FWFei Wang

Fei Wang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Fei Wang has a total of 13 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Analysis and Control of Abnormal Wear of Reciprocating Compressors in Natural Gas Underground Storage Caverns

    by Sijia Zheng, Zhixiang Dai, Fei Wang, Feng Wang, Yongbo Wang, Qin Bie, Wei Jiang, Jingdong Chen, Zicheng Peng, Jie Sun

    Throughout China’s 14th five-year plan, the national natural gas pipeline network has been interconnected, and the gas quality became increasingly complex. A certain amount of dust particles widely spread in the natural gas pipeline and lead to abnormal wear of the reciprocating compressor’s compression cylinder within the underground storage cavern. The wear characteristics of the compression cylinder are effectively demonstrated based on the tangential impact energy model, and combined with field measurement and the moving-grid method of computational fluid dynamics. The results reveal that the lubricating oil forms “grinding paste” when mixed with dust particles. With an increase in the dust mass concentration from 0.01% to 3.00%, the viscosity of the “grinding paste” increases from 450,800 mPa·s to 1,274,000 mPa·s, and the density increases from 890 kg/m3 to 980 kg/m3. The abnormal wear frequently occurs at the 12 o’clock and 6 o’clock directions of the compression cylinder. When the piston is in the midpoint of the stroke, the wall shear rate and the wear rate are the highest. When the piston is at both endpoints of the stroke, the wall shear rate and the wear rate are the lowest. For every 1000 h of operation without repairing the cylinder, the dust concentration should be controlled below 0.60%. For every 5000 h and 10,000 h of operation without replacing the cylinder, the dust concentration should be controlled below 1.3% and 0.4%. When the dust mass concentration is 0.01%, the wear rate decreases with decreasing lubricating oil viscosity. When the dust mass concentration is 0.51% and 1.0%, and the lubricating oil viscosities are 259,700 mPa·s, 220,500 mPa·s, and 196,980 mPa·s, the wear rate increases dramatically with decreasing lubricating oil viscosity.


  • Corrected the Internal Corrosion Data Obtained through MFL by Considering CO 2 Corrosion

    by Jian Gao, Lin Qin, Yihui Wang, Fei Wang, Yang Wang

    A gas pipeline of Southwest Oil & Gas Field Company was put into operation in 2007. During the MFL in 2010, it was found that there were 408 metal losses, among which 332 internal corrosions were found and imperfects needed to be repaired. There should not have 332 internal corrosions in this pipeline according to the analysis of the internal corroion rate, the clock distribution and one similar pipeline. By considering CO2 corrosion, 66 manufacturing defects deeper than 28% were screened out and 28 imperfects needed to be repaired based on the correction of corrosion rate calculated by de Waard's CO2 corrosion rate empirical formula. The numbers were greatly reduced compared with those before correction. All the internal corrosions were confirmed to be manufacturing defects after excavating and data confirmation. There were 27 defects needed to repaired which was almost the same as the correction by CO2 corrosion rate, thus this method was proved to be valid in correcting the numbers of internal corrosion.