Line Parameter Estimation of Distribution Network after Grounding Fault
- 1 February 2020
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Abstract
With the high impedance single-phase ground fault occurs in a distribution network, the line parameters will change substantially. Typically, the neutral resonance grounding is used to compensate the fault current. Better results can be achieved with active compensation, but precise line parameters need to be known. In this paper, an existing method of estimating distribution line parameters using only RMS voltage and power measurements is employed to estimate distribution line parameters after high impedance single-phase ground fault. The power flow equation without voltage phase angle, the compensation model of active compensation device and the measurement error compensation model are established. Simulation results obtain the required line parameters while reducing measurement error and computational complexity. It is conducive to the subsequent state analysis of distribution lines.Keywords
This publication has 16 references indexed in Scilit:
- Principle and Design of a Single-Phase Inverter-Based Grounding System for Neutral-to-Ground Voltage Compensation in Distribution NetworksIEEE Transactions on Industrial Electronics, 2016
- Impact of Smart Metering Data Aggregation on Distribution System State EstimationIEEE Transactions on Industrial Informatics, 2016
- A Novel Neutral Electromagnetic Hybrid Flexible Grounding Method in Distribution NetworksIEEE Transactions on Power Delivery, 2016
- Synchrophasor measurement method for overhead line parameters estimation in MV distribution networks2014
- Identification of power distribution network topology via voltage correlation analysis2013
- Blind topology identification for power systems2013
- Line parameter estimation using phasor measurements by the total least squares approach2013
- Estimation of Parameters of a Three-Phase Distribution FeederIEEE Transactions on Power Delivery, 2011
- Transmission Line Conductor Temperature Impact on State Estimation Accuracy2007
- Real time recursive parameter estimation in energy management systemsIEEE Transactions on Power Systems, 1996