A 14-Bit Oversampled SAR ADC With Mismatch Error Shaping and Analog Range Compensation
- 21 March 2023
- journal article
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 70 (5) , 1719-1723
Abstract
DAC mismatch is a major challenge for high-resolution ADCs. This paper proposes an analog-detection-based input range compensation technique for high-resolution ADCs with mismatch error shaping (MES). By applying a pre-comparison and suitably switching the DAC MSB, the input loss caused by MES is compensated. By adopting a flying-capacitor sampling technique, the prediction errors found in prior solutions are avoided. The prototype 14-bit SAR ADC achieves 80.4 dB SNDR and 93 dB SFDR in a 4 kHz signal bandwidth with an OSR of 16. It only occupies 0.0034 mm and consumes 0.656 μW under a 0.8 V supply, leading to a Schreier figure-of-merit of 178.3 dB. These features make it suitable for miniaturized high-performance IoT and biomedical systems.Keywords
Funding Information
- Dutch Research Council (16594)
This publication has 9 references indexed in Scilit:
- A 100kHz-Bandwidth 98.3dB-SNDR Noise-Shaping SAR ADC with Improved Mismatch Error Shaping and Speed-Up Techniques2022
- A 7.3-μ W 13-ENOB 98-dB SFDR Noise-Shaping SAR ADC With Duty-Cycled Amplifier and Mismatch Error ShapingIEEE Journal of Solid-State Circuits, 2022
- A 0.37mm2 250kHz-BW 95dB-SNDR CTDSM with Low-Cost 2nd-order Vector-Quantizer DEM2022
- A 103-dB SFDR Calibration-Free Oversampled SAR ADC With Mismatch Error Shaping and Pre-Comparison TechniquesIEEE Journal of Solid-State Circuits, 2021
- 9.3 A 40kHz-BW 90dB-SNDR Noise-Shaping SAR with 4× Passive Gain and 2nd-Order Mismatch Error Shaping2020
- A 5-Channel Unipolar Fetal-ECG Readout IC for Patch-Based Fetal MonitoringIEEE Solid-State Circuits Letters, 2019
- A 1.2-V Dynamic Bias Latch-Type Comparator in 65-nm CMOS With 0.4-mV Input NoiseIEEE Journal of Solid-State Circuits, 2018
- 27.2 an oversampling SAR ADC with DAC mismatch error shaping achieving 105dB SFDR and 101dB SNDR over 1kHz BW in 55nm CMOS2016
- 11.1 An oversampled 12/14b SAR ADC with noise reduction and linearity enhancements achieving up to 79.1dB SNDR2014