Mechanical and tribological properties of PEEK particle-filled UHMWPE composites: The role of counterface morphology change in dry sliding wear
Authors:
- 16 July 2013
- journal article
- research article
- Published by SAGE Publications in Journal of Reinforced Plastics and Composites
- Vol. 32 (21) , 1614-1623
Abstract
Polyether ether ketone (PEEK) is a commonly used engineering plastic but has poor friction and wear properties when compared to those of ultra-high-molecular-weight polyethylene (UHMWPE), whereas UHMWPE has good tribological properties but relatively weaker mechanical strengths. An optimum combination of these two materials is expected to have both sides’ goodness without adverse effects to a certain extent. Adding an optimum amount of PEEK powder filler into UHMWPE to form composite has shown better friction, wear and compressive strength properties. The mechanism of wear resistance improvement is found largely due to counterface transfer film but less because of the filler strengthening effect. Adding PEEK could improve the compressive strength of the composite due to high hardness of PEEK particles.Keywords
This publication has 27 references indexed in Scilit:
- Friction and wear of PEEK composites in vacuum environmentWear, 2010
- Preparation and tribological properties of polyetheretherketone compositesJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2010
- Friction and wear variations of short carbon fiber (SCF)/PTFE/graphite (10vol.%) filled PEEK: Effects of fiber orientation and nominal contact pressureWear, 2010
- Molecular Deformation Mechanisms in UHMWPE During Tribological Loading in Artificial JointsTribology Letters, 2010
- Characterization of grooves in scratch resistance testingPolymer Engineering & Science, 2008
- A low friction and ultra low wear rate PEEK/PTFE compositeWear, 2006
- Large deformation compression induced crystallinity degradation of conventional and highly crosslinked UHMWPEsBiomaterials, 2005
- Wear and mechanical properties of Ekonol/G/MoS2/PEEK compositesJournal of Materials Science, 2004
- Plasticity-induced damage layer is a precursor to wear in radiation-cross-linked UHMWPE acetabular components for total hip replacementThe Journal of Arthroplasty, 1999
- On the friction and wear behaviour of PAN- and pitch-carbon fiber reinforced PEEK compositesWear, 1999