Modelling study of divertor W leakage for different divertor conditions with Ne seeding in EAST tokamak
Open Access
- 15 October 2024
- journal article
- research article
- Published by IOP Publishing in Nuclear Fusion
- Vol. 64 (12) , 126048
Abstract
Sequential SOLPS-ITER and DIVIMP simulations are carried out for tungsten (W) edge transport during neon (Ne) injection in EAST, elucidating the pathway of W impurity leakage from the divertor to the core plasma under different dissipative divertor conditions. Divertor conditions from low-recycling to detachment are generated by modulating the Ne injection rate in the SOLPS simulation. With the drift velocities incorporated in DIVIMP, W transport under the drift effect is investigated. For low-density L-mode plasma conditions with favorable B t direction, the majority of W source originates from the outer divertor target and leaks upstream through the near-SOL E× B drift reversed region at both inner and outer divertors. The E× B drift is demonstrated to have a significant effect on W leakage and the effect diminishes with the increase of Ne injection rate. Compared to the D2 injection cases, Ne injection helps to achieve a strong dissipative divertor condition at a much lower plasma density, resulting in a higher W leakage ability due to the smaller friction with the background plasma. For Ne injection cases under high-density H-mode conditions, W leaks mostly through the outer divertor region while the inner divertor is fully detached. Compared to the L-mode cases, the shorter power decay lengths in the scrap-off layer (SOL) of the H-mode cases result in smaller parallel E× B drift velocities especially in the middle and far SOL region. With the increase of the Ne injection rate, the decrease of the E× B drift in the middle SOL leads to a wider near-separatrix W leakage path. Therefore, a worse divertor W screening is expected, which is consistent with the previous published experimental observations (Ding et al 2022 Nucl. Mater. Energy 33 101250).Keywords
Funding Information
- National MCF Energy R&D Program of China (2019YFE03080100)
- National Natural Science Foundation of China (12022511)
- Key Research Program of Frontier Sciences of CAS (ZDBS-LY-SLH010)
This publication has 43 references indexed in Scilit:
- Experimentally-based ExB drifts in the DIII-D divertor and SOL calculated from integration of Ohm's law using Thomson scattering measurements of Te and neNuclear Materials and Energy, 2017
- Effect of heating scheme on SOL width in DIII-D and EASTNuclear Materials and Energy, 2017
- Comparison of 2D simulations of detached divertor plasmas with divertor Thomson measurements in the DIII-D tokamakNuclear Materials and Energy, 2017
- Overview of the design approach and prioritization of R&D activities towards an EU DEMOFusion Engineering and Design, 2016
- Effects of background plasma characteristics on tungsten impurity transport in the SOL/divertor region using IMPGYRO codeJournal of Nuclear Materials, 2015
- The new SOLPS-ITER code packageJournal of Nuclear Materials, 2015
- Research status and issues of tungsten plasma facing materials for ITER and beyondFusion Engineering and Design, 2014
- Tungsten divertor erosion in all metal devices: Lessons from the ITER like wall of JETJournal of Nuclear Materials, 2013
- Outer target heat fluxes and power decay length scaling in L-mode plasmas at JET and AUGJournal of Nuclear Materials, 2013
- Plasma operation with an all metal first-wall: Comparison of an ITER-like wall with a carbon wall in JETJournal of Nuclear Materials, 2013