DVDenis V. Vagin

Denis V. Vagin

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Denis V. Vagin has a total of 67 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • 3D frequency-domain geoelectromagnetic modeling with a primary-secondary field approach

    by Yuri G. Soloveichik, Marina G. Persova, Denis V. Vagin, Yulia I. Koshkina

  • Pulse breakdown of water: bubble model

    by Sergey M Korobeynikov, Denis V Vagin, Yulia Kuznetsova

    This paper discusses experimental data and simple mathematical models of pulsed breakdown of water. This is essential for pulsed high-power energy science. The proposed model is based on the assumption that during discharge from the anode, the emission of charge carriers does not occur until the pre-breakdown values of the electric field strength is reached. During discharge initiation from the cathode, electron emission occurs in a comparatively weak field. The resulting space charge near the electrode causes negative pressure, cavitation, gas diffusion into the bubble and a partial discharge within it, culminating in the formation of a subsonic cathode streamer. When calculating the electric field strength near the usually assumed micropoints, the dipole saturation effect is taken into account, causing an abnormal increase in the electric field strength at the micropoint in the case of discharge ignition from the anode. This again leads to bubble formation, a partial discharge in it, which leads to the initiation of the anode streamer. The bubble model of pulsed discharge ignition in water explains all the widely known dependencies of pulsed electrical strength on external and internal factors (pulse duration, pressure, temperature, dielectric permittivity, viscosity). The polarity effect is also explained within the model.

  • Comparative analysis of computational schemes for FEM modeling of 3D time-domain geoelectromagnetic fields excited by a horizontal grounded-wire source

    by Yuri G. Soloveichik, Marina G. Persova, Denis V. Vagin, Anastasia P. Sivenkova, Dmitry S. Kiselev, Yulia I. Koshkina


  • Simulation of Electrooptical Measurements of Prebreakdown Electric Fields in Polar Liquids Near Cathode Streamer

    by Vladimir B. Yassinskiy, Yulia A. Kuznetsova, Sergey M. Korobeynikov, Denis V. Vagin, Alexander V. Ridel

    This article is devoted to the analysis of electrooptical studies of the prebreakdown stage in water and nitrobenzene in the submicrosecond range and the modeling of these processes. Computer simulation showed that in water at an unchanged permittivity $\varepsilon$ $=$ 80, the field strength at the head of the cathode streamer did not exceed $E$ $=$ $2$ mV/cm. Considering the nonlinearity of the permittivity $\varepsilon$ $=$ $\varepsilon(E)$ made it possible to estimate the strength of the same field as $E$ $=$ 2.4–3.1 mV/cm. These values are close to the estimate of the dipole saturation strength in water ( $E_{S}$ $=$ $3$ mV/cm), and consideration of saturation does not lead to a sharp increase in the field. It should be emphasized that, in the case of an anode streamer, the calculated field strength was much larger than $E_{S}$ , which led to an anomalous increase in the field strength when the nonlinearity was taken into account. An electrooptical experiment in nitrobenzene was also analyzed. It was computed that the value of the field strength in front of the head of the moving cathode streamer is 2.7 mV/cm. Taking into account the possible saturation of dipoles leads to an $E_{\mathrm{S}}$ of $\sim$ 4 mV/cm. The closeness of the obtained values in water and nitrobenzene indicates the similarity of the mechanisms of formation of slow cathode streamers in various liquids.


  • The Breakdown Voltage of Moistened Mineral Oil During Its Cooling

    by Marina N. Lyutikova, Sergey M. Korobeynikov, Alexander V. Ridel, Denis V. Vagin, Alexander A. Konovalov

    In high voltage oil-filled equipment, mineral insulating oil has two main functions - to remove heat from heated parts and to insulate conductors. Regardless of the temperature, transformer oil must always provide reliable insulation of high-voltage equipment elements. The primary indicator characterizing the electrical insulating properties of mineral oil is its electrical strength. This work presents the results of the study, which reflect the change in the value of the breakdown voltage of the oil during its cooling from + 60 °C to -20 °C. Modeling shows that when the cell is cooled, together with its contents, conditions are realized on the electrodes for the predominant formation of water in the form of drops or ice particles. Such an experiment and simulation shows the processes occurring in the insulation of a power transformer during its forced commissioning and decommissioning at negative temperatures. Experimental data on the nature of changes in the breakdown voltage of a liquid dielectric depending on the cooling method and the degree of oil oxidation are presented. Ice crystals form in the oil as it cools, the shape of which is different. It was found that in the process of oil cooling in the interelectrode gap, an “ice cloud” or “ice bridge” is formed. During thawing, emulsion water is formed from ice inclusions, which are concentrated on the electrodes of the measuring cell. It was experimentally determined that under high voltage action in small gaps of the measuring cell, water droplets are drawn out, forming a "water bridge" between the electrodes.


  • Simulation of Electrooptical Measurements of Prebreakdown Electric Fields in Water—Part I: Electric Field Near Anode Streamer

    by V. B. Yassinskiy, Yu. A. Kuznetsova, S. M. Korobeynikov, D. V. Vagin

    The analysis of the results of electrooptical measurements using the Kerr effect at the prebreakdown stage of an electric discharge in water made it possible to estimate the intensity of the inception field of the anode streamer. The electric field strength and phase difference distribution were constructed using computer simulation in the point-to-plane system near the anode tip. The conditions of an actual experiment are simulated. It turned out that taking into account the nonlinearity of the relative permittivity and saturation of polarization leads to a sharp increase in the field strength in a narrow region near the needle tip and compression of both the strong field region and compression of Kerr fringes. Taking these factors into account made it possible to explain the unusual shape of the chronogram and to estimate the field strength of the appearance of the anode streamer as E~40-50 MV/cm.


  • Open Access

    Simulation of electrooptical measurements of prebreakdown electric fields in water. Part 2. Electric field near cathode streamer

    by Vladimir Yassinskiy, Yulia Kuznetsova, Sergey Korobeynikov, Denis Vagin

    In this paper, we continue the analysis of electrooptical studies of the prebreakdown stage in water in the submicrosecond range. We consider a cathode streamer developing in a system of the spherical electrodes. Computer simulation of electric showed that at a constant e = 80, the field strength at the head of the cathode streamer should not exceed E = 1.9 MV/cm. Taking into account the nonlinearity of the permittivity e = e(E) made it possible to estimate this field strength as E ~ 2.4-3.1 MV/cm. It is shown that even with some excess of the strength over the threshold value (ES ~ 3 MV/cm), at which the state of dipole saturation is possible; its consideration does not lead to a noticeable change in the result. Thus, a significant decrease in the field strength near the cathode streamer compared to the anode streamer was confirmed.

  • Open Access

    Simulation of electrooptical measurements of prebreakdown electric fields in water. Part1

    by Vladimir Yassinskiy, Yulia Kuznetsova, Sergey Korobeynikov, Denis Vagin

    The paper deals with the processing and analysis of the results of electro-optical studies of the pre-breakdown stage of an electric discharge in water using the Kerr effect. For this, the first chronogram was selected, obtained in the process of electro-optical chronographic research of water breakdown. In this work, it was possible to explain not only the features of the chronogram but also to obtain an estimate of the intensity of the appearance of the anode streamer in water E ~ 40-50 MV/cm. Using the method of computer simulation in the point-plane system near the anode point, the distributions of the electric field strength and the phase difference were constructed. The calculations were carried out both at a constant relative permittivity and its nonlinear dependence on the electric field strength. It turned out that dipole saturation is observed near the tip. As a result, the Kerr bands become denser and, at a spatial resolution of the recording equipment of 30 μm, in the pre-measuring zone, they are not recorded on the chronogram.

  • A method of FE modeling multiphase compressible flow in hydrocarbon reservoirs

    by Yuri G. Soloveichik, Marina G. Persova, Alexander M. Grif, Anastasia S. Ovchinnikova, Ilya I. Patrushev, Denis V. Vagin, Dmitry S. Kiselev


  • Resolution Analysis of Airborne Electromagnetic Survey Using Helicopter Platform and UAV

    by Marina G. Persova, Yury G. Soloveichik, Denis V. Vagin, Dmitry S. Kiselev, Anastasia P. Sivenkova, Evgenia I. Simon

    The paper considers the possibilities of time-domain airborne electromagnetic exploration technologies using both standard helicopter platforms and unmanned aerial vehicles with a source in the form of a long grounded electrical line when prospecting ore deposits. The analysis is carried out using finite element modeling programs and the results of field experiments, which made it possible to obtain the noise level. A geoelectric model obtained as a result of processing data from airborne electromagnetic prospecting in the Ural region is considered. The influence of the tilt of the target object and its position relative to the transmitter line are analyzed. The simulation takes into account topography, the curved surface of the target, and heterogeneities in the overburden layers. Numerical modeling makes it possible to clarify the noise level of the measuring equipment and establish the requirements for the minimum measurement accuracy for solving electromagnetic exploration problems of the class under consideration. Computational experiments have shown that when searching for ore objects lying at depths of up to 200 m, both technologies make it possible to recover the location and shape of the target objects in plan and in depth.