Alessandro Palmieri
Research Subjects
Alessandro Palmieri has a total of 37 co-authors. Here are the top co-authors by number of shared publications:
- William Earl Mustain
Department of Chemical Engineering University of South Carolina Columbia South Carolina USA
3 shared publications - Michael Thompson Pettes
Center for Integrated Nanotechnologies Materials Physics and Applications Division Los Alamos National Laboratory Los Alamos NM 87545 USA
2 shared publications - Sajad Yazdani
Shiraz University of Technology,Electrical and Electronics Department,Shiraz,Iran
2 shared publications - Stavros Karakalos
Department of Chemical Engineering, University of South Carolina, Columbia, South Carolina 29208, United States
2 shared publications - Alexandra M. Oliveira
Department of Chemical and Biomolecular Engineering, University of Connecticut, Storrs, CT 06269, USA
1 shared publication - Amedeo Grimaldi
Politecnico di Milano
1 shared publication
Latest Publications
- Open Access
- 27 July 2026
- Published by American Chemical Society (ACS) in ChemRxiv
Tuning graphene oxide performance across diverse applications by oxidation-extent fractionation of a single batch
Graphene oxide (GO) produced by Hummers-type methods comprises sheets with varying degrees of oxidation, yet most studies treat GO as being uniform. Here, we fractionate GO via emulsion-based partitioning, with highly oxidized sheets remaining in the aqueous phase (GOw) and less-oxidized sheets stabilizing the oil/water interface (GOe). The resulting fractions exhibit different properties across five tested domains. Contact angles range from 63°(GOw) to 92°(GOee). GOw films transmit 90.2% at 550 nm versus 84.1% for GOee, and microwave reduction decreases GOw transmittance about four times as much as the less-oxidized GOee fraction (4.34% vs 1.07%). PEG-conjugated GOew maintained A549 cell viability above 80% at all dilutions, while GOw and unfractionated GO remained non-cytotoxic at the lower concentrations. GOe-PEG reduced viability at most dilutions. In PVAc composites at 1 wt%, the most-oxidized fraction GOw gave the largest modulus increase (34%), while unfractionated GO and the less-oxidized GOe gave smaller increases that were not statistically separable from each other. In lithium-ion half-cells, GOwww delivers 270 mAh/g at cycle 50, compared with 61 mAh/g for GOeee. Across the fractions generated from a single batch, four of the five property rankings
- 27 July 2026
- Published by American Chemical Society (ACS) in ChemRxiv
Open AccessTuning graphene oxide performance across diverse applications by oxidation-extent fractionation of a single batch
Graphene oxide (GO) produced by Hummers-type methods comprises sheets with varying degrees of oxidation, yet most studies treat GO as being uniform. Here, we fractionate GO via emulsion-based partitioning, with highly oxidized sheets remaining in the aqueous phase (GOw) and less-oxidized sheets stabilizing the oil/water interface (GOe). The resulting fractions exhibit different properties across five tested domains. Contact angles range from 63°(GOw) to 92°(GOee). GOw films transmit 90.2% at 550 nm versus 84.1% for GOee, and microwave reduction decreases GOw transmittance about four times as much as the less-oxidized GOee fraction (4.34% vs 1.07%). PEG-conjugated GOew maintained A549 cell viability above 80% at all dilutions, while GOw and unfractionated GO remained non-cytotoxic at the lower concentrations. GOe-PEG reduced viability at most dilutions. In PVAc composites at 1 wt%, the most-oxidized fraction GOw gave the largest modulus increase (34%), while unfractionated GO and the less-oxidized GOe gave smaller increases that were not statistically separable from each other. In lithium-ion half-cells, GOwww delivers 270 mAh/g at cycle 50, compared with 61 mAh/g for GOeee. Across the fractions generated from a single batch, four of the five property rankings
- Open Access
- 19 September 2024
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 95, 1299-1315
Experimental investigation on the effect of channel geometry on performance heterogeneity in hydrogen PEM fuel cell
- 19 September 2024
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 95, 1299-1315
Open AccessExperimental investigation on the effect of channel geometry on performance heterogeneity in hydrogen PEM fuel cell
- 19 May 2021
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 4 (6) , 5424-5433
Large Scale Synthesis of Manganese Oxide/Reduced Graphene Oxide Composites as Anode Materials for Long Cycle Lithium Ion Batteries
- 19 May 2021
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 4 (6) , 5424-5433
Large Scale Synthesis of Manganese Oxide/Reduced Graphene Oxide Composites as Anode Materials for Long Cycle Lithium Ion Batteries
- 23 May 2018
- Published by Wiley in ChemElectroChem
- Vol. 5 (15) , 2059-2063
Improved Capacity Retention of Metal Oxide Anodes in Li‐Ion Batteries: Increasing Intraparticle Electronic Conductivity through Na Inclusion in Mn3O4
In this work, we significantly improve the cyclability of Mn3O4 anodes in Li‐ion batteries by enhancing its intraparticle electronic conductivity by doping with Na. Na was selected because, unlike typical transition‐metal dopants, it is non‐surface redox active in the potential window where the metal oxide conversion reaction occurs, and hence is more electrochemically stable during charge/discharge cycling. This work presents the first time that Na has been used as a dopant in metal oxide anodes, and the result is excellent capacity retention and rate capability. More specifically, Na was added to Mn3O4 (to achieve a Mn/Na ratio of ca. 9 : 1), impregnated onto a carbon nanotube matrix. The concentration of Na considering the entire composition of the anode material was 0.5 at %. These electrodes were able to achieve a capacity of approximately 750 mAh/g at a 1C rate, and retain over 99 % of that capacity over 500 cycles. They were also able to provide nearly twice the theoretical capacity of conventional graphite anodes under high rate discharge (609 mAh/g @ 5C), as well as achieve a higher capacity at 10C (ca. 350 mAh/g) than conventional graphite electrodes can at 1C.
- 23 May 2018
- Published by Wiley in ChemElectroChem
- Vol. 5 (15) , 2059-2063
Improved Capacity Retention of Metal Oxide Anodes in Li‐Ion Batteries: Increasing Intraparticle Electronic Conductivity through Na Inclusion in Mn3O4
In this work, we significantly improve the cyclability of Mn3O4 anodes in Li‐ion batteries by enhancing its intraparticle electronic conductivity by doping with Na. Na was selected because, unlike typical transition‐metal dopants, it is non‐surface redox active in the potential window where the metal oxide conversion reaction occurs, and hence is more electrochemically stable during charge/discharge cycling. This work presents the first time that Na has been used as a dopant in metal oxide anodes, and the result is excellent capacity retention and rate capability. More specifically, Na was added to Mn3O4 (to achieve a Mn/Na ratio of ca. 9 : 1), impregnated onto a carbon nanotube matrix. The concentration of Na considering the entire composition of the anode material was 0.5 at %. These electrodes were able to achieve a capacity of approximately 750 mAh/g at a 1C rate, and retain over 99 % of that capacity over 500 cycles. They were also able to provide nearly twice the theoretical capacity of conventional graphite anodes under high rate discharge (609 mAh/g @ 5C), as well as achieve a higher capacity at 10C (ca. 350 mAh/g) than conventional graphite electrodes can at 1C.
- 16 March 2018
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 122 (13) , 7120-7127
Cobalt Doping as a Pathway To Stabilize the Solid-State Conversion Chemistry of Manganese Oxide Anodes in Li-Ion Batteries
- 16 March 2018
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 122 (13) , 7120-7127
Cobalt Doping as a Pathway To Stabilize the Solid-State Conversion Chemistry of Manganese Oxide Anodes in Li-Ion Batteries