Chiara Bernardini
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Chiara Bernardini has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
- Jeffrey P. Bons
Aerospace Research Center, Department of Mechanical and Aerospace Engineering, The Ohio State University, Columbus, OH 43235
4 shared publications - Stuart I. Benton
Graduate Fellow
4 shared publications Jeffrey P. Bons
Ohio State University
3 shared publications- Jen-Ping Chen
Department of Atmospheric Sciences National Taiwan University Taipei Taiwan
3 shared publications - Francesco Martelli
Department of Industrial Engineering (DIEF), Università degli Studi di Firenze, Via di Santa Marta, 3, 50139 Firenze, Italy
2 shared publications - Guillermo Paniagua
Zucrow Laboratories, Purdue University, 500 Allison Road, West Lafayette, IN 47907, USA
2 shared publications
Latest Publications
- 26 August 2014
- Published by Wiley in Journal of Turbomachinery
- Vol. 136 (11) , 111003
Steady Vortex-Generator Jet Flow Control on a Highly Loaded Transonic Low-Pressure Turbine Cascade: Effects of Compressibility and Roughness
A new high-speed linear cascade has been developed for low-pressure turbine (LPT) studies at The Ohio State University. A compressible LPT profile is tested in the facility and its baseline performance at different operating conditions is assessed by means of isentropic Mach number distribution and wake total pressure losses. Active flow control is implemented through a spanwise row of vortex-generator jets (VGJs) located at 60% chord on the suction surface. The purpose of the study is to document the effectiveness of VGJ flow control in high-speed compressible flow. The effect on shock-induced separation is assessed by Mach number distribution, wake loss surveys and shadowgraph. Pressure sensitive paint (PSP) is applied to understand the three dimensional flow and shock pattern developing from the interaction of the skewed jets and the main flow. Data show that with increasing blowing ratio, the losses are first decreased due to separation reduction, but losses connected to compressibility effects become stronger due to increased passage shock strength and jet orifice choking; therefore, the optimum blowing ratio is a tradeoff between these counteracting effects. The effect of added surface roughness on the uncontrolled flow and on flow control behavior is also investigated. At lower Mach number, turbulent separation develops on the rough surface and a different flow control performance is observed. Steady VGJs appear to have control authority even on a turbulent separation but higher blowing ratios are required compared to incompressible flow experiments reported elsewhere. Overall, the results show a high sensitivity of steady VGJs control performance and optimum blowing ratio to compressibility and surface roughness.
- 26 August 2014
- Published by Wiley in Journal of Turbomachinery
- Vol. 136 (11) , 111003
Steady Vortex-Generator Jet Flow Control on a Highly Loaded Transonic Low-Pressure Turbine Cascade: Effects of Compressibility and Roughness
A new high-speed linear cascade has been developed for low-pressure turbine (LPT) studies at The Ohio State University. A compressible LPT profile is tested in the facility and its baseline performance at different operating conditions is assessed by means of isentropic Mach number distribution and wake total pressure losses. Active flow control is implemented through a spanwise row of vortex-generator jets (VGJs) located at 60% chord on the suction surface. The purpose of the study is to document the effectiveness of VGJ flow control in high-speed compressible flow. The effect on shock-induced separation is assessed by Mach number distribution, wake loss surveys and shadowgraph. Pressure sensitive paint (PSP) is applied to understand the three dimensional flow and shock pattern developing from the interaction of the skewed jets and the main flow. Data show that with increasing blowing ratio, the losses are first decreased due to separation reduction, but losses connected to compressibility effects become stronger due to increased passage shock strength and jet orifice choking; therefore, the optimum blowing ratio is a tradeoff between these counteracting effects. The effect of added surface roughness on the uncontrolled flow and on flow control behavior is also investigated. At lower Mach number, turbulent separation develops on the rough surface and a different flow control performance is observed. Steady VGJs appear to have control authority even on a turbulent separation but higher blowing ratios are required compared to incompressible flow experiments reported elsewhere. Overall, the results show a high sensitivity of steady VGJs control performance and optimum blowing ratio to compressibility and surface roughness.
- 2 January 2014
- Published by Wiley in Journal of Turbomachinery
- Vol. 136 (7) , 071013
Parametric Optimization of Unsteady End Wall Blowing on a Highly Loaded Low-Pressure Turbine
Efforts to reduce blade count and avoid boundary layer separation have led to low-pressure turbine airfoils with significant increases in loading as well as front-loaded pressure distributions. These features have been independently shown to increase losses within the secondary flow field at the end wall. Compound angle blowing from discrete jets on the blade suction surface near the end wall has been shown to be effective in reducing these increased losses and enabling the efficient use of highly loaded blade designs. In this study, experiments are performed on the front loaded L2F low-pressure turbine airfoil in a linear cascade. The required mass flow is reduced by decreasing the hole count from previous configurations and from the introduction of unsteady blowing. The effects of pulsing frequency and duty cycle are investigated using phase-locked stereo particle image velocimetry to demonstrate the large scale movement and hysteresis behavior of the passage vortex interacting with the pulsed jets. Total pressure loss contours at the cascade outlet demonstrate that the efficiency benefit is maintained with the use of unsteady forcing.
- 2 January 2014
- Published by Wiley in Journal of Turbomachinery
- Vol. 136 (7) , 071013
Parametric Optimization of Unsteady End Wall Blowing on a Highly Loaded Low-Pressure Turbine
Efforts to reduce blade count and avoid boundary layer separation have led to low-pressure turbine airfoils with significant increases in loading as well as front-loaded pressure distributions. These features have been independently shown to increase losses within the secondary flow field at the end wall. Compound angle blowing from discrete jets on the blade suction surface near the end wall has been shown to be effective in reducing these increased losses and enabling the efficient use of highly loaded blade designs. In this study, experiments are performed on the front loaded L2F low-pressure turbine airfoil in a linear cascade. The required mass flow is reduced by decreasing the hole count from previous configurations and from the introduction of unsteady blowing. The effects of pulsing frequency and duty cycle are investigated using phase-locked stereo particle image velocimetry to demonstrate the large scale movement and hysteresis behavior of the passage vortex interacting with the pulsed jets. Total pressure loss contours at the cascade outlet demonstrate that the efficiency benefit is maintained with the use of unsteady forcing.
- 1 January 2014
- Published by American Institute of Aeronautics and Astronautics (AIAA) in AIAA Journal
- Vol. 52 (1) , 104-115
Pulsed Jets Laminar Separation Control Using Instability Exploitation
- 1 January 2014
- Published by American Institute of Aeronautics and Astronautics (AIAA) in AIAA Journal
- Vol. 52 (1) , 104-115
Pulsed Jets Laminar Separation Control Using Instability Exploitation
- 24 October 2013
- Published by Wiley in Journal of Turbomachinery
- Vol. 136 (5) , 051018
Exploitation of Subharmonics for Separated Shear Layer Control on a High-Lift Low-Pressure Turbine Using Acoustic Forcing
The mechanism of separation control by sound excitation is investigated on the aft-loaded low-pressure turbine (LPT) blade profile, the L1A, which experiences a large boundary layer separation at low Reynolds numbers. Previous work by the authors has shown that on a laminar separation bubble such as that experienced by the front-loaded L2F profile, sound excitation control has its best performance at the most unstable frequency of the shear layer due to the exploitation of the linear instability mechanism. The different loading distribution on the L1A increases the distance of the separated shear layer from the wall and the exploitation of the same linear mechanism is no longer effective in these conditions. However, significant control authority is found in the range of the first subharmonic of the natural unstable frequency. The amplitude of forced excitation required for significant wake loss reduction is higher than that needed when exploiting linear instability, but unlike the latter case, no threshold amplitude is found. The fluid-dynamics mechanisms under these conditions are investigated by particle image velocimetry (PIV) measurements. Phase-locked PIV data gives insight into the growth and development of structures as they are shed from the shear layer and merge to lock into the excited frequency. Unlike near-wall laminar separation sound control, it is found that when such large separated shear layers occur, sound excitation at subharmonics of the fundamental frequency is still effective with high-Tu levels.
- 24 October 2013
- Published by Wiley in Journal of Turbomachinery
- Vol. 136 (5) , 051018
Exploitation of Subharmonics for Separated Shear Layer Control on a High-Lift Low-Pressure Turbine Using Acoustic Forcing
The mechanism of separation control by sound excitation is investigated on the aft-loaded low-pressure turbine (LPT) blade profile, the L1A, which experiences a large boundary layer separation at low Reynolds numbers. Previous work by the authors has shown that on a laminar separation bubble such as that experienced by the front-loaded L2F profile, sound excitation control has its best performance at the most unstable frequency of the shear layer due to the exploitation of the linear instability mechanism. The different loading distribution on the L1A increases the distance of the separated shear layer from the wall and the exploitation of the same linear mechanism is no longer effective in these conditions. However, significant control authority is found in the range of the first subharmonic of the natural unstable frequency. The amplitude of forced excitation required for significant wake loss reduction is higher than that needed when exploiting linear instability, but unlike the latter case, no threshold amplitude is found. The fluid-dynamics mechanisms under these conditions are investigated by particle image velocimetry (PIV) measurements. Phase-locked PIV data gives insight into the growth and development of structures as they are shed from the shear layer and merge to lock into the excited frequency. Unlike near-wall laminar separation sound control, it is found that when such large separated shear layers occur, sound excitation at subharmonics of the fundamental frequency is still effective with high-Tu levels.
- 24 June 2013
- Published by Wiley in Journal of Turbomachinery
- Vol. 135 (5) , 051001
The Effect of Acoustic Excitation on Boundary Layer Separation of a Highly Loaded LPT Blade
An experimental investigation of the effect of acoustic excitation on the boundary layer development of a highly loaded low-pressure turbine blade at low-Reynolds number is investigated. The aim of this work is to study the effect of excitation at select frequencies on separation which could give indications about active flow control exploitation. The front-loaded L2F blade is tested in a low-speed linear cascade. The uncontrolled flow presents a separation bubble on the suction surface at Reynolds numbers below 40,000. For these conditions, the instability of the shear layer is documented using hot-wire anemometry. A loudspeaker upstream of the cascade is directed towards the passage inlet section. A parametric study on the effect of amplitude and frequency is carried out. The effect of the excitation frequency is observed to delay separation for a range of frequencies. However, the control authority of sound is found to be most effective at the fundamental frequency of the shear layer. The amplitude of perturbation is significant in the outcome of control until a threshold value is reached. PIV measurements allow a deeper understanding of the mechanisms leading to the reduction of separation. Data has been acquired with a low inlet turbulence level (<1%) in order to provide a cleaner environment which magnifies the effects of the excitation frequency, and with an increased turbulence intensity level of 3% which is representative of more typical engine values. Integrated wake loss values are also presented to evaluate the effect on blade performance.
- 24 June 2013
- Published by Wiley in Journal of Turbomachinery
- Vol. 135 (5) , 051001
The Effect of Acoustic Excitation on Boundary Layer Separation of a Highly Loaded LPT Blade
An experimental investigation of the effect of acoustic excitation on the boundary layer development of a highly loaded low-pressure turbine blade at low-Reynolds number is investigated. The aim of this work is to study the effect of excitation at select frequencies on separation which could give indications about active flow control exploitation. The front-loaded L2F blade is tested in a low-speed linear cascade. The uncontrolled flow presents a separation bubble on the suction surface at Reynolds numbers below 40,000. For these conditions, the instability of the shear layer is documented using hot-wire anemometry. A loudspeaker upstream of the cascade is directed towards the passage inlet section. A parametric study on the effect of amplitude and frequency is carried out. The effect of the excitation frequency is observed to delay separation for a range of frequencies. However, the control authority of sound is found to be most effective at the fundamental frequency of the shear layer. The amplitude of perturbation is significant in the outcome of control until a threshold value is reached. PIV measurements allow a deeper understanding of the mechanisms leading to the reduction of separation. Data has been acquired with a low inlet turbulence level (<1%) in order to provide a cleaner environment which magnifies the effects of the excitation frequency, and with an increased turbulence intensity level of 3% which is representative of more typical engine values. Integrated wake loss values are also presented to evaluate the effect on blade performance.
- 1 January 2013
- Published by Taylor & Francis in Engineering Applications of Computational Fluid Mechanics
- Vol. 7 (2) , 250-260
Pulsating Coolant Ejection Effects Downstream of Supersonic Trailing Edge
- 1 January 2013
- Published by Taylor & Francis in Engineering Applications of Computational Fluid Mechanics
- Vol. 7 (2) , 250-260
Pulsating Coolant Ejection Effects Downstream of Supersonic Trailing Edge
- 7 September 2012
- Published by Springer Nature in Journal of Thermal Science
- Vol. 21 (5) , 404-412
Turbine blade boundary layer separation suppression via synthetic jet: An experimental and numerical study
- 7 September 2012
- Published by Springer Nature in Journal of Thermal Science
- Vol. 21 (5) , 404-412
Turbine blade boundary layer separation suppression via synthetic jet: An experimental and numerical study