Influence of mean stress on the fatigue of welded tubular structures under uniaxial fatigue loading
Open Access
- 28 February 2026
- journal article
- research article
- Published by Springer Nature in Welding in the World
- Vol. 70 (5) , 2005-2024
Abstract
Welded hollow section joints are essential for weight reduction in load-bearing structures of agricultural machinery and cranes while maintaining high load capacity. In mobile and gantry cranes, their favorable structural properties enhance durability and significantly reduce overall weight, thereby improving maneuverability and energy efficiency. In these applications, primary loads induce cyclic stresses with either tensile or compressive mean components, which interact with residual stresses from the welding process. In the nominal stress approach of existing codes and guidelines, mean stress effects are typically disregarded due to the assumption of high residual tensile stresses. The structural stress method outlined in the CIDECT Design Guide also does not account for residual or mean stresses, nor does it differentiate between material grades. In contrast, the effective notch stress concept considers mean stress effects via enhancement factors but assumes stress ratio independence for non-stress-relieved and complex welded structures. To address these limitations, fatigue tests with wall thicknesses below 10 mm were conducted within the FOSTA P 1603 research project at Munich University of Applied Sciences. The tests focused on X-joints made of rectangular and circular hollow section tubes using S355J2H and high-strength S620QH steels. The joints were tested under up to four different load ratios. The results are evaluated using the nominal stress and local stress fatigue approaches to identify discrepancies in current guidelines and to develop more accurate, less conservative recommendations. This paper presents the experimental findings and highlights the need for improved fatigue assessment methods for welded hollow section joints.Keywords
Funding Information
- Forschungsvereinigung Stahlanwendung (P1603)
- Hochschule für angewandte Wissenschaften München
This publication has 20 references indexed in Scilit:
- Sequence effects on the life estimation of welded tubular structures made of S355J2H under uniaxial fatigue loadingWelding in the World, 2024
- Recommendations for Fatigue Design of Welded Joints and Components2024
- Sequence effects on the life estimation of thin-walled welded tubular structures made of HSS + UHSS under bendingWelding in the World, 2022
- An enhancement of the current design concepts for the improved consideration of residual stresses in fatigue-loaded weldsWelding in the World, 2021
- Mean stress correction in fatigue design under consideration of welding residual stressWelding in the World, 2020
- Structural Hot-Spot Stress Approach to Fatigue Analysis of Welded Components2018
- Hochfeste nahtlose Rohre und Stahlbauhohlprofile für Krane und den MaschinenbauStahlbau, 2015
- An efficient meshing approach for the calculation of notch stressesWelding in the World, 2012
- Size effects in the fatigue behavior of welded steel tubular bridge jointsMaterialwissenschaft und Werkstofftechnik, 2008
- Fatigue behaviors of square-to-square hollow section T-joint with corner crack. II: Numerical modelingEngineering Fracture Mechanics, 2007