International Round-Robin Test of Critical Current of Superconducting Cable Sample
- 5 August 2024
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 34 (7) , 1-6
Abstract
Ten institutes from six countries participated in an international round-robin test to evaluate the critical current of a superconducting power cable made of Bi-2223 tapes. The cable design featured a two-layer inner core conductor and a single-layer outer shield conductor. The shield layer measured approximately 40 mm in diameter, and the cable length was 2.0 m. To eliminate the influence of resistive voltage drops from current transfer, voltage taps for measurement were positioned at a sufficient distance from the current terminals. The critical current was determined using the resistive method with the electric field criterion of 1.0 ${\rm{\mu V}}/\text{cm}$ . In addition, the $n$ -value, an optional parameter reflecting the current–voltage ( $I$ – $V$ ) characteristics, was extracted from the $I$ – $V$ curve within an electric field range of 0.1–1.0 ${\rm{\mu V}}/\text{cm}$ . A detailed uncertainty analysis was conducted for both the critical current and the $n$ -value. Finally, this article discusses the potential for standardization of the employed resistive measurement method.Keywords
This publication has 24 references indexed in Scilit:
- The research on the current capability and insulating properties of 35 kV/1 kA CD HTS cable witness samplesIOP Conference Series: Earth and Environmental Science, 2019
- Development of Tri-axial superconducting cable system for type testJournal of Physics: Conference Series, 2018
- Progress of 275kV–3kA YBCO HTS cablePhysica C: Superconductivity and its Applications, 2011
- Development of YBCO power devices in JapanPhysica C: Superconductivity and its Applications, 2010
- Development of (RE)BCO cables for HTS power transmission linesPhysica C: Superconductivity and its Applications, 2009
- Development of a 10 m long 1 kA 66/77 kV YBCO HTS cable with low AC loss and a joint with low electrical resistanceSuperconductor Science and Technology, 2009
- Status of high temperature superconductor cable and fault current limiter projects at American SuperconductorPhysica C: Superconductivity and its Applications, 2009
- Development of YBCO HTS cable with low AC lossPhysica C: Superconductivity and its Applications, 2008
- Study of an YBCO HTS transmission cable systemPhysica C: Superconductivity and its Applications, 2007
- Operation experiences with a 30 kV/100 MVA high temperature superconducting cable systemSuperconductor Science and Technology, 2004