Low Loss Acoustic Delay Lines Based on Solidly Mounted Lithium Niobate Thin Film
Authors:
- 8 May 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 29 (4) , 449-451
Abstract
In this work, acoustic delay lines (ADLs) based on solidly mounted structures were studied to achieve low insertion loss (IL) and wide fractional bandwidth (FBW). By adopting the guided shear-horizontal wave (SH-wave) in thin-film lithium niobate on insulator (LNOI) configuration, the acoustic energy is constrained near the surface to attain high piezoelectric coupling (K²) to yield low IL and wide FBW. Proposed ADLs were designed with Au electrodes in X-cut LNOI to obtain sufficient K² > 27% up to 1-GHz, thus allowing a better IL-FBW tradeoff. Fabricated prototype ADLs with wavelength (λ ) of 4 μm (940 MHz) and 6 μm (640 MHz) achieve IL around 10 dB and FBW around 9% simultaneously using conventional bidirectional transducers. Such a performance is comparable to suspended plate wave ADL counterparts while retains enhanced mechanical robustness for batch-manufacturing and packaging. [2020-0057]Keywords
Funding Information
- Ministry of Science and Technology (MOST) of Taiwan (MOST 108-2636-E-007-014)
This publication has 17 references indexed in Scilit:
- Solidly Mounted Anti-Symmetric Lamb-Wave Delay Lines as an Alternate to SAW DevicesIEEE Electron Device Letters, 2018
- Delay lines based on a suspended thin film of X-cut lithium niobate2017
- Solidly mounted resonator using shear horizontal mode plate wave in LiNbO3 plate2016
- Surface acoustic wave devices on AlN/3C–SiC/Si multilayer structuresJournal of Micromechanics and Microengineering, 2013
- Two-port filters and resonators on AlN/3C-SiC plates utilizing high-order Lamb wave modes2013
- Development of SAW-based multi-gas sensor for simultaneous detection of CO2 and NO2Sensors and Actuators B: Chemical, 2011
- Overview of design challenges for single phase unidirectional SAW filters2003
- Low loss SAW filters utilizing the natural single phase unidirectional transducer (NSPUDT)2002
- Accurate design of low-noise microwave SAW oscillators2002
- Investigation of acoustic waves in thin plates of lithium niobate and lithium tantalateIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 2001