Flame and Induction Hardening – An Advantageous Alternative to Case Hardening for Large Size Gears?
Authors:
- 29 March 2022
- journal article
- research article
- Published by Walter de Gruyter GmbH in HTM Journal of Heat Treatment and Materials
- Vol. 77 (2) , 112-126
Abstract
Surface hardening is an economical and technological alternative to case hardening, especially for larger gear sizes. Due to the high carburization depths required for case hardening with large component dimensions and technological limitations (e. g. furnace size), typical surface hardening processes such as flame or induction hardening show advantages here. In this publication, a flame-spin-hardened variant is compared with an induction-hardened variant using the gap-by-gap method. Both variants have a gear size of m n = 14 mm. A comparison is also made with a case-hardened, shot-peened reference variant of comparable size. In the comparison, the chemical composition, microstructural properties, hardness-depth characteristics and experimental results of the tooth root bending strength tests on the pulsator test rig are presented, comparatively evaluated and discussed. The experimentally determined tooth root load carrying capacities of the two surface-hardened variants are then classified with the reference variant in the state of the art.Keywords
This publication has 10 references indexed in Scilit:
- On the determination of the bending fatigue strength in and above the very high cycle fatigue regime of shot-peened gearsForschung im Ingenieurwesen, 2021
- Suitable Material Selection for Large Size Cylindrical Gears*HTM Journal of Heat Treatment and Materials, 2021
- Investigations on the tooth root bending strength and the fatigue fracture characteristics of case-carburized and shot-peened gears of different sizesProceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, 2019
- INFLUENCE OF ADDITIONAL SURFACE FINISHING TO THE MATERIAL PROPERTIES AND THE FLANK LOAD CARRYING CAPACITY OF CASE-HARDENED GEARS WITH GRINDING BURNThe Proceedings of the JSME international conference on motion and power transmissions, 2017
- Wärmebehandlung von Verzahnungsteilen2016
- Influence of hardening pattern, base material and residual stress condition on the tooth root bending strength of induction hardened gears2016
- Predicting the effects of material properties gradient and residual stresses on the bending fatigue strength of induction hardened aeronautical gearsInternational Journal of Fatigue, 2016
- Induction Hardening of Spur Gearwheels Made from 42CrMo4 Hardening and Tempering Steel by Employing Spray CoolingSteel Research International, 2010
- GSD-06 INFLUENCE OF RESIDUAL STRESSES ON TOOTH ROOT BENDING STRENGTH OF CASE HARDENED GEARS(GEAR STRENGTH AND DURABILITY, INCLUDING GEAR MATERIALS AND HEAT TREATMENT TECHNIQUES)The Proceedings of the JSME international conference on motion and power transmissions, 2009
- Zahnradgetriebe — Grundlagen (Stirnräder)2003