Structural, Morphological, and Photocatalytic Comparison of TiO₂ Thin Films Deposited by RF Magnetron Sputtering at Room Temperature and 300 °C
- 29 June 2026
- journal article
- Published by Cumhuriyet University in Cumhuriyet Science Journal
- Vol. 47 (3) , 557-565
Abstract
In this study, titanium dioxide TiO₂ thin films were deposited onto glass substrates at room temperature and at a substrate temperature of 300°C using the RF magnetron sputtering technique, and their structural, morphological, chemical, and photocatalytic properties were comparatively investigated. XRD analysis revealed that the film deposited at room temperature exhibited a fully amorphous structure, whereas the film deposited at 300°C displayed low-intensity reflections of the anatase (101) and (004) planes on an amorphous background, indicating the onset of limited crystalline nucleation with increasing temperature. Cross-sectional SEM images confirmed the formation of a homogeneous layer with an approximate thickness of 330 nm, while surface SEM micrographs showed a compact and fine-grained morphology characteristic of films deposited at low temperatures. AFM measurements demonstrated a granular surface topography with an RMS roughness of approximately 26 nm over a 10 × 10 µm scan area. FTIR spectra revealed the characteristic Ti–O–Ti vibrational modes, confirming the formation of the TiO₂ network structure. Photocatalytic experiments showed that the TiO₂ film deposited at 300°C achieved approximately 74% degradation of methylene blue under UVA irradiation after about 9 hours, exhibiting significantly higher photocatalytic activity compared to the room-temperature film. This improvement is attributed to partial structural ordering and increased surface roughness. Overall, the findings demonstrate that the structural evolution occurring in TiO₂ thin films deposited at low temperatures directly influences their photocatalytic behavior, and that TiO₂ films exhibiting considerable photocatalytic performance can be produced even at moderate deposition temperatures such as 300°C.Keywords
This publication has 31 references indexed in Scilit:
- Effect of substrate temperature on the photocatalytic degradation efficiency of methylene blue using TiO₂ thin filmsReaction Kinetics, Mechanisms and Catalysis, 2025
- A current review of TiO2 thin films: synthesis and modification effect to the mechanism and photocatalytic activityApplied Surface Science Advances, 2025
- Effect of substrate temperature and annealing on the growth of TiO 2‐x thin films deposited by using DC‐magnetron sputtering techniqueSurface and Interface Analysis, 2023
- Photocatalytic antimicrobial and photostability studies of TiO2/ZnO thin filmsArabian Journal of Chemistry, 2023
- Microstructure-induced functionality in titanium dioxide thin filmsMaterials Characterization, 2023
- Development of photocatalytic nanostructured TiO2 and NiO/TiO2 coatings by DC magnetron sputtering for photocatalytic applicationsCeramics International, 2023
- Photocatalytic TiO2-based coatings for environmental applicationsCatalysis Today, 2021
- Highly crystallized mesoporous anatase films with enhanced photoactivity derived from sputter deposited TiO2-WO3 composites: The positive role of sodiumApplied Surface Science, 2021
- Room temperature deposition of XRD-amorphous TiO2 thin films: Investigation of device performance as a function of temperatureCeramics International, 2018
- Influence of annealing temperature on structure and photocatalytic activity of TiO2 thin films prepared by DC reactive magnetron sputtering methodWuhan University Journal of Natural Sciences, 2012