AJAkhenaton-Andrew Dhafir Jones

Akhenaton-Andrew Dhafir Jones

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Akhenaton-Andrew Dhafir Jones has a total of 66 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Perspective on Electrochemical Lead Detection: Distributed Sensing to Address Unevenly Distributed Risk

    by Elizabeth R. Jacobia, A. Andrew D. Jones Iii

    Lead contamination is a global issue and requires detection for risk evaluation and remediation. Standardized testing is accurate and effective for water quality monitoring, however, does not provide real-time results and is not widely accessible. Electrochemical detection methods have been developed with comparable lead sensitivity and selectivity to standard methods. United States Environmental Protection Agency certification of electrochemical lead detection methods and inspectors would allow for readily available and cost-efficient water quality results. Introducing electrochemical lead detection methods in the United States will increase water quality awareness, incentivize mitigation, and provide data for regulation and policy development.

  • Open Access

    Dimensional analysis as a tool for biofilm comparative analysis: bridging the interdisciplinary divides

    by Chelsea M. Middleton, A-Andrew D. Jones

    Biofilms are the predominant lifestyle for bacteria. Biofilm abundance makes understanding their behavior important for different research domains. These domains can have different information and reporting standards. Information reporting standards have been proposed for some biofilm research methods. Standard methods and consensus standards have also been promulgated. We propose dimensional analysis to encourage abundant information reporting and facilitate comparative analysis. Dimensional analysis utilizes physical system parameters to generate generalizable model data. We review dimensionless quantities that can be applied to biofilm studies. We suggest dimensionless quantities for existing standards, with three examples using dimensional analysis to quantitatively compare literature data.

  • Open Access

    Characterization of Bismuth-Coated Glassy Carbon Electrodes in Acidic Solvent Electrolytes for Enhanced Lead Detection

    by Elizabeth R. Jacobia, Akhenaton-Andrew Dhafir Jones

    Lead detection is needed to assess water quality risks, evaluate potential human exposure to lead, and guide effective resource allocation. Bismuth-coated electrodes have been employed for trace lead detection in drinking water samples because they can be made portable and are a safer alternative to mercury-based electrodes. Alternative electrolytes to the standard acetate buffer electrolyte can simplify the detection method and ensure the complete dissolution of particulate lead, a substantial portion of total lead, in drinking water samples. Acids are effective in dissolving particulate lead but are not common electrolytes for lead detection using bismuth-coated electrodes because it is hypothesized that they disrupt the coating. We tested this hypothesis in nitric, hydrochloric, acetate buffer, and sodium chloride electrolytes using square wave stripping voltammetry (SWSV), open circuit potential (OCP), cyclic voltammetry (CV), electrochemically active surface area calculations, and electrochemical impedance spectroscopy (EIS) to determine the electrochemical and electrical properties of bismuth-coated rotating disk electrodes in each. Nitric Acid had the lowest percent relative standard deviation (RSD) between lead peak repeated measures of the electrolytes (2.82 ± 0.947%), the highest OCP value (-0.0170 ± 0.0157 V), and moderate calculated electrochemically active surface area (0.0316 ± 0.0136 cm2) and roughness factor values (0.161 ± 0.069 cm2). Uncompensated resistance (168.82 ± 2.22 ohms) and polarization resistance (1387.41 ± 67.75 ohms) in nitric acid was low compared to the other electrolytes tested. Nitric acid had the highest EIS magnitude parameters for electrical surface distribution (5.5x10-4 ± 2.8x10-5 S•sα) and non-ideal capacitor coefficient (0.713 ± 0.006). The bismuth-coated electrode enabled a 60.3% increase in sensitivity compared to the bare electrode in nitric acid. We conclude that nitric acid is an effective alternative electrolyte for lead detection on bismuth-coated glassy carbon electrodes due to its low pH and minimal complexation with lead ions.

  • Open Access

    In Vitro Evaluation of Escherichia coli and Staphylococcus aureus Translocation in 3D Printed Material

    by Ashma Sharma, Joshua Prince, A‐Andrew D. Jones

    Vascular graft infection is a rare but life‐threatening condition, primarily occurring after 30 days post‐surgery. Meta‐analysis has shown that antimicrobial coatings on graft materials do not prevent these infections. Moreover, infections still occurs even though studies have shown that there is no bacterial proliferation or bacterial penetration of common vascular graft material. The time frame of infection, meta‐analysis, and in situ studies suggest that bacteria present at the suture site are introduced into the surrounding tissue or that systemically circulating bacteria may be surviving, proliferating, diffusing slowly, and evading host immune defense in synthetic vascular grafts. De novo vascular graft materials, such as tissue‐engineered vascular graft material and decellularized vasculature may provide an in situ platform for studying survival, proliferation, and diffusion in tissue and tissue‐like materials. In this study, we used confocal microscopy to image the penetration depth of bacteria over time as a proxy for the diffusion of Staphylococcus aureus and Escherichia coli into alginate, GelMA, and decellularized porcine vascular tissue. We quantified viable bacteria breakthrough as a function of biomaterial type. We found that the penetration depth over time was similar in all three biomaterials, however E. coli broke through much less from tissue than from engineered materials, while S. aureus had higher breakthrough in the GelMa but otherwise equal rates. These results point to the possibility of interstitial growth control relative to surface coatings as a future target for engineering infection resistance in engineered vascular grafts.


  • Open Access

    Transmission from Sink to Patient: An Evaluation of Sink Generated Bioaerosols and their Role in Hospital Acquired Bacterial Infections

    by JoHannah Buehrer, Megan Lott, Kevin J. Zhu, Kayla Fericy, Joshua Granek, Claudia K. Gunsch, Akhenaton-Andrew Dhafir Jones, Joe Brown, Glenn Morrison, Barbara Turpin

    Healthcare Associated Infections (HAIs) pose a significant public health risk. Hospital sinks and associated plumbing are one likely source. This study investigates bioaerosol emissions from sink P-traps during faucet operation to assess their potential role in pathogen transmission in the hospital context. We designed an aerosol chamber system with adjustable air change rate and a functioning sink meeting hospital standards. We quantified bioaerosol and large droplet emission factors from the sink, using FAmpEscherichia coli as a model for Enterobacteriaceae such as Klebsiella pneumoniae. We cultured Andersen Cascade Impactor and BioSpot sampler aerosol samples and deposition plates using MI agar, which is selective for E. coli. Across five experiments, deposition plate counts were substantial, while air samples were close to detection limits. We estimated PM5.0 bioaerosol emissions factors of 1.3 x 10-10 to 1.9 x 10-10 CFU emitted per CFU in P-trap. Large droplet emission factor was one order of magnitude larger, at 4.3 x 10-9 ± 2.8 x 10-9 CFU per CFU. Results were used to predict Klebsiella pneumoniae inhalation dose (0.78 to 1.12 CFU day-1) and inhalation infection probability (∼10-5) for 5.5 day hospital stay with colonized plumbing (air change rate 6 h-1). This translates to ∼1 infection per year for a hospital with a severe plumbing system colonization affecting ∼2000 continuously occupied rooms. For pathogens with different dose response curves, we demonstrate how infection probability via inhalation depends on dose response.

  • Open Access

    Nanocellulose hydrogels as biointerface analogs for studying nanoparticle transport and accumulation

    by Joshua Prince, Darryl Taylor, A-Andrew D. Jones

    Nanoparticles have been proposed as drug delivery vehicles to enhance targeting and efficiency of traditional and novel therapeutics. Previous studies have identified size, surface charge, and volume exclusion as factors that influence nanoparticle diffusion and retention. However, there is little accepted or successful quantification of how these parameters influence nanoparticle penetration relative to biological adaptation and biological response. Part of the challenge is the response of living biological interfaces to many of these nanoparticle delivery vehicles and nanosized drugs. This study aimed to emulate key physicochemical barriers to diffusion found in living biomaterials by developing a tunable, synthetic hydrogel. Through the controlled exposure of 150 kDa and 2 MDa nanodextrans with neutral and negative surface charge, we evaluated the system’s ability to emulate three core physicochemical features often implicated in biofilm-associated transport resistance: size exclusion, charge interactions, and volume exclusion. We demonstrated a 30% statistically significant decrease in partition coefficients for 2 MDa nanodextran from 150 kDa nanodextran, confirming the ability of the nanocellulose-based microcaps to size based exclusion of hydrated biomaterial matrices. We combined our results with bioaccumulation data from the literature and found only the interaction of size and charge had a statistically significant effect (p-value < 0.05, F-statistic = 4.8). This controllable system can be coupled with in silico modeling to understand interfacial transport phenomena for nanomaterial-biomaterial interactions.

  • Open Access

    In vitro evaluation of Escherichia coli and Staphylococcus aureus translocation in 3D printed material

    by Ashma Sharma, Joshua Prince, Akhenaton-Andrew D Jones

    Vascular graft infection is a rare but life threating condition, primarily occurring after 30 days post-surgery. Meta-analysis has shown that antimicrobial coatings on graft materials do not prevent these infections. Moreover, infection still occurs even though studies have also shown that there is no bacterial proliferation on or bacterial penetration of common vascular graft material. The time frame of infection, meta-analysis, and in situ studies suggest that bacteria present at the suture site are introduced into the surrounding tissue or that systemically circulating bacteria may be surviving, proliferating, diffusing slowly, and evading host immune defense in synthetic vascular grafts. De novo vascular graft materials, such as tissue-engineered vascular graft material and decellularized vasculature may provide an in situ platform for studying survival, proliferation, and diffusion in tissue and tissue-like materials. In this study, we use confocal microscopy to image penetration depth of bacteria over time as a proxy for diffusion of Staphylococcus aureus and Escherichia coli into alginate, GelMA, and decellularized porcine vascular tissue. We quantified viable bacteria breakthrough as a function of biomaterial type. We found penetration depth over time was similar in all three biomaterials, however E. coli broke through much less from tissue than from engineered materials, while S. aureus had higher breakthrough in the GelMa but otherwise equal rates. These results point to the possibility of interstitial growth control relative to surface coatings as a future target for engineering infection resistance in engineered vascular grafts. Graphical

  • Open Access

    Evaluation of Solvents for Dissolution and Electrochemical Detection of Common Lead Forms in Test Drinking Water

    by Elizabeth R. Jacobia, A-Andrew D. Jones

    Lead contamination in drinking water is a global human health concern. Total lead measurement requires lead dissolution of insoluble lead particles. Standard methods use extensive sample preparation and laboratory-based analysis, unfeasible for point-of-use sensors. Square wave stripping voltammetry using a bismuth-coated electrode has been proposed as a fast, safe, and accurate alternative to standard methods. However, point-of-use lead sensors are limited by a lack of lead dissolution. Lead dissolution of different lead forms in standardized test water with nitric acid at pH 2, hydrochloric acid at pH 2, and acetate buffer at pH 4.5 was investigated. Lead forms common in drinking water were tested and compared to lead nitrate, a form commonly used in laboratory-based studies. The lead dissolution solvents tested were used simultaneously as electrolyte solutions. Measurements were verified by inductively coupled plasma-mass spectrometry. Nitric acid and hydrochloric acid had comparable lead dissolution and sensing for lead forms common in drinking water and real tap water samples. The acids achieved low limits of detection, 1.38 μg l −1 in nitric acid, 6.06 μg l −1 in hydrochloric acid. We conclude nitric acid and hydrochloric acid have the potential to dissolve lead and act as an electrolyte for square wave stripping voltammetry sensing.


  • Synthesis of Metal‐Modified Nanocellulose as a Biofilm Analogue for Biofilm Mimicry in Biomedical and Environmental Applications

    by Darryl W. Taylor, A‐Andrew D. Jones

    Bacterial biofilms are complex, multi‐component structures consisting primarily of four key elements: polysaccharides, metal ions, proteins, and extracellular DNA. In our research, we specifically focus on the polysaccharide and metal ion components, which play a crucial role in determining the biofilm's mechanical properties. Polysaccharides provide the structural matrix, although metal ions, particularly divalent cations like calcium and cobalt, cross‐link with the polysaccharides, thereby modulating the biofilm's rigidity and viscoelastic behavior. By introducing divalent cations into nanocellulose, we can replicate this natural cross‐linking process, allowing us to finely tune the material's mechanical properties to more closely resemble those of bacterial biofilms. This approach not only enhances the accuracy of synthetic biofilm models over alginate hydrogels but also provides valuable insights into how biofilms maintain their structural integrity in various environments. Our findings indicate that nanocellulose exhibits mechanical properties closer to biofilms than alginate analogs, making it a suitable non‐living control for biofilm studies. Furthermore, divalent nickel, followed by calcium and magnesium, demonstrate a closer mechanical mimicry to biofilms. In conclusion, this research shows the potential of nanocellulose as a versatile material for bacterial biofilm mimicry.


  • The Climate Change Burden on Immune Health: Are Persons Living with HIV More at Risk?

    by Griffin Woolley, Kyle Kroll, Kate Hoffman, Ashley Ward, Amy Corneli, Sarah V. Mudrak, M. Umar Qureshi, N. Lance Okeke, Cliburn Chan, Akhenaton-Andrew D. Jones, et al.

    Climate change poses one of the most significant modern threats to overall human health,especially for vulnerable populations including persons living with HIV (PLWH). In this perspective, we specifically explore the concept of immune resilience in human health and how climate change phenomena - including extreme weather events, food insecurity, pollution, and emerging diseases - may exacerbate immune dysfunction and comorbidities faced by PLWH and hinder access to HIV treatment and prevention services. Multidisciplinary, collaborative efforts are urgently needed to quantify these impacts, develop mitigation strategies, and strengthen policies and funding to bolster immune resilience for PLWH in the face of accelerating climate change.