Air-induced laser-assisted sequential micro-milling process for precise microchannel fabrication
- 12 October 2026
- journal article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part L: Journal of Materials: Design and Applications
Abstract
Laser micromilling suffers from surface oxidation and spatter surrounding the machined zone. However, the micromilling process has drawbacks, including tool wear, high cutting forces, burr formation, and reduced tool life. To address these issues, this study proposes a novel hybrid method for fabricating 100 µm microchannels through an air-induced laser-assisted sequential micromilling (AILASMM) process, comprising laser milling followed by tool-based micromilling. To mitigate cutting forces, compressed air is introduced during laser machining to assist in effective material removal and to promote the formation of an oxidation layer, thereby reducing forces during the subsequent micromilling step. Results demonstrated that AILASMM significantly reduces (15–25%) the magnitude of the cutting forces with respect to conventional micromilling (CMM). In addition to that, the tool wear and burr formation were reduced (15–25%) in the former technique and produced a better surface finish. Milling at an increased feed rate increased the cutting forces. The burr size was also observed to increase (from 37 to 59 µm) as the feed rate increased (from 40 to 60 mm/min). AILASMM at a lower value of the spindle speed (20000 rpm), the surface finish improved to 0.6 µm, and the burr size was reduced to 20 µm. AILASMM produced small and fragmented chips, significantly reducing the tool's adhesion wear.Keywords
This publication has 30 references indexed in Scilit:
- A Review on Hybrid Micromachining Process and Technologies2023
- Thermal effects on removal mechanism of monocrystal SiC during micro-laser assisted nanogrinding processCeramics International, 2023
- Laser-induced oxidation assisted micro milling of high aspect ratio microgroove on WC-Co cemented carbideChinese Journal of Aeronautics, 2021
- Experimental study of micromilling burrs of 304 stainless steelThe International Journal of Advanced Manufacturing Technology, 2019
- Study on laser-induced oxidation assisted micro milling of Ti6Al4V alloyThe International Journal of Advanced Manufacturing Technology, 2019
- Laser-assisted grinding of silicon nitride by picosecond laserThe International Journal of Advanced Manufacturing Technology, 2017
- Investigations into the effect of process parameters on surface roughness and burr formation during micro end milling of TI-6AL-4VThe International Journal of Advanced Manufacturing Technology, 2016
- Laser-assisted milling of Ti-6Al-4V with the consideration of surface integrityThe International Journal of Advanced Manufacturing Technology, 2015
- Research on the modeling of burr formation process in micro-ball end milling operation on Ti–6Al–4VThe International Journal of Advanced Manufacturing Technology, 2012
- Laser assisted micro-milling of hard-to-machine materialsCIRP Annals, 2009