Defining the optimal systolic phase targets using absolute delay time for reconstructions in dual-source coronary CT angiography
- 3 September 2015
- journal article
- research article
- Published by Springer Nature in The International Journal of Cardiovascular Imaging
- Vol. 32 (1) , 91-100
Abstract
To define the optimal systolic phase for dual-source computed tomography angiography using an absolute reconstruction delay time after the R–R interval based on the coronary artery motion, we analyzed images reconstructed between 200 and 420 miliseconds (ms) after the R wave at 20 ms increments in 21 patients. Based on the American Heart Association coronary segmentation guidelines, the origin of six coronary artery landmarks (RCA, AM1, PDA, LM, OM1, and D2) were selected to calculate the coronary artery motion velocity. The velocity of the given landmark was defined as the quotient of the route and the length of the time interval. The x, y and z-coordinates of the selected landmark were recorded, and were used for the calculation of the 3D route of coronary artery motion by using a specific equation. Differences in velocities were assessed by analysis of variance for repeated measures; Bonferroni post hoc tests were used for multiple pair wise comparisons. 1488 landmarks were measured (6 locations at 12 systolic time points) in 21 patients and were analyzed. The mean values of the minimum velocities were calculated separately for each heart rate group (i.e. 80 bpm). The mean lowest coronary artery velocities in each segment occurred in the middle period of each time interval of the acquired systolic phase i.e. 280–340 ms. No differences were found in the minimal coronary artery velocities between the three HR groups, with the exception of the AM1 branch (p = 0.00495) between 80 bpm (p = 0.03), and at HRs of 65–80 versus >80 bpm (p = 0.006). During an absolute delay of 200–420 ms after the R-wave, the ideal reconstruction interval varies significantly among coronary artery segments. Decreased velocities occur between 280 to 340 ms. Therefore a narrow range of systolic intervals, rather than a single phase, should be acquired.Keywords
This publication has 34 references indexed in Scilit:
- Assessment of image quality and radiation dose of prospectively ECG-triggered adaptive dual-source coronary computed tomography angiography (cCTA) with arrhythmia rejection algorithm in systole versus diastole: a retrospective cohort studyThe International Journal of Cardiovascular Imaging, 2013
- Cardiac Computed Tomography Angiography With Automatic Tube Potential SelectionJournal of Thoracic Imaging, 2013
- Low-dose coronary-CT angiography using step and shoot at any heart rate: comparison of image quality at systole for high heart rate and diastole for low heart rate with a 128-slice dual-source machineThe International Journal of Cardiovascular Imaging, 2012
- Coronary computed tomography angiography during arrhythmia: Radiation dose reduction with prospectively ECG-triggered axial and retrospectively ECG-gated helical 128-slice dual-source CTJournal of Cardiovascular Computed Tomography, 2012
- Robustness of end-systolic reconstructions in coronary dual-source CT angiography for high heart rate patientsEuropean Radiology, 2009
- Coronary MR angiography at 3T during diastole and systoleJournal of Magnetic Resonance Imaging, 2007
- Dual-source CT cardiac imaging: initial experienceEuropean Radiology, 2006
- Cardiac Motion of Coronary Arteries: Variability in the Rest Period and Implications for Coronary MR AngiographyRadiology, 1999
- A reporting system on patients evaluated for coronary artery disease. Report of the Ad Hoc Committee for Grading of Coronary Artery Disease, Council on Cardiovascular Surgery, American Heart AssociationCirculation, 1975
- The phases of the cardiac cycleAmerican Heart Journal, 1972