Analysis and Control of Abnormal Wear of Reciprocating Compressors in Natural Gas Underground Storage Caverns
Open Access
Abstract
Throughout China’s 14th five-year plan, the national natural gas pipeline network has been interconnected, and the gas quality became increasingly complex. A certain amount of dust particles widely spread in the natural gas pipeline and lead to abnormal wear of the reciprocating compressor’s compression cylinder within the underground storage cavern. The wear characteristics of the compression cylinder are effectively demonstrated based on the tangential impact energy model, and combined with field measurement and the moving-grid method of computational fluid dynamics. The results reveal that the lubricating oil forms “grinding paste” when mixed with dust particles. With an increase in the dust mass concentration from 0.01% to 3.00%, the viscosity of the “grinding paste” increases from 450,800 mPa·s to 1,274,000 mPa·s, and the density increases from 890 kg/m3 to 980 kg/m3. The abnormal wear frequently occurs at the 12 o’clock and 6 o’clock directions of the compression cylinder. When the piston is in the midpoint of the stroke, the wall shear rate and the wear rate are the highest. When the piston is at both endpoints of the stroke, the wall shear rate and the wear rate are the lowest. For every 1000 h of operation without repairing the cylinder, the dust concentration should be controlled below 0.60%. For every 5000 h and 10,000 h of operation without replacing the cylinder, the dust concentration should be controlled below 1.3% and 0.4%. When the dust mass concentration is 0.01%, the wear rate decreases with decreasing lubricating oil viscosity. When the dust mass concentration is 0.51% and 1.0%, and the lubricating oil viscosities are 259,700 mPa·s, 220,500 mPa·s, and 196,980 mPa·s, the wear rate increases dramatically with decreasing lubricating oil viscosity.Keywords
Funding Information
- National Natural Science Foundation of China (51775463, 2019-GH02-00055-HZ)
- International Cooperation Project of Chengdu Science and Technology Bureau (51775463, 2019-GH02-00055-HZ)
This publication has 20 references indexed in Scilit:
- Fretting wear behavior of silicone rubber under quartz sand abrasivesWear, 2024
- Development of a DEM method for predicting wear distribution on particle scalePowder Technology, 2023
- Approximation of the compression process to isothermal in a reciprocating compressor with a liquid pistonApplied Thermal Engineering, 2022
- Piston trajectory optimization of a reciprocating compressorInternational Journal of Refrigeration, 2021
- Further study on the geometric conservation law for finite volume method on dynamic unstructured meshComputers & Fluids, 2015
- Analysis and modelling of bead contacts in wet-operating stirred media and planetary ball mills with CFD–DEM simulationsChemical Engineering Science, 2015
- Tribological characteristics of one-process and two-process cylinder liner honed surfaces under reciprocating sliding conditionsTribology International, 2010
- Friction and wear bench tests of different engine liner surface finishesTribology International, 2008
- Numerical simulation and experimental study of a two-stage reciprocating compressor for condition monitoringMechanical Systems and Signal Processing, 2008
- Comparison of computed and measured particle velocities and erosion in water and air flowsWear, 2007