Stability of Bipolar Plate Materials for Proton‐Exchange Membrane Water Electrolyzers: Dissolution of Titanium and Stainless Steel in DI Water and Highly Diluted Acid
Open Access
- 20 September 2023
- journal article
- research article
- Published by Wiley in ChemElectroChem
- Vol. 10 (20)
Abstract
The widespread use of proton exchange membrane water electrolyzers (PEMWE) is hindered by their high cost, of which a colossal factor is caused by the bipolar plates (BPP). In this paper, we investigate the stability of two BPP materials on‐line with an optimized scanning flow cell setup coupled to an inductively coupled plasma mass spectrometer (SFC‐ICP‐MS), as well as scanning electron microscopy (SEM). The stability of currently used titanium and a cheaper alternative, stainless steel (SS) 316L, were characterized in deionized (DI) water and 0.5 mM H2SO4 to mimic the conditions at the BPP under operation. We show that the dissolution of Ti is negligible, whereas SS 316L degrades notably. Here, besides pH, the applied potentials play a crucial role. Nonetheless, even for the highest measured dissolution rate of SS 316L, the contamination in a full cell is estimated to remain below 1 ppm. This work illustrates the capabilities of on‐line high‐throughput stability tests for BPP materials and could therefore contribute towards optimization of cost‐effective PEMWE.Keywords
This publication has 55 references indexed in Scilit:
- Time and potential resolved dissolution analysis of rhodium using a microelectrochemical flow cell coupled to an ICP-MSJournal of Electroanalytical Chemistry, 2012
- Coupling of a high throughput microelectrochemical cell with online multielemental trace analysis by ICP-MSElectrochemistry Communications, 2011
- Reviewing Metallic PEMFC Bipolar PlatesFuel Cells, 2010
- Effect of manufacturing processes on formability and surface topography of proton exchange membrane fuel cell metallic bipolar platesJournal of Power Sources, 2010
- Plasma nitriding of 316L austenitic stainless steel: Experimental investigation of fatigue life and surface evolutionSurface and Coatings Technology, 2010
- The influence of metal ions on the conductivity of Nafion 112 in polymer electrolyte membrane fuel cellJournal of Power Sources, 2008
- Glow discharge nitriding of AISI 316L austenitic stainless steel: Influence of treatment pressureSurface and Coatings Technology, 2006
- Conductivity of polymer electrolyte membranes by impedance spectroscopy with microelectrodesSolid State Ionics, 2005
- Contaminant absorption and conductivity in polymer electrolyte membranesJournal of Power Sources, 2005
- XPS investigations of electrochemically formed passive layers on Fe/Cr-alloys in 0.5 M H2SO4Corrosion Science, 2004