The article considers the possibility of using cutting time to determine cutting conditions through the calculation of the determining ratio. One of the five speed zones of oscillation is determined by its value. Among them, the third speed oscillation zone is the most unfavorable for obtaining the quality of the machined surface. To exit this zone without reducing the cutting speed, it is proposed to use technological techniques that increase the cutting time. In particular, by increasing the angle of inclination of the helical cutting edge of the end mill. This allows you to assign such a value of the angle of inclination at which, due to the cutting time, the value of the determining ratio approaches the second speed oscillation zone, in which the damping properties of the cutting process significantly reduce the intensity of oscillations and ensure stable milling.