Abstract
Unified temperature-dependent models are developed to optimize ${R} {_{\text {sp}}}$ for the insulating pillar superjunction (IP-SJ) MOSFETs. The insulating pillar (i-pillar) could be intrinsic silicon in the compensated pillar SJ (CP-SJ) structure, oxide in the oxide pillar SJ (OP-SJ) structure, or even air in the air pillar SJ (AP-SJ) structure. These three typical structures are investigated and compared. Extensive investigations reveal that CP-SJ exhibits no improvement ${R} {_{\text {sp}}}$ compared with the conventional SJ (C-SJ) structure. The AP-SJ (with the lowest relative dielectric constant of unity) possesses the best ${R} {_{\text {sp}}}$ , especially with high BV and narrow half cell width b, and large drain-to-source voltage ( ${V} {_{\text {DS}}}$ ), due to better suppression of JFET effect. For BV ${=}1250$ V and ${b}{=}0.6~{\mu }$ m, theoretical optimization predicts a largest reduction up to 20.5% in ${R} {_{\text {sp}}}$ with ${V} {_{\text {DS}} =}5$ V for the AP-SJ at room temperature. The effects of temperature (T) on the optimization results and the temperature-dependent application are also investigated.
Funding Information
  • National Natural Science Foundation of China (51607026)
  • Open Foundation of State Key Laboratory of Electronic Thin Films and Integrated Devices (KFJJ202106)
  • Guangdong Basic and Applied Basic Research Foundation (2021A1515011720)

This publication has 15 references indexed in Scilit: