SBStuart I. Benton

Stuart I. Benton

*This is an algorithmically generated author record based on publicly available information.

Stuart I. Benton has a total of 7 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Response of a Streamwise Vortex–Wall Interaction to Unsteady Forcing

    by Stuart I. Benton, Jeffrey P. Bons

    Streamwise vortices exist in a number of engineering flows in both external and internal aerodynamics, often with undesirable effects. An experimental investigation of a streamwise vortex–wall interaction is performed through the use of a vortex-generating wing section and a suspended splitter plate. A synthetic jet actuator is implemented below the vortex, and the response of the vortex to unsteady forcing is evaluated with a focus on spatial amplification through convective instabilities. At low forcing frequencies, a large displacement of the vortex is recorded near the actuator, but with almost no spatial amplification. This behavior agrees qualitatively with transient growth studies of columnar vortices. Within a specific frequency range, it is shown that spatial amplification of the vortex displacement occurs. The range of amplified forcing frequency agrees well with predictions for the Crow instability. The vortex–wall interaction generates a secondary vortex structure that rolls up from the boundary layer. When the actuator displaces the primary vortex structure, this causes a strong dynamic reaction in the secondary structure. This occurs due to a mutual induction mechanism between the two vortices as well as a spatial oscillation of the separation point from which the secondary structure originates.


  • Steady Vortex-Generator Jet Flow Control on a Highly Loaded Transonic Low-Pressure Turbine Cascade: Effects of Compressibility and Roughness

    by Chiara Bernardini, Stuart I. Benton, John D. Lee, Jeffrey P. Bons, Jen-Ping Chen, Francesco Martelli

    A new high-speed linear cascade has been developed for low-pressure turbine (LPT) studies at The Ohio State University. A compressible LPT profile is tested in the facility and its baseline performance at different operating conditions is assessed by means of isentropic Mach number distribution and wake total pressure losses. Active flow control is implemented through a spanwise row of vortex-generator jets (VGJs) located at 60% chord on the suction surface. The purpose of the study is to document the effectiveness of VGJ flow control in high-speed compressible flow. The effect on shock-induced separation is assessed by Mach number distribution, wake loss surveys and shadowgraph. Pressure sensitive paint (PSP) is applied to understand the three dimensional flow and shock pattern developing from the interaction of the skewed jets and the main flow. Data show that with increasing blowing ratio, the losses are first decreased due to separation reduction, but losses connected to compressibility effects become stronger due to increased passage shock strength and jet orifice choking; therefore, the optimum blowing ratio is a tradeoff between these counteracting effects. The effect of added surface roughness on the uncontrolled flow and on flow control behavior is also investigated. At lower Mach number, turbulent separation develops on the rough surface and a different flow control performance is observed. Steady VGJs appear to have control authority even on a turbulent separation but higher blowing ratios are required compared to incompressible flow experiments reported elsewhere. Overall, the results show a high sensitivity of steady VGJs control performance and optimum blowing ratio to compressibility and surface roughness.


  • Parametric Optimization of Unsteady End Wall Blowing on a Highly Loaded Low-Pressure Turbine

    by Stuart I. Benton, Chiara Bernardini, Jeffrey P. Bons, Rolf Sondergaard

    Efforts to reduce blade count and avoid boundary layer separation have led to low-pressure turbine airfoils with significant increases in loading as well as front-loaded pressure distributions. These features have been independently shown to increase losses within the secondary flow field at the end wall. Compound angle blowing from discrete jets on the blade suction surface near the end wall has been shown to be effective in reducing these increased losses and enabling the efficient use of highly loaded blade designs. In this study, experiments are performed on the front loaded L2F low-pressure turbine airfoil in a linear cascade. The required mass flow is reduced by decreasing the hole count from previous configurations and from the introduction of unsteady blowing. The effects of pulsing frequency and duty cycle are investigated using phase-locked stereo particle image velocimetry to demonstrate the large scale movement and hysteresis behavior of the passage vortex interacting with the pulsed jets. Total pressure loss contours at the cascade outlet demonstrate that the efficiency benefit is maintained with the use of unsteady forcing.


  • Exploitation of Subharmonics for Separated Shear Layer Control on a High-Lift Low-Pressure Turbine Using Acoustic Forcing

    by Chiara Bernardini, Stuart I. Benton, Jen-Ping Chen, Jeffrey P. Bons

    The mechanism of separation control by sound excitation is investigated on the aft-loaded low-pressure turbine (LPT) blade profile, the L1A, which experiences a large boundary layer separation at low Reynolds numbers. Previous work by the authors has shown that on a laminar separation bubble such as that experienced by the front-loaded L2F profile, sound excitation control has its best performance at the most unstable frequency of the shear layer due to the exploitation of the linear instability mechanism. The different loading distribution on the L1A increases the distance of the separated shear layer from the wall and the exploitation of the same linear mechanism is no longer effective in these conditions. However, significant control authority is found in the range of the first subharmonic of the natural unstable frequency. The amplitude of forced excitation required for significant wake loss reduction is higher than that needed when exploiting linear instability, but unlike the latter case, no threshold amplitude is found. The fluid-dynamics mechanisms under these conditions are investigated by particle image velocimetry (PIV) measurements. Phase-locked PIV data gives insight into the growth and development of structures as they are shed from the shear layer and merge to lock into the excited frequency. Unlike near-wall laminar separation sound control, it is found that when such large separated shear layers occur, sound excitation at subharmonics of the fundamental frequency is still effective with high-Tu levels.


  • The Effect of Acoustic Excitation on Boundary Layer Separation of a Highly Loaded LPT Blade

    by Chiara Bernardini, Stuart I. Benton, Jeffrey P. Bons

    An experimental investigation of the effect of acoustic excitation on the boundary layer development of a highly loaded low-pressure turbine blade at low-Reynolds number is investigated. The aim of this work is to study the effect of excitation at select frequencies on separation which could give indications about active flow control exploitation. The front-loaded L2F blade is tested in a low-speed linear cascade. The uncontrolled flow presents a separation bubble on the suction surface at Reynolds numbers below 40,000. For these conditions, the instability of the shear layer is documented using hot-wire anemometry. A loudspeaker upstream of the cascade is directed towards the passage inlet section. A parametric study on the effect of amplitude and frequency is carried out. The effect of the excitation frequency is observed to delay separation for a range of frequencies. However, the control authority of sound is found to be most effective at the fundamental frequency of the shear layer. The amplitude of perturbation is significant in the outcome of control until a threshold value is reached. PIV measurements allow a deeper understanding of the mechanisms leading to the reduction of separation. Data has been acquired with a low inlet turbulence level (<1%) in order to provide a cleaner environment which magnifies the effects of the excitation frequency, and with an increased turbulence intensity level of 3% which is representative of more typical engine values. Integrated wake loss values are also presented to evaluate the effect on blade performance.


  • Secondary Flow Loss Reduction Through Blowing for a High-Lift Front-Loaded Low Pressure Turbine Cascade

    by Stuart I. Benton, Jeffrey P. Bons, Rolf Sondergaard

    Efforts to increase individual blade loading in the low pressure turbine have resulted in blade geometries optimized for midspan performance. Many researchers have shown that increased blade loading and a front-loaded pressure distribution each separately contribute to increased losses in the endwall region. A detailed investigation of the baseline endwall flow of the L2F profile, which is a high-lift front loaded profile, is performed. In-plane velocity vectors and total pressure loss maps are obtained in five planes oriented normal to the blade surface for three Reynolds numbers. A row of pitched and skewed jets are introduced near the endwall on the suction surface of the blade. The flow control method is evaluated for four momentum coefficients at the high Reynolds number, with a maximum reduction of 42% in the area averaged total pressure loss coefficient. The same blade is also fitted with midspan vortex-generator jets and is tested at a Reynolds number of 20,000, resulting in a 21% reduction in the area averaged total pressure loss.