Compatibility Studies on Elastomers and Polymers with Ethanol Blended Gasoline
Authors:
Open Access
- 29 January 2014
- journal article
- research article
- Published by Hindawi Limited in Journal of Fuels
- Vol. 2014, 1-8
Abstract
This paper reports the compatibility studies of 10% ethanol blended gasoline (E10) with four types of elastomer materials, namely, Neoprene rubber, Nitrile rubber, hydrogenated Nitrile butadiene rubber (HNBR), and Polyvinyl chloride/Nitrile butadiene rubber blend (PVC/NBR), and two types of plastic materials, namely, Nylon-66 and Polyoxymethylene (Delrin). These materials have applications in automotives as engine seals, gaskets, fuel system seals and hoses, and so forth. Two types of the ethanol blended gasoline mixtures were used: (a) gasoline containing 5% ethanol (E5), which is commercial form of gasoline available in India, and (b) gasoline containing 10% ethanol (E10). The above materials were immersed in E5 and E10 for 500 hrs at 55°C. A set of eight different properties in E5 and E10 (visual inspection, weight change, volume change, tensile strength, percent elongation, flexural strength, impact strength, and hardness) were measured after completion of 500 hrs and compared with reference specimens (specimens at 55°C without fuel and specimens at ambient conditions). Variation observed in different materials with respect to the above eight properties has been used to draw inference about the compatibility of these elastomeric/polymer materials with E10 fuel vis-à-vis E5 fuels. The data presented in this study is comparative in nature between the results of E10 and E5.Keywords
Funding Information
- Tata Motors
This publication has 10 references indexed in Scilit:
- COMPATIBILITY STUDY OF NBR/PVC BLEND WITH GASOLINES AND ETHANOL FUELRubber Chemistry and Technology, 2012
- Aggressiveness of a 20% bioethanol 80% gasoline mixture on autoparts: II Behavior of polymeric materialsFuel, 2012
- Intermediate Blends Infrastructure Materials Compatibility Study2011
- Compatibility study of high density polyethylene with bioethanol–gasoline blendsMaterials & Design (1980-2015), 2011
- Fluoroelastomer Compatibility with Bioalcohol FuelsSAE International Journal of Fuels and Lubricants, 2009
- An Experimental Investigation on 1.4L MPFI Gasoline Engine to Study its Performance, Emission and Compatibility with E10 FuelSAE International Journal of Advances and Current Practices in Mobility, 2009
- Elastomer selection for bio-fuel requires a systems approachSealing Technology, 2009
- Effect of additives on the antiknock properties and Reid vapor pressure of gasolineFuel, 2005
- Compatibility of Elastomeric Materials with GasoholSAE International Journal of Advances and Current Practices in Mobility, 2004
- Vapour pressure measurements and predictions for alcohol–gasoline blendsFuel, 2000