Laurent Authier
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Laurent Authier has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
Cyril Cugnet
Université de Pau et des Pays de l'Adour, LCABIE, UMR-CNRS 5254, IPREM, 2 avenue Angot,64053 Pau Cedex 9,France
5 shared publicationsOlivier Zaouak
Université de Pau et des Pays de l'Adour / CNRS, Laboratoire de Chimie Analytique et Bio-Inorganique UMR 5254 IPREM, 2 avenue Angot, 64053 PAU Cedex 9, France
4 shared publicationsMartine Potin‐Gautier
Université de Pau et des Pays de l'Adour/CNRS, Laboratoire de Chimie Analytique et Bio-Inorganique UMR 5254 IPREM, 2 avenue Angot, 64053 PAU Cedex 9, France
3 shared publicationsAlain Castetbon
Université de Pau et des Pays de l'Adour/CNRS, Laboratoire de Chimie Analytique et Bio-Inorganique UMR 5254 IPREM, 2 avenue Angot, 64053 PAU Cedex 9, France
2 shared publicationsAlice René
Laboratoire Sciences Chimiques de Rennes, UMR-CNRS 6226, ENSCR, Avenue du Général Leclerc, CS 50837, 35708 Rennes Cedex 7, France
2 shared publications- Christophe Pécheyran
Institut des Sciences Analytiques et de Physico‐chimie pour l'environnement et les Matériaux IPREM UMR 5254 ‐ UPPA/CNRS Pau France
1 shared publication
Latest Publications
- 1 January 2013
- Published by Royal Society of Chemistry (RSC) in The Analyst
- Vol. 138 (7) , 2192-2198
Use of screen-printed microelectrodes working as generator/collector systems for the determination of the antioxidant capacity of phenolic compounds
A new method using cheap homemade dual-electrodes has been developed to measure the antioxidant capacity of phenolic compounds. These micro-sized electrodes are elaborated by successive screen-printing of conductive ink and insulator layers and are then used as generator/collector sensors. Cyclic voltammetry and chronoamperometry with a bipotentiostat have been used to test and characterize these sensors. The antioxidant capacity values found by this new method are compared with a classical method (using a macro-sized electrode) to demonstrate its reliability.
- 1 January 2013
- Published by Royal Society of Chemistry (RSC) in The Analyst
- Vol. 138 (7) , 2192-2198
Use of screen-printed microelectrodes working as generator/collector systems for the determination of the antioxidant capacity of phenolic compounds
A new method using cheap homemade dual-electrodes has been developed to measure the antioxidant capacity of phenolic compounds. These micro-sized electrodes are elaborated by successive screen-printing of conductive ink and insulator layers and are then used as generator/collector sensors. Cyclic voltammetry and chronoamperometry with a bipotentiostat have been used to test and characterize these sensors. The antioxidant capacity values found by this new method are compared with a classical method (using a macro-sized electrode) to demonstrate its reliability.
- 21 May 2010
- Published by Wiley in Electroanalysis
- Vol. 22 (11) , 1159-1165
Electroanalytical Device for Cadmium Speciation in Waters. Part 2: Automated System Development and Cadmium Semicontinuous Monitoring
A full‐automated electroanalytical device is presented here. It is composed of an electrochemically adapted automation module and a competitive screen‐printed sensor modified ex situ by a very low quantity of mercury. The contribution of this automated apparatus to analyses is described in detail. Coupled with an UV‐photolysis unit, it has permitted the rapid detection of both total and electrochemically accessible cadmium in solutions containing 10 mg L−1 of humic substances without addition of reagents. Semicontinuous monitoring of tap water doped with 5.3 μg L−1 of cadmium, in presence of traces of lead and copper, has been successfully achieved for 7 days.
- 21 May 2010
- Published by Wiley in Electroanalysis
- Vol. 22 (11) , 1159-1165
Electroanalytical Device for Cadmium Speciation in Waters. Part 2: Automated System Development and Cadmium Semicontinuous Monitoring
A full‐automated electroanalytical device is presented here. It is composed of an electrochemically adapted automation module and a competitive screen‐printed sensor modified ex situ by a very low quantity of mercury. The contribution of this automated apparatus to analyses is described in detail. Coupled with an UV‐photolysis unit, it has permitted the rapid detection of both total and electrochemically accessible cadmium in solutions containing 10 mg L−1 of humic substances without addition of reagents. Semicontinuous monitoring of tap water doped with 5.3 μg L−1 of cadmium, in presence of traces of lead and copper, has been successfully achieved for 7 days.
- 21 May 2010
- Published by Wiley in Electroanalysis
- Vol. 22 (11) , 1151-1158
Electroanalytical Device for Cadmium Speciation in Waters. Part 1: Development and Characterization of a Reliable Screen‐Printed Sensor
A reliable screen‐printed sensor for cadmium speciation analysis is presented here. Its development has been focused on the achievement of a reproducible and repeatable sensor. The electrode construction and its surface coating are discussed in detail. The optimized procedure has permitted to obtain very accurate sensors with detection limit of 0.2 μg (Cd) L−1 using SWASV for only 60 s of deposition time. The electrochemically accessible, i.e. potentially bioavailable, fraction of the cadmium present in an untreated river water sample has been successfully quantified without degassing. These results give a glimpse of the potential of this membrane‐free sensor in real matrices.
- 21 May 2010
- Published by Wiley in Electroanalysis
- Vol. 22 (11) , 1151-1158
Electroanalytical Device for Cadmium Speciation in Waters. Part 1: Development and Characterization of a Reliable Screen‐Printed Sensor
A reliable screen‐printed sensor for cadmium speciation analysis is presented here. Its development has been focused on the achievement of a reproducible and repeatable sensor. The electrode construction and its surface coating are discussed in detail. The optimized procedure has permitted to obtain very accurate sensors with detection limit of 0.2 μg (Cd) L−1 using SWASV for only 60 s of deposition time. The electrochemically accessible, i.e. potentially bioavailable, fraction of the cadmium present in an untreated river water sample has been successfully quantified without degassing. These results give a glimpse of the potential of this membrane‐free sensor in real matrices.
- 4 December 2009
- Published by Elsevier in Sensors and Actuators B: Chemical
- Vol. 143 (1) , 158-163
A novel microelectrode array combining screen-printing and femtosecond laser ablation technologies: Development, characterization and application to cadmium detection
- 4 December 2009
- Published by Elsevier in Sensors and Actuators B: Chemical
- Vol. 143 (1) , 158-163
A novel microelectrode array combining screen-printing and femtosecond laser ablation technologies: Development, characterization and application to cadmium detection
- 10 March 2009
- Published by Wiley in Electroanalysis
- Vol. 21 (6) , 689-695
Bismuth‐Coated Screen‐Printed Microband Electrodes for On‐Field Labile Cadmium Determination
Performances of a screen‐printed microband electrode prepared by ex situ bismuth deposition are reported. According to the low bismuth toxicity, this electrode represents an environmentally friendly alternative to mercury modified sensors, particularly for on‐field measurements. The electrochemical behaviour of the microband electrode has been studied and is in agreement with microelectrode theory before and after bismuth modification. Sensitive cadmium analysis achieved in nondeaerated and unstirred solutions leads to a detection limit of 1.3 μg L−1 using SWASV for 120 s deposition time. This sensor has been successfully applied to a nontreated river water sample.
- 10 March 2009
- Published by Wiley in Electroanalysis
- Vol. 21 (6) , 689-695
Bismuth‐Coated Screen‐Printed Microband Electrodes for On‐Field Labile Cadmium Determination
Performances of a screen‐printed microband electrode prepared by ex situ bismuth deposition are reported. According to the low bismuth toxicity, this electrode represents an environmentally friendly alternative to mercury modified sensors, particularly for on‐field measurements. The electrochemical behaviour of the microband electrode has been studied and is in agreement with microelectrode theory before and after bismuth modification. Sensitive cadmium analysis achieved in nondeaerated and unstirred solutions leads to a detection limit of 1.3 μg L−1 using SWASV for 120 s deposition time. This sensor has been successfully applied to a nontreated river water sample.