Study of mechanical properties of ceramic materials based on ca3(po4)2-ca2,5na(po4)2, obtained by 3d printing

Authors:
  • LULomonosov Moscow State University
    Lomonosov Moscow State University
  • YFYa.YU. Filippov
    Ya.YU. Filippov
  • SUShenzhen MSU-BIT University
    Shenzhen MSU-BIT University
  • DLD.S. Larionov
    D.S. Larionov
  • AGA.V. Garshev
    A.V. Garshev
  • DPD.V. Prosvirnin
    D.V. Prosvirnin
  • VPV.I. Putlyaev
    V.I. Putlyaev

Abstract
The mechanical properties of ceramic materials based on high-temperature phases of tricalcium phosphate α-Ca3(PO4)2 and sodium rhenanite Ca2,5Na(PO4)2, as well as their composites in the 1:1 molar ratio, fabricated by the stereolithography method, have been studied. It is shown that the composite (biphase) ceramics produced by pressing followed by firing exhibit the highest density - 92% - and ultimate compression strength up to 120 MPa. For ceramic materials synthesized by 3D printing with a specified porosity of 70%, the influence of the pore space architecture on the mechanical properties under compression was determined. It is shown that ceramics with the Kelvin architecture exhibit greater strength than ceramics with the gyroid architecture. A temperature-time regime for heat treatment of the printed samples was developed to remove the polymer matrix, resulting in crack-free ceramics. It was found that the ultimate compressive strength of 3D ceramics based on α-Ca3(PO4)2 reached 2.5 MPa, which is acceptable for medical applications.