Particular pollutants, physical properties, and environmental performance of porous ceramsite materials containing oil-based drilling cuttings residues
- 1 September 2021
- journal article
- research article
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 29 (5) , 7202-7213
Abstract
The mineral compositions of oil-based drilling cutting residues (ODCRs) were similar to that of clay, which could be used as raw materials for ceramsite. In this study, the maximum addition of ODCRs and the optimum calcination conditions were studied by single factor experiment. The microstructure, phase composition, and element distribution of ceramsite were studied by means of SEM, XRD and EDS. The ceramsite, with a 40% ODCRs content, was calcined at 1000 °C for 2 h. After cooling down, the ceramsite had good physical properties, including low density, low water absorption, and high compressive strength. The bulk density was 850–970 kg/m3, the water absorption was 2.1–10%, and the cylinder compressive strength was 6–11.8 MPa. And most of the heavy metals in ODCRs were effectively solidified. The organic toxic substances were completely burned. The leaching amount of harmful elements met the requirements of Chinese standards. The ceramsite would avoid secondary pollution to the environment. So the ceramsite made from ODCRs can not only improve the processing speed of ODCRs, but also be used as building materials, greening materials, industrial filter materials, etc., and increase its environmental and social benefits.Keywords
Funding Information
- Natural Science Foundation of Chongqing Municipality (cstc2019jcyj-msxmX0651)
This publication has 32 references indexed in Scilit:
- Analysis of lead toxicity in human cellsBMC Genomics, 2012
- A review of the current options for the treatment and safe disposal of drill cuttingsWaste Management & Research: The Journal for a Sustainable Circular Economy, 2011
- Organ Specific Distribution of PAHs in a Carnivorous Fish Species Following Chronic Exposure to Used Synthetic-Based Drilling MudPolycyclic Aromatic Compounds, 2011
- Cleaned oil-drill cuttings for use as filler in bituminous mixturesConstruction and Building Materials, 2009
- The use of oil well-derived drilling waste and electric arc furnace slag as alternative raw materials in clinker productionResources, Conservation and Recycling, 2007
- Cardiovascular Effects of Nickel in Ambient AirEnvironmental Health Perspectives, 2006
- Microwave treatment of oil-contaminated North Sea drill cuttings in a high power multimode cavitySeparation and Purification Technology, 2006
- Surfactant-Enhanced Treatment of Oil-Based Drill CuttingsJournal of Energy Resources Technology, 2004
- Phytodegradation of extra heavy oil-based drill cuttings using mature reed wetland: an in situ pilot studyEnvironment International, 2004
- Use of petroleum-contaminated drilling wastes as sub-base material for road constructionWaste Management & Research: The Journal for a Sustainable Circular Economy, 2000