Effect of Scanning Speed on Properties of Laser Surface Remelted 304 Stainless Steel
Open Access
- 29 August 2022
- journal article
- research article
- Published by MDPI AG in Micromachines
- Vol. 13 (9) , 1426
Abstract
In order to study the microstructure and properties of stainless steel after laser surface remelting, based on the theory of laser surface remelting, a simulation model of nanosecond-pulsed laser surface remelted stainless steel was established to study the evolution law of the Marangoni force of the molten pool during laser surface remelting. A single-lane laser remelting experiment was performed to study the variation of the scanning speed on the remelting width, roughness, and layer microtopography. The “S” scanning path was used to remelt the stainless steel surface to investigate the bonding force between the remelted layer and the substrate, the hardness, microscopic morphology, and corrosion resistance. The results show that the viscosity of the liquid metal in the molten pool increases with the increase of the scanning speed. Larger liquid viscosity and smaller surface tension temperature gradients promote a weaker flow of liquid metal, which reduces the velocity of the liquid metal flow in the molten pool. With the increase of scanning speed, the remelting width gradually decreases, but the roughness gradually increases. When the element content of Cr increases, the element content of Fe and O decreases. The surface is covered with an oxide film, the main components of which are oxides of Cr and Fe, the remelted layer is greater than that of the substrate, and the corrosion resistance is improved. Laser surface remelting technology can improve the structure and properties of 304 stainless steel.Keywords
Funding Information
- Natural Science Foundation of Anhui Jianzhu University (2019QDZ20)
- Anhui Provincial Key Laboratory of Natural Science (KJ2019A0798)
This publication has 22 references indexed in Scilit:
- Improving the bio-corrosion behavior of AISI316L stainless steel through deposition of Ta-based thin films using PACVDApplied Surface Science, 2018
- Biological and corrosion behavior of m-ZrO2 and t-ZrO2 coated 316L SS for potential biomedical applicationsCeramics International, 2018
- Enhancing the localised corrosion resistance of 316L stainless steel via FBR-CVD chromising treatmentCorrosion Engineering, Science and Technology: The International Journal of Corrosion Processes and Corrosion Control, 2017
- Transition from superhydrophilic to superhydrophobic state of laser textured stainless steel surface and its effect on corrosion resistanceCorrosion Science, 2017
- Wear Resistance and Non-Magnetic Layer Formation on 316L Implant Material with Plasma NitridingJournal of Bionic Engineering, 2014
- Corrosion behaviour of laser surface melted magnesium alloy AZ91DMaterials & Design (1980-2015), 2014
- Nanosecond laser surface modification of AISI 304L stainless steel: Influence the beam overlap on pitting corrosion resistanceApplied Surface Science, 2014
- Numerical simulation of transient temperature field during laser keyhole welding of 304 stainless steel sheetOptics & Laser Technology, 2011
- Improvement of ductility in magnesium alloy sheet using laser scanning treatmentMaterials Letters, 2010
- Coated 316L stainless steel with CrxN film as bipolar plate for PEMFC prepared by pulsed bias arc ion platingJournal of Power Sources, 2008