MKMatthias Kuntz

Matthias Kuntz

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Matthias Kuntz has a total of 71 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Ultra high-speed nanophotonics

    by D. Bimberg, G. Fiol, C. Meuer, D. Arsenijevic, J. Kim, S. Liebich, M. Laemmlin, M. Kuntz, H. Schmeckebier, G. Eisenstein

    Mode-locked lasers (MLLs) and semiconductor optical amplifiers (SOAs) based on quantum dot (QD) gain material will impact the development of next generation networks like the 100Gb/s Ethernet. Hybrid mode-locked lasers consisting of a monolithic two section device presently already generate picosecond pulse trains at 40 GHz with an extremely low jitter in the range of 200 fs under optimum operating conditions. A detailed chirp analysis which is prerequisite for optical time division multiplexing applications is presented. QD SOAs are showing superior performance for linear amplification as well as nonlinear signal processing. Wavelength conversion via cross-gain modulation is shown to have a small signal bandwidth beyond 40 GHz under high bias current injection. This makes QD SOAs much superior to conventional SOAs.

  • Tilted cavity concept for the high-power wavelength stabilized diode lasers

    by L. Ya. Karachinsky, I. I. Novikov, G. Fiol, M. Kuntz, Yu. M. Shernyakov, N. Yu. Gordeev, M. V. Maximov, M. B. Lifshits, T. Kettler, K. Posilovic, et al.

    We discuss wavelength stabilized all-epitaxial Tilted Cavity Lasers (TCLs). Optical cavity of a TCL favors propagation of only one tilted optical mode ensuring wavelength-selective operation. The possibility of full control of the thermal shift of the lasing wavelength d λ/dT in TCL including positive, zero or negative shift, is proved theoretically. Broad-area (100 μm) 970-nm-range devices have been fabricated showing a high temperature stability of the lasing wavelength (0.13 nm/K), a high power operation (> 7 W in pulsed mode and > 1.5 W in continuous wave (cw) mode), and a narrow vertical far-field beam divergence (FWHM ~ 20°). Single transverse mode edge-emitting 4 μm-wide-ridge TCLs demonstrated high-power spatial and spectral single mode cw operation with a longitudinal side mode suppression ratio (SMSR) up to 41.3 dB at 93 mW output power. Such a result is similar to the best values achieved for DFB lasers in the same spectral range, while no etching and overgrowth is used in present case.

  • High-Speed Mode-Locked Quantum-Dot Lasers and Optical Amplifiers

    by Matthias Kuntz, Gerrit Fiol, Matthias Laemmlin, Christian Meuer, Dieter Bimberg

    Recent results on GaAs-based high-speed mode-locked quantum-dot (QD) lasers and optical amplifiers with an operation wavelength centered at 1290 nm are reviewed and their complex dependence on device and operating parameters is discussed on the basis of experimental data obtained with integrated fiber-based QD device modules. Hybrid and passive mode locking of QD lasers with repetition frequencies between 5 and 80 GHz, sub-ps pulse widths, ultralow timing jitter down to 190 fs, high output peak power beyond 1 W, and suppression of Q-switching are reported, showing the large potential of this class of devices for O-band optical fiber applications. Results on cw and dynamical characterization of QD semiconductor optical amplifiers (SOAs) are presented. QD amplifiers exhibit a close-to-ideal noise figure of 4 dB and demonstrate multiwavelength amplification of three coarse wavelength division multiplexing (CWDM) wavelengths simultaneously. Modelling of QD polarization dependence shows that it should be possible to achieve polarization insensitive SOAs using vertically coupled QD stacks. Amplification of ultrafast 80 GHz optical combs and bit-error-free data signal amplification at 40 Gb/s with QD SOAs show the potential for their application in future 100 Gb Ethernet networks.


  • Novel concepts for ultrahigh-speed quantum-dot VCSELs and edge-emitters

    by N. N. Ledentsov, F. Hopfer, A. Mutig, V. A. Shchukin, A. V. Savel'Ev, G. Fiol, M. Kuntz, V. A. Haisler, T. Warming, E. Stock, et al.

    Advanced types of QD media allow an ultrahigh modal gain, avoid temperature depletion and gain saturation effects, when used in high-speed quantum dot (QD) vertical-cavity surface-emitting lasers (VCSELs). An anti-guiding VCSEL design reduces gain depletion and radiative leakage, caused by parasitic whispering gallery VCSEL modes. Temperature robustness up to 100°C for 0.96 - 1.25 &mgr;m range devices is realized in the continuous wave (cw) regime. An open eye 20 Gb/s operation with bit error rates better than 10-12 has been achieved in a temperature range 25-85°C without current adjustment. A different approach for ultrahigh-speed operation is based on a combination of the VCSEL section, operating in the CW mode with an additional section of the device, which is electrooptically modulated under a reverse bias. The tuning of a resonance wavelength of the second section, caused by the electrooptic effect, affects the transmission of the system. The second cavity mode, resonant to the VCSEL mode, or the stopband edge of the second Bragg reflector can be used for intensity modulation. The approach enables ultrahigh speed signal modulation. 60GHz electrical and ~35GHz optical (limited by the photodetector response) bandwidths are realized.


  • High speed nanophotonic devices based on quantum dots

    by D. Bimberg, G. Fiol, M. Kuntz, C. Meuer, M. Lämmlin, N. N. Ledentsov, A. R. Kovsh


  • 20-Gb/s direct modulation of 980 nm VCSELs based on submonolayer deposition of quantum dots

    by F. Hopfer, Mutig A, G. Fiol, M. Kuntz, S. S. Mikhrin, I. L. Krestnikov, D. A. Livshits, A. R. Kovsh, C. Bornholdt, V. Shchukin, et al.

    980 nm vertical-cavity surface-emitting laser based on sub-monolayer growth of quantum dots show at 25 and 85°C for 20 Gb/s without current adjustment clearly open eyes and error free operation with bit error rates better than 10-12. For these multimode lasers the small signal modulation bandwidth decreases only from 15 GHz at 25°C to 13 GHz at 85°C. Single mode devices demonstrate at 20°C a small signal modulation bandwidth of 16.6 GHz with 0.8 mW optical output power and a record high modulation current efficiency factor of 19 GHz/mA1/2.


  • High-Speed Quantum Dot Lasers and Amplifiers for Optical Data Communication

    by M. Kuntz, G. Fiol, C. Szewc, M. Lammlin, C. Meuer, D. Bimberg, A. Kovsh, N. Ledentsov, S. Ferber, C. Schubert, et al.

    Quantum dot based 1.3, μm fiber-coupled laser and amplifier modules show 10 Gb/s and 40 Gb/s operation, respectively, with bit error rates below 10-11. Amplifier chip gain up to 26 dB has been demonstrated. Mode-locked quantum dot lasers show optical pulses with widths below 1 ps and repetition frequencies up to 80 GHz. 710 fs pulses were amplified with 10 dB net gain and without pulse broadening.


  • Quantum dot photonic devices for lightwave communication

    by Dieter Bimberg, Matthias Kuntz, Matthias Laemmlin


  • Open Access

    Direct modulation and mode locking of 1.3 μm quantum dot lasers

    by M Kuntz, G Fiol, M Lämmlin, D Bimberg, M G Thompson, K T Tan, C Marinelli, A Wonfor, R Sellin, R V Penty, et al.


  • Spectrotemporal response of 1.3 μm quantum-dot lasers

    by M. Kuntz, N. N. Ledentsov, D. Bimberg, A. R. Kovsh, V. M. Ustinov, A. E. Zhukov, Yu. M. Shernyakov

    We report the spectrotemporal measurements on 1.3 μm quantum-dot lasers with picosecond time resolution. The relaxation oscillations of the various mode groups monitored separately are identical and thus allow us to examine the spectrally integrated transient of the laser pulse for its characteristics. A modulation bandwidth of 2.3 GHz at room temperature is determined, demonstrating the potential of high-speed operation of these devices at wavelengths relevant for optical data transmission. The differential gain at room temperature was measured to be g′=1×10−15 cm2, the gain compression factor is ε=1×10−15 cm3.