Fatigue of As-Fabricated Open Cell Aluminum Foams
- 1 January 2005
- journal article
- Published by ASME International in Journal of Engineering Materials and Technology
- Vol. 127 (1) , 40-45
Abstract
This paper presents the results of the combined experimental investigation and digital image correlation (DIC) analysis of the fatigue failure of open cell aluminum foams. Compression–compression cyclic loads were applied to foam specimens under the as-fabricated condition. Following characterization of the S-N curve behavior, the macroscale deformation of the tested foam under fatigue was recorded using an in-situ digital camera. The deformation sequence was then analyzed using DIC technique. It was found that foams failed with an abrupt strain jump when shear bands were formed, and serious deformation up to more than 30% was developed in the center of the shear band. The ex-situ scanning electron microscopy analysis indicated that the abrupt strain jump was due to the microscale damage accumulation in struts where surface cracks were formed and propagated.Keywords
This publication has 11 references indexed in Scilit:
- Mechanisms and mechanics of compressive deformation in open-cell Al foamsMechanics of Materials, 2004
- Influence of heat treatment on compression fatigue of aluminium foamsJournal of Materials Science, 2002
- Metal Foams: A Design GuideApplied Mechanics Reviews, 2001
- Manufacture, characterisation and application of cellular metals and metal foamsProgress in Materials Science, 2001
- Fatigue properties of aluminium foams at high numbers of cyclesMaterials Science and Engineering: A, 2000
- Mechanical Behavior of Metallic FoamsAnnual Review of Materials Science, 2000
- The stress–life fatigue behaviour of aluminium alloy foamsFatigue & Fracture of Engineering Materials & Structures, 2000
- Compression fatigue of a cellular Al alloyMaterials Science and Engineering: A, 1999
- Fatigue failure of an open cell and a closed cell aluminium alloy foamActa Materialia, 1999
- Cellular Solids1997