Mechanothermal assessment of outdoors aged hybrid glass fibre reinforced polymer composite filled with fly ash as industrial waste
- 2 February 2024
- journal article
- research article
- Published by SAGE Publications in Journal of Reinforced Plastics and Composites
Abstract
Industrial fly ash impregnated glass fibre reinforced polymer (GFRP) composites were examined to assess their overall characteristics in adverse ambient conditions, keeping in mind that use of filler materials in FRP composites was expected to enhance the strength properties of the material. GFRP composite specimens with 2–10 wt % industrial fly ash were fabricated in the laboratory. These were exposed to open ambient ageing for 120 days. The samples impregnated with 8 wt % fly ash and aged for 120 days were seen to absorb the minimum moisture and exhibited the maximum ILSS of 35.19 MPa and flexural strength of 690 MPa, respectively. These samples also exhibited the highest Tg of 101.53°C as revealed through low temperature DSC. It was also observed that the 8 wt% fly ash containing samples aged in the open for 120 days showed the ILSS to be 5.83% higher and Tg to be 21.95% higher as compared to the unaged GFRP samples without fly ash. FTIR spectra confirm the trend of thermo-mechanical properties. Both optical and scanning electron microscopy of the fractured surfaces of the test samples revealed the modes of mechanical failure of the hybrid GFRP composite with their indicative properties at optimized extent of fly ash dispersion.Keywords
Funding Information
- World Bank Project (755/GMU, dated 19-02-2022)
This publication has 42 references indexed in Scilit:
- Study on mechanical properties of fly ash impregnated glass fiber reinforced polymer composites using mixture design analysisMaterials & Design (1980-2015), 2014
- Studies on dry sliding wear behaviour of functionally graded graphite particle-filled glass-epoxy compositesComposite Interfaces, 2013
- Flexural properties of lightweight FRP composite truss structuresJournal of Composite Materials, 2011
- Analysis of flexural properties of hollow-particle filled compositesComposites Part B: Engineering, 2010
- A novel method to measure residual stresses in unidirectional GFRPComposite Structures, 2009
- Analysis of carboxyl group in coal and coal aromaticity by Fourier transform infrared (FT-IR) spectrometryFuel, 2009
- Solid particle erosion of glass fibre reinforced flyash filled epoxy resin compositesComposites Science and Technology, 2006
- Temperature effect during humid ageing on interfaces of glass and carbon fibers reinforced epoxy compositesJournal of Colloid and Interface Science, 2006
- Measurement of Fiber Density by Helium PycnometryJournal of Composite Materials, 2000
- Influence of cure conditions on glass transition temperature and density of an epoxy resinJournal of Applied Polymer Science, 1986