Application of Electrically-Conductive Epoxy in No-Insulation Coils for Controlling Contact Resistance
- 4 February 2025
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 35 (5) , 1-6
Abstract
This article presents a partial-depth impregnation method using electrically conductive epoxy composites in high-temperature superconductor (HTS) coils. In a previous study, we proposed a wet winding technique using electrically-conductive epoxy composites to control the contact resistance of no-insulation (NI) HTS coils. In that method, the epoxy composites were applied across the entire contact surface between winding turns, allowing the contact resistance to be controlled by adjusting the mixing ratio of electrically-conductive powder. However, this approach led to significant current degradation due to delamination caused by thermal contraction mismatch between the epoxy composites and the HTS tape. The partial-depth impregnation method addresses this issue by allowing the epoxy composites to penetrate only partway between winding turns, thereby minimizing critical current degradation. In this study, HTS coils were dry-wound with 4.1 mm-wide HTS tape and insulated with 3 mm-wide polyimide tape on each turn. By applying the electrically-conductive epoxy composites to the edge of the HTS coil, the epoxy composite penetrated to a depth of 1.1 mm. This configuration allows the current to bypass through the edge of the insulated coil, providing self-protection characteristics. Additionally, the contact resistance can be controlled by adjusting the mixing ratio of the electrically-conductive powders. The feasibility of the proposed impregnation technique was demonstrated through over-current and sudden-discharge tests on the partial-depth impregnated coils with different mixing ratios of electrically conductive powders.Keywords
Funding Information
- National Research Foundation of Korea
- Ministry of Science and ICT through the National R&D Program (2022M3I9A1073187)
- Korea government (RS-2024-00391886)
This publication has 26 references indexed in Scilit:
- A surface-shunting method for the prevention of a fault-mode-induced quench in high-field no-insulation REBCO magnetsSuperconductor Science and Technology, 2024
- 26.86-tesla direct-current magnetic field generated with an all-REBCO superconducting magnetSuperconductor Science and Technology, 2024
- Electromagnetic characteristics of NI-REBCO coils according to contact surface conditions controlled by the oxidation state and roughness of the REBCO conductorPhysica C: Superconductivity and its Applications, 2023
- Bending and uniaxial tensile strain effects on the critical current of REBCO coated conductor tapesCryogenics, 2021
- 45.5-tesla direct-current magnetic field generated with a high-temperature superconducting magnetNature, 2019
- The effects of co-wound Kapton, stainless steel and copper, in comparison with no insulation, on the time constant and stability of GdBCO pancake coilsSuperconductor Science and Technology, 2014
- Turn-to-turn contact characteristics for an equivalent circuit model of no-insulation ReBCO pancake coilSuperconductor Science and Technology, 2013
- Remarkable weakness against cleavage stress for YBCO-coated conductors and its effect on the YBCO coil performancePhysica C: Superconductivity and its Applications, 2011
- Degradation of the performance of a YBCO-coated conductor double pancake coil due to epoxy impregnationPhysica C: Superconductivity and its Applications, 2010
- Bending strain characteristics of critical current in REBCO CC tapes in different modesPhysica C: Superconductivity and its Applications, 2009