SHSang-Woo Han

Sang-Woo Han

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Sang-Woo Han has a total of 53 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Leakage Current and Breakdown Characteristics of Isolation in Gallium Nitride Lateral Power Devices

    by Mansura Sadek, Sang-Woo Han, Anusmita Chakravorty, Jesse T. Kemmerling, Rian Guan, Jianan Song, Yixin Xiong, James Lundh, Karl D. Hobart, Travis J. Anderson, et al.

    In gallium nitride (GaN) lateral power devices with advanced E-field management, isolation becomes a bottleneck for achieving higher breakdown voltage (BV). To understand the physical mechanism of isolation, the experimental analysis of isolation structures is done in this work. This article presents the measured leakage current and breakdown characteristics of isolation structures, compatible with lateral devices. For unimplanted isolation structures, leakage is injection barrier limited and breakdown is by surface punchthrough. BV has a quadratic dependence on the isolation length. Ion implantation introduces trap-limited hopping conduction, marked by the exponentially field-dependent conductance. After implantation, despite an increase in leakage current, BV increases drastically. The dependence of BV on isolation length changes from quadratic in unimplanted isolation to linear in implanted one due to flattening of E-field. To achieve high BV in GaN lateral power devices, the implanted isolation structure is preferred at the cost of high isolation leakage.


  • GaN Super-Heterojunction FETs With 10-kV Blocking and 3-kV Dynamic Switching

    by Jesse T. Kemmerling, Rian Guan, Mansura Sadek, Yixin Xiong, Jianan Song, Sang-Woo Han, Sundar Isukapati, Woongje Sung, Rongming Chu

    This article reports on two generations of GaN-on-sapphire super-heterojunction (SHJ) transistors, aiming at the realization of 10-kV class power transistors with low static and dynamic ON-resistance. First generation (Gen. 1) GaN SHJ-FETs used a single 2-D electron gas (2DEG) channel design with Schottky gate. Experimental results indicated the feasibility of achieving 10-kV blocking, however, room for improvement to reduce static source-to-drain ON-resistance ${R}_{\text {DS},\text {ON}}$ and dynamic ${R}_{\text {DS},\text {ON}}$ degradation. A second generation (Gen. 2) SHJ-MOSFET was designed using an epitaxy with two 2DEG channels for larger ON-state drain current and smaller ${R}_{\text {DS},\text {ON}}$ . The high-voltage capability and dynamic ${R}_{\text {DS},\text {ON}}$ degradation mitigation were reached by implementing the GaN SHJ design, while simultaneously avoiding surface trapping between the gate and the SHJ structure. Gen. 2 experimentally showed scaling of blocking voltage with SHJ length up to 10 kV, reduced static ${R}_{\text {DS},\text {ON}}$ of $71.4~\Omega \cdot $ mm (73.5 $\text{m}\Omega \cdot $ cm $^{{2}}{)}$ , low ${R}_{\text {DS,ON}}{C}_{\mathrm {O(}\mathrm {tr})}$ of ~4.9 ps, and controlled current collapse of 123% when switched from an OFF-state bias of 3 kV.


  • Impact of Charge Balance on Static and Dynamic Characteristics of GaN Super-Heterojunction Schottky Barrier Diodes

    by Jesse T. Kemmerling, Rian Guan, Mansura Sadek, Sundar Isukapati, Woongje Sung, Sang-Woo Han, Rongming Chu

    This letter reports the first controlled experimental study on the impact of charge-balance on static and dynamic characteristics of GaN super-heterojunction Schottky barrier diodes (SHJ-SBD). Charge balance between p- and n-type doped GaN for reducing peak E-field can be optimized via charge-balance etching (CBE) of the p-GaN SHJ region to improve dynamic ${R}_{\textit {ON}}$ degradation and breakdown voltage (BV). Three CBE conditions were fabricated with the same process on a single epitaxial wafer to mitigate process dependent variation. Charge-balance varied from donor-rich (thinner p-GaN) to near-optimum charge-balance condition, which enabled excellent dynamic ${R}_{\textit {ON}}$ degradation of 16.9% at 3 kV and BV greater than 10 kV without field plate. TCAD simulation reinforces understanding showing CBE effect on E-Field redistribution and reduced peak E-field.


  • High-Temperature Static and Dynamic Characteristics of 4.2-kV GaN Super-Heterojunction p-n Diodes

    by Mansura Sadek, Sang-Woo Han, Jianan Song, James C. Gallagher, Travis J. Anderson, Rongming Chu

    This article presents the static and dynamic characterization of 4.2-kV super-junction p-n diodes at high temperatures. Reduction of the forward current with increasing temperature is consistent with 2DEG mobility degradation caused by polar optical phonon scattering. Reverse leakage current was dominated by isolation leakage, with an activation energy of ~0.26 eV, close to the reported activation energy of surface leakage. Dynamic switching characterization in the temperature range from room temperature (RT) to 300 °C showed a nonmonotonic dependence of dynamic ON-resistance on temperature. At room temperature and 50 °C, devices showed zero current collapse (CC) up to OFF-state stress bias of 3 kV at 100 $\mu \text{s}$ timescale. Between 100 °C and 200 °C, significant CC was observed. From 250 °C to 300 °C, devices showed recovery from the severe CC. The degradation and recovery of dynamic ON-resistance can be explained by emission and recapture of holes during the OFF- and ON-states, respectively.


  • Analysis of Thermal Characteristics of AlGaN/GaN Heterostructure Field-Effect Transistors Using Micro-Raman Spectroscopy

    by Jengsu Yoo, Soo-Kyung Chang, Gunwoo Jung, Kyuheon Kim, Tae-Soo Kim, Jung-Hoon Song, Ho-Young Cha, Sang-Woo Han

    We investigated the heat dissipation in heterostructure field-effect transistors (HFETs) using microRaman measurement of the temperature in active AIGaN/GaN. By varying the gate structure, the heat dissipation through the gate was clearly revealed. The temperature increased to 120 °C at the flat gate device although the inserted gate increased to only 37 °C. Our results showed that the inserted gate structure reduced the self-heating effect by three times compared to the flat gate structure. Temperature mapping using micro-Raman measurement confirmed that the temperature of the near gate area was lower than that of the near drain area. This indicated that the inserted gate electrode structure effectively prohibited self-heating effects.


  • 12.5 kV GaN Super-Heterojunction Schottky Barrier Diodes

    by Sang-Woo Han, Jianan Song, Mansura Sadek, Alex Molina, Mona A. Ebrish, Suzanne E. Mohney, Travis J. Anderson, Rongming Chu

    This article reports GaN super-heterojunction Schottky barrier diodes (SHJ-SBDs) with substantially improved performance. Metal-2DEG sidewall n-ohmic contacts were deployed to achieve low contact resistance of $0.75~\Omega ~ \cdot ~mm$ , avoiding the risk of abnormally high contact resistance caused by inaccurate etch depth control. A pGaN notch formed near the cathode successfully eliminated excessive hole conduction caused by the sidewall n-ohmic contact. Isolation was improved by a high-energy Al implantation step. The resulting SHJ-SBD exhibited a breakdown voltage (BV) of ~12.5 kV and a specific resistance of 100.8 $\text{m}\Omega ~ \cdot ~cm^{2}$ .


  • Study of interface trap density of AlOxNy/GaN MOS structures

    by Jianan Song, Sang-Woo Han, Haoting Luo, Jaime Rumsey, Jacob H. Leach, Rongming Chu

    GaN metal–oxide–semiconductor structures were fabricated by atomic layer deposition of aluminum oxynitride thin films on bulk GaN substrates with c-, a-, and m-plane surfaces. Capacitance–voltage measurements ranging from 5 kHz to 1 MHz were conducted at room temperature. The interface trap number density (Nit) and interface trap level density (Dit) of the devices were extracted. A Nit of less than 2 × 1011 cm−2 and a Dit of less than 2 × 1011 cm−2 eV−1 were obtained on the a-plane and m-plane samples. Nit and Dit values were larger for c-plane samples, with the largest interface trap density observed on the c-plane sample with the highest dislocation density. The different Nit and Dit values can be attributed to different dislocation densities and dangling bond densities among different samples.


  • Experimental Demonstration of Charge- Balanced GaN Super-Heterojunction Schottky Barrier Diode Capable of 2.8 kV Switching

    by Sang-Woo Han, Jianan Song, Sang Ha Yoo, Ziguang Ma, Robert M. Lavelle, David W. Snyder, Joan M. Redwing, Thomas N. Jackson, Rongming Chu

    This letter reports an experimental demonstration of charge-balanced GaN super-heterojunction Schottky barrier diodes (SHJ-SBDs). Charge balance between the n-type delta-doping and the p-type doping was achieved by adjusting the thickness of the pGaN. This device structure enabled scaling of breakdown voltage to over 3 kV, and dynamic switching up to 2.8 kV without using any field-plate.


  • Open Access

    Electrical Properties of Horizontal Array Capacitor Using Composite Organic Dielectric Layer of Impregnated Glass-Fiber Epoxy

    by Hwa-Sun Park, Young-Il Na, Sang-Min Lee, Su-Jeong Suh, Yong-Soo Oh, Joon-Kyun Lee, Sang Gweon Kim, Sang-Woo Han, Ho-Young Cha, Jung-Rag Yoon

    We introduce a horizontal array capacitor with nine capacitances in a single body using an organic dielectric layer impregnated with glass fiber as a prepreg sheet. An organic solid horizontal array capacitor with a dielectric of prepreg materials of the epoxy type can implement the nine capacitances in a single body via a unique simple lamination and cutting process. We then investigate the basic electrical properties of a horizontal array capacitor. The organic solid array capacitors with five electrodes and four dielectrics are Cu/PPG layer/Cu/PPG layer/Cu/PPG layer/Cu/PPG layer/Cu with a horizontal array structure. The size of a completed array capacitor is 2.85 × 2.85 mm. The height of the fabricated array capacitor in the vertical direction is 0.5 mm, with nine capacitances possessing a series-type structure. The average capacitance value of C1, C2, C3, and C4 is 1.98 nF, and each tolerance has a value within 1% based on the average value. The temperature change rate in the capacitance maintains a nearly linear characteristic, but the rate of change tends to increase finely from 120°C or more. The capacitance values of C5, C6, and C7 with the parallel circuit were measured according to the voltage. Impedance and ESR (equivalent series resistor) of C1 were measured according to frequency and temperature.

  • Normally-Off GaN-on-Si MISFET Using PECVD SiON Gate Dielectric

    by Hyun-Seop Kim, Sang-Woo Han, Won-Ho Jang, Chun-Hyung Cho, Kwang-Seok Seo, Jungwoo Oh, Ho-Young Cha

    We have developed a silicon oxynitride (SiON) deposition process using a plasma-enhanced chemical vapor deposition system for the gate dielectric of GaN-on-Si metal-insulator-semiconductor field-effect transistors (MISFETs). The optimized SiON film had a relative dielectric constant of 5.3 and a breakdown field of 12 MV/cm. A normally-off GaN-on-Si MISFET fabricated with a 33-nm SiON gate dielectric exhibited a threshold voltage of ~2 V, an ON-resistance of 7.85 mQ · cm 2 , and a breakdown voltage of ~640 V at the OFF-state current density of 1 μA/mm. The extracted interface trap density was 1 × 10 12 cm -2 · eV -1 at E c - E t = 0.442 eV, which resulted in negligible hysteresis and excellent dynamic characteristics.