SMSergey S. Mikhrin

Sergey S. Mikhrin

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Sergey S. Mikhrin has a total of 106 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • High-average power femtosecond VECSELs with tunable repetition rates up to 10 GHz

    by O. D. Sieber, V. J. Wittwer, M. Hoffmann, I. L. Krestnikov, S. S. Mikhrin, D. A. Livshits, M. Golling, T. Südmeyer, U. Keller

    We present high average power femtosecond VECSELs based on both quantum dot (QD) and quantum well (QW) gain with extremely low dispersion. 1.05 W in 784-fs pulses could be achieved from a QD-VECSEL modelocked by a QDSESAM with fast recovery dynamics. A similar QW-gain structure modelocked by the same SESAM enabled stable 480-fs with an average output power of 300 mW at a repetition rate of 7 GHz. Furthermore, we investigated repetition rate scaling by changing the cavity length. We demonstrated fundamentally modelocked pulses over a tuning range from 6.5 GHz to 11.3 GHz. Without any realignment of the cavity over the whole tuning range, the pulse duration remained nearly constant around 625 fs (±3.5%) while the output power was 169 mW (±6%). The center wavelength changed only about ±0.2 nm around 963.8 nm. A tunable repetition rate can be of interest for various metrology application such as optical sampling by laser cavity tuning.


  • All quantum dot based femtosecond VECSEL

    by M. Hoffmann, O. D. Sieber, W. P. Pallmann, V. J. Wittwer, I. L. Krestnikov, S. S. Mikhrin, D. A. Livshits, G. Malcolm, C. Hamilton, Y. Barbarin, et al.

    Using quantum well gain materials, ultrafast VECSELs have achieved higher output powers (2.1 W) and shorter pulses (60 fs) than any other semiconductor laser. Quantum dot (QD) gain materials offer a larger inhomogeneously broadened bandwidth, potentially supporting shorter pulse durations. We demonstrate the first femtosecond QD-based VECSEL using a QD-SESAM for modelocking, obtaining 63 mW at 3.2 GHz in 780-fs pulses at 960 nm. In continuous wave operation we obtained 5.2 W using an intra-cavity diamond heat spreader, which has been the highest output power from a QD-VECSEL so far. Further power scaling is thus expected also for modelocked operation.


  • High-power quantum-dot-based semiconductor disk laser

    by M. Butkus, K. G. Wilcox, J. Rautiainen, O. G. Okhotnikov, S. S. Mikhrin, I. L. Krestnikov, A. R. Kovsh, M. Hoffmann, T. Südmeyer, U. Keller, et al.

    We demonstrate multiwatt cw output power from an optically pumped quantum-dot semiconductor disk laser. Continuous-wave output power of 4.35 W with 22% slope efficiency was demonstrated at a center wavelength of 1032 nm. This represents an increase in power of 15 times and an increase in slope efficiency of 10 times from the previously published results using Stranski–Krastanow grown quantum dots. An intracavity diamond heat spreader was used for thermal management. The maximum output power was limited by the available pump power, and no sign of thermal rollover was observed.


  • Temperature-Dependent Small-Signal Analysis of High-Speed High-Temperature Stable 980-nm VCSELs

    by Alex Mutig, Gerrit Fiol, Konstantin Potschke, Phillip Moser, Dejan Arsenijevic, Vitaly A. Shchukin, Nikolay N. Ledentsov, Sergey S. Mikhrin, Igor L. Krestnikov, Daniil A. Livshits, et al.

    980-nm VCSELs based on submonolayer growth show for 20-Gbit/s large-signal modulation clearly open eyes without adjustment of the driving conditions between 25degC and 120degC. To access the limiting mechanism for the modulation bandwidth, a temperature-dependent small-signal analysis is carried out on these devices. Single-mode devices are limited by damping, whereas multimode devices are limited by thermal effects, preventing higher photon densities in the cavity.


  • 120°C 20 Gbit/s operation of 980nm VCSEL based on sub-monolayer growth

    by Friedhelm Hopfer, Alex Mutig, Gerrit Fiol, Phillip Moser, Dejan Arsenijevic, Vitaly A. Shchukin, Nikolai N. Ledentsov, Sergey S. S. Mikhrin, Igor L. Krestnikov, Daniel A. Livshits, et al.

    980 nm VCSELs based on sub-monolayer growth show for 20 Gbit/s large signal modulation clearly open eyes without adjustment of the driving conditions between 25 and 120 °C. To access the limiting mechanism for the modulation bandwidth, a temperature dependent small signal analysis is carried out on these devices. Single mode devices are limited by damping, whereas multimode devices are limited by thermal effects, preventing higher photon densities in the cavity.


  • Tilted cavity concept for the high-power wavelength stabilized diode lasers

    by L. Ya. Karachinsky, I. I. Novikov, G. Fiol, M. Kuntz, Yu. M. Shernyakov, N. Yu. Gordeev, M. V. Maximov, M. B. Lifshits, T. Kettler, K. Posilovic, et al.

    We discuss wavelength stabilized all-epitaxial Tilted Cavity Lasers (TCLs). Optical cavity of a TCL favors propagation of only one tilted optical mode ensuring wavelength-selective operation. The possibility of full control of the thermal shift of the lasing wavelength d λ/dT in TCL including positive, zero or negative shift, is proved theoretically. Broad-area (100 μm) 970-nm-range devices have been fabricated showing a high temperature stability of the lasing wavelength (0.13 nm/K), a high power operation (> 7 W in pulsed mode and > 1.5 W in continuous wave (cw) mode), and a narrow vertical far-field beam divergence (FWHM ~ 20°). Single transverse mode edge-emitting 4 μm-wide-ridge TCLs demonstrated high-power spatial and spectral single mode cw operation with a longitudinal side mode suppression ratio (SMSR) up to 41.3 dB at 93 mW output power. Such a result is similar to the best values achieved for DFB lasers in the same spectral range, while no etching and overgrowth is used in present case.

  • Novel concepts for ultrahigh-speed quantum-dot VCSELs and edge-emitters

    by N. N. Ledentsov, F. Hopfer, A. Mutig, V. A. Shchukin, A. V. Savel'Ev, G. Fiol, M. Kuntz, V. A. Haisler, T. Warming, E. Stock, et al.

    Advanced types of QD media allow an ultrahigh modal gain, avoid temperature depletion and gain saturation effects, when used in high-speed quantum dot (QD) vertical-cavity surface-emitting lasers (VCSELs). An anti-guiding VCSEL design reduces gain depletion and radiative leakage, caused by parasitic whispering gallery VCSEL modes. Temperature robustness up to 100°C for 0.96 - 1.25 &mgr;m range devices is realized in the continuous wave (cw) regime. An open eye 20 Gb/s operation with bit error rates better than 10-12 has been achieved in a temperature range 25-85°C without current adjustment. A different approach for ultrahigh-speed operation is based on a combination of the VCSEL section, operating in the CW mode with an additional section of the device, which is electrooptically modulated under a reverse bias. The tuning of a resonance wavelength of the second section, caused by the electrooptic effect, affects the transmission of the system. The second cavity mode, resonant to the VCSEL mode, or the stopband edge of the second Bragg reflector can be used for intensity modulation. The approach enables ultrahigh speed signal modulation. 60GHz electrical and ~35GHz optical (limited by the photodetector response) bandwidths are realized.


  • 20-Gb/s direct modulation of 980 nm VCSELs based on submonolayer deposition of quantum dots

    by F. Hopfer, Mutig A, G. Fiol, M. Kuntz, S. S. Mikhrin, I. L. Krestnikov, D. A. Livshits, A. R. Kovsh, C. Bornholdt, V. Shchukin, et al.

    980 nm vertical-cavity surface-emitting laser based on sub-monolayer growth of quantum dots show at 25 and 85°C for 20 Gb/s without current adjustment clearly open eyes and error free operation with bit error rates better than 10-12. For these multimode lasers the small signal modulation bandwidth decreases only from 15 GHz at 25°C to 13 GHz at 85°C. Single mode devices demonstrate at 20°C a small signal modulation bandwidth of 16.6 GHz with 0.8 mW optical output power and a record high modulation current efficiency factor of 19 GHz/mA1/2.


  • Edge and surface-emitting tilted cavity lasers (Invited Paper)

    by N. N. Ledentsov, V. A. Shchukin, A. R. Kovsh, S. S. Mikhrin, I. L. Krestnikov, A. V. Kozhukhov, N. Yu. Gordeev, L. Ya. Karachinsky, M. V. Maximov, I. I. Novikov, et al.

    The Tilted Cavity (TC) concept has been proposed to combine advantages of edge- and surface-emitting lasers (detectors, amplifiers, switches, etc.). Tilted Cavity Lasers (TCL) enable wavelength-stabilized high-power edge and surface emitters (TCSEL) in low-cost single-epitaxial step design. The concept covers numerous applications including mode-locked TCL for light speed control, dispersion and linewidth engineering, GaN-based light-emitters, electrooptic wavelength tunable devices, and other applications. Presently, wavelength stabilized TC operation is realized between -200°C and 70°C in broad TCL diodes with cleaved facets based on quantum dots (QDs). The spectral width is below 0.6 nm in broad area 100 μm-wide-stipe devices. The far fields are: 4° (lateral) and 42° (vertical). Wavelength-stabilized 1.16 μm and 1.27 μm edge-emitting QD TCL lasers are demonstrated. Quantum well TCL demonstrate high-temperature operation up to 240°C with a low threshold, high temperature stability and improved wavelength stability. The tilted cavity approach can also be applied in wavelength-optimized photodetectors, switches, semiconductor optical amplifiers, including multi-channel devices, in optical fibers, in photodetectors, in light-emitting diodes and in many other applications. Moreover, microelectronic devices based on similar tilted angle resonance phenomena in quantum wells and superlattices can be realized in electron- or hole-wavefunction-engineered structures, thus, merging the fields of nanophotonics and nanoelectronics. The tilted cavity concept can be further complimented by lateral patterning and (or) processing of three-dimensional photonic crystal structures further extending horizons of modern optoelectronics.


  • High-power, high repetition rate, short-pulse mode-locking using flared waveguide quantum-dot lasers at 1.3 μm

    by M.G. Thompson, F.K. Lau, R.L. Sellin, C. Marinelli, R.V. Penty, I.H. White, A.R. Kovsh, S.S. Mikhrin, D.A. Livshits, N.N. Ledentsov, et al.

    Ultra-short pulse, high power mode-locking is demonstrated in InGaAs quantum dot lasers using a flared waveguide design. 24 GHz mode-locking with 790 fs wide pulses and 500 mW peak powers suitable for telecommunications applications are presented. (2 pages)