Evaluation of Strength Anisotropy in Foliated Metamorphic Rocks: A Review Focused on Microscopic Mechanisms
Open Access
- 26 September 2024
- journal article
- review article
- Published by MDPI AG in Geosciences
- Vol. 14 (10) , 253
Abstract
This review paper addresses the recent and past advancements in investigating the anisotropic behavior of foliated metamorphic rock strength subjected to uniaxial or triaxial compression loading, direct or indirect tensile loading, and shear loading. The experimental findings published in the literature show that the strength of foliated rocks is significantly affected by varying the angle β between weak planes and major principal stress. A higher value of strength is reported at β = 0° or 90°; whereas a low strength value is noted at intermediate angles between β = 0° and 90°. The strength anisotropy depends on the degree of schistosity or gneissosity, which is the result of the preferred arrangement of phyllosilicate minerals under differential pressures. The failure of foliated rocks starts at the microscopic scale because of the dislocation slip, plastic kinking, and fracturing in phyllosilicate minerals such as mica. Tensile wing cracks at the tip of the mica propagate parallel to the deviatoric stress. Then, intergranular and intragranular shear-tensile cracks coalesce and lead to rock failure. The weak planes’ orientation controls the mode of failure such that tensile splitting, slip failure, and shear failure across foliations are observed at β = 0°–30°, β = 30°–60°, β = 60°–90° respectively. In the past, several attempts have been made to formulate failure criteria to estimate rock strength using different mathematical and empirical approaches. Over the years, the trend has shifted towards discontinuum modeling to simulate rock failure processes and to solve problems from laboratory to upscaled levels.Keywords
This publication has 123 references indexed in Scilit:
- Low Static Shear Modulus Along Foliation and Its Influence on the Elastic and Strength Anisotropy of Poorman Schist Rocks, Homestake Mine, South DakotaRock Mechanics and Rock Engineering, 2020
- Three‐dimensional discrete element simulation of indirect tensile behaviour of a transversely isotropic rockInternational Journal for Numerical and Analytical Methods in Geomechanics, 2020
- Mechanical Properties and Failure Patterns of Migmatized Gneiss with Metamorphic Foliation Under UCS TestRock Mechanics and Rock Engineering, 2019
- Assessment of Inherent Anisotropy and Confining Pressure Influences on Mechanical Behavior of Anisotropic Foliated Rocks Under Triaxial CompressionRock Mechanics and Rock Engineering, 2015
- Slope Failure in a Foliated Rock Mass with Non-Uniform Joint Spacing: a Comparison Between Numerical and Centrifuge Model ResultsRock Mechanics and Rock Engineering, 2014
- Menderes Massif (Western Turkey): structural, metamorphic and magmatic evolution - a synthesisInternational Journal of Earth Sciences, 2001
- Time‐dependent multilaminate model of rocks—a numerical study of deformation and failure of rock massesInternational Journal for Numerical and Analytical Methods in Geomechanics, 1977
- On yielding of oriented solidsActa Mechanica, 1977
- Indirect tensile testing of anisotropic rocksRock Mechanics and Rock Engineering, 1973
- The application of ionic equilibria to metamorphic differentiation: An exampleContributions to Mineralogy and Petrology, 1970