MICROSTRUCTURE, RESIDUAL STRESSES, TEXTURE, AND MECHANICAL PROPERTIES OF A WELDED JOINT IN VT1-0 ALLOY SHEETS
Open Access
- 1 April 2025
- journal article
- Published by Institute of Engineering Science, Ural Branch RAS in Diagnostics, Resource and Mechanics of materials and structures
- Vol. 2025 (2) , 42-59
Abstract
The grain structure, microstrain distribution, crystallographic texture and residual stresses in a CO2 laser welded joint of VT1-0 alloy sheets (technical titanium) are studied by EBSD and X-ray diffraction analysis. The mechanical properties of the welded joint are determined. It is shown that the weld structure is represented by differently directed large laths of the α-phase. The metal in the heat-affected zones is characterized by a mixed structure resulting from the polymorphic β→α transformation in the form of packets of secondary α-phase plates near the weld and polyhedral α-grains near the base metal. Multicomponent textures have been detected in all the zones of the welded joint. This creates prerequisites for decreased anisotropy of strength properties, which is typical of hexagonal crystals. The strength of the welded joint proves to be significantly higher than that of the base metal; namely, the ultimate strength of the joint is 660 MPa, and that of the base material is 500 MPa. The heat-affected zone is the most deformed zone in the welded joint, the share of deformed grains reaches 44%, and residual stresses do not exceed 10% of the yield strength.Keywords
This publication has 9 references indexed in Scilit:
- EBSD Analysis of an Austenitic Cr–Ni Steel Laser WeldPhysics of Metals and Metallography, 2022
- A review on alpha case formation and modeling of mass transfer during investment casting of titanium alloysJournal of Alloys and Compounds, 2021
- Deformation behavior of Ti-6Al-4V microstructures under uniaxial loading: Equiaxed Vs. transformed-β microstructuresMaterials Characterization, 2021
- Microstructural manipulation and improved mechanical properties of a near α titanium alloyMaterials Science and Engineering: A, 2020
- Microstructural evolution and hardness response in the laser beam welded joints of pure titanium during recrystallization and grain growthMaterials Characterization, 2018
- Crystal growth during keyhole mode laser weldingActa Materialia, 2017
- Heat and thermomechanical treatment and textural hardening of weldable titanium alloysWelding International, 2013
- Microstructural evolution of fusion zone in laser beam welds of pure titaniumMaterials Characterization, 2012
- A 3D Hough transform for indexing EBSD and Kossel patternsJournal of Microscopy, 2008