Under the RB model, the active failure mechanism of fill is similar to the push slide of slope, and the development process of active failure surface is top-down sliding layer by layer. The research in this paper shows that the compaction degree of fill is an important factor affecting the characteristics of the fracture surface and the critical width to height ratio of the finite soil, and it is an important index to define the finite or semi-infinite state of the soil behind the wall.