NSNina Stark

Nina Stark

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Nina Stark has a total of 95 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Probabilistic sediment characterization using Chirp sub-bottom profiler and Portable Free-Fall Penetrometer measurements

    by Md Rejwanur Rahman, Adrian Rodriguez-Marek, Nina Stark, Carl Friedrichs, Kelly M. Dorgan, Grace Massey


  • Open Access

    Scalable Geomorphic Monitoring for Tidal Wetland Sediment Nourishments

    by Brian Harris, Justin Shawler, Aleksandra Ostojic, Monica Chasten, Sean McGill, David White, Lenore Tedesco, Brittany Bruder, Freddie Falcone, Daniel Gallegos, et al.

  • Open Access

    Morphologic interaction of bridges during high-energy flood events by the example of the flood of mid-July 2021 in the Ahr Valley, Germany

    by Stefanie Wolf, Lisa Burghardt, Nina Stark, Anton Ahlswede, Michael Gardner, Anne Lemnitzer, Holger Schüttrumpf

    In mid-July 2021, heavy rainfall led to severe flash floods in the Eifel-mountain region in western Germany. The Ahr River, a tributary to the Rhine River in Rhineland-Palatinate, was most severely affected. Discharges accumulated rapidly in the narrow valley and formed a fast-moving flood wave, leading to record-breaking water levels. High hydraulic forces in combination with driftwood and debris accumulation led to local back-up, and eventually failure of many bridges [1].The flood is proven to be a high-energy event that led to significant morphologic changes [2]. Besides lateral river course changes, severe local erosion was observed after the flood, and especially documented near bridges [3].The Ahr Valley is well suited for a case study on the morphologic interaction of bridges with high-energy floods, as around 75% of the 114 bridges were damaged or destroyed in 2021 [1]. In April 2022, bathymetry data was collected at two affected bridges. Further, selected bridges were monitored by drone surveys every six months, allowing us to investigate the morphologic development over the last two years.Besides bridge overtopping , pier scouring led to structural failure [1, 4, 5]. At a railway bridge between Reimerzhoven and Dernau (N: 50.532213, E: 7.062320) scouring occurred upstream on the pier in the middle of the riverbed, and bank erosion occurred on the right-hand in flow direction. Riverbed narrowing and sediment deposition at the remaining piers occurred on a small scale. Further upstream, at the town of Altenahr, massive debris accumulation, bridge overtopping, and pier scouring downstream of the middle pier led to structural failure. At this location, a railway bridge and a trafficable bridge were located next to each other (N: 50.514921, E 6.985825). The railway bridge experienced severe bank erosion on the left-hand side in flow direction. After removal, shoal formation led to the cut-off of a stagnant water pool [2]. Processes of pier scouring, bank erosion, and sediment deposition in the following two years differ in both examples. Further investigation and comparison help to gain an understanding of the complex morphologic interaction of bridges in high-energy flood events. Parameters, like the main flow direction and the local flow velocity as well as driftwood accumulation leading to bridge overtopping impact patterns of erosion and deposition. Results can support local water resources management as well as bridge construction authorities.[1] Burghardt L, Schüttrumpf H, Wolf S et al. (2022) Analyse der Schäden an Brückenbauwerken in Folge des Hochwassers 2021 an der Ahr. Wasser Abfall 24:12–17[2] Wolf S, Stark N, Holste I et al. (2023) Evaluation of the High-Energy-Flood of mid-July 2021 as a Morphologic Driver in the Ahr Valley [preprint][3] Lehmkuhl F, Keßels J, Schulte P et al. (2022) Beispiele für morphodynamische Prozesse und Verlagerungen in Folge des Hochflutereignisses 2021 im Ahrtal. Wasser Abfall 24:40–47. https://doi.org/10.1007/s35152-022-1349-7[4] Pucci A, Eickmeier D, Sousa HS et al. (2023) Fragility Analysis Based on Damaged Bridges during the 2021 Flood in Germany. Applied Sciences 13:10454. https://doi.org/10.3390/app131810454[5] Lemnitzer A, Stark N, Gardner M et al. (2022) Geotechnical Reconnaissance of the 2021 Western European Floods. GEER Association (Report - 76)


  • Open Access

    Evaluation of the high-energy flood of mid-July 2021 as a morphologic driver in the anthropogenically developed Ahr Valley, Germany, in interaction with infrastructures

    by Stefanie Wolf, Nina Stark, Ina Holste, Frank Lehmkuhl, Wolfgang Römer, Lisa Burghardt, Holger Schüttrumpf

    Background: This study explores morphologic changes in the Ahr River, Germany, caused by the high-energy flood in mid-July 2021. This study aims to assess the flood's significance as a morphological driver using the Lateral Mobility Index (LMI), as well as the impact of infrastructure on morphodynamics in terms of the formation of mud deposits and stagnant water pools, considering three focus areas of about 1 to 5 km river length. The three focus areas cover differences in the valley morphology as well as near natural and anthropogenically affected sections. Results: The LMI is derived from orthophotos from 1998 to 2022, and based on the surface area of the old and the new channel. It describes the sum of new and abandoned channel area in relation to the previous channel area. For the 2021 high-energy event, an increased LMI suggests an increasing change in river course and morphology. Post-flood, the LMI in focus areas 1 (furthest upstream, LMI of 1.5) and 3 (at the Rhine confluence, LMI of 3.2) surpasses the historic LMI by a factor of about 3. Focus area 3 exhibits the highest activity, while focus area 2 (LMI between 0.25 and 0.70) the lowest. The area of mud deposits and stagnant water pools increased immediately after the flood, especially in focus area 3. Over the following months, initial post-flood mud deposits not only washed away but also rebuilt to some degree later on. Conclusions: The LMI enabled to quantitatively identify a rare and significant morphological disruption in the Ahr River’s lateral development in three focus areas, and thus, serves as additional proof that the flood of mid-July 2021 was a high-energy event impacting the local river geomorphology. Infrastructure impacted the formation of mud deposits and stagnant water zones during and after the flood, with additional influence from factors such as driftwood and valley width. The data suggested a phase of resuspension of sediments after the flood, likely due to cleanup and ad hoc river management, highlighting the need for continued river monitoring.


  • Open Access

    Initial observations of the impacts of infauna on portable free fall penetrometer measurements in sandy parts of Mobile Bay

    by Nina Stark, Kelly M. Dorgan, Nicola C. Brilli, Madeline R. Frey, Chesna Cox, Joseph Calantoni

    The seabed surface provides habitat for abundant and diverse fauna, whose burrowing activities have been shown to modify geotechnical properties of surface sediments. Whether these impacts affect geotechnical properties on larger scales of traditional measurements has not been well studied. This study represents an initial attempt to assess whether infaunal activity affects seabed properties on a scale relevant for, and therefore, detectable in portable free fall penetrometer measurements. Specifically, we examine sediment strength profiles of the upper 10–70 cm of sandy (poorly graded sand and muddy sand) seabed sediments in Mobile Bay, Alabama, USA, hypothesizing that infauna create heterogeneity in sediment structure that would lead to variability in PFFP vertical profiles as well as among replicate measurements at a site. Sediments were composed predominantly of sands, with only 17% of the sites featuring sand contents < 97% and median grain sizes ranging from 0.0987 to 0.3457 mm. Sediment strength generally decreased with a decreasing sand content, but variability was not explained by sand content alone. PFFP impacts in sandier sites (> 97% sand) were limited to the surface few cm, but considerable vertical and spatial variability in muddy sands and lower strength at sites with abundant burrowing infauna suggest that infaunal activities may affect PFFP measurements in these sediments.


  • Open Access

    Relating Geotechnical Sediment Properties and Low Frequency CHIRP Sonar Measurements

    by Reem Jaber, Nina Stark, Rodrigo Sarlo, Jesse E. McNinch, Grace Massey

    Low frequency acoustic methods are a common tool for seabed stratigraphy mapping. Due to the efficiency in seabed mapping compared to geotechnical methods, estimating geotechnical sediment properties from acoustic surveying is attractive for many applications. In this study, co-located geotechnical and geoacoustic measurements of different seabed sediment types in shallow water environments (su < 3 kPa) and loose sands (~20% relative density). This is a step towards validating the ability of acoustic methods to capture geotechnical properties in the topmost seabed layers.


  • Open Access

    A SIMPLE LABORATORY CALIBRATION METHOD FOR MITIGATING SEAWATER EFFECTS ON SOIL MOISTURE SENSORS

    by Nicola C. Brilli, Nina Stark, Britt Raubenhiemer, Steve Elgar, Bennet Korka

    The importance of moisture content for sediment dynamics in coastal environments is well documented, particularly in reference to aeolian sediment transport (Davidson-Arnott, 2005). Tidally-induced changes in moisture content in partially saturated environments, such as beaches, cause significant changes in surface shear strength through the development of suction stresses, which can affect erodibility (Sassa and Watabe, 2007). Thus, the accurate measurement of moisture content in these environments is important for determination of strength properties and for predicting sediment transport. Most moisture sensors work by measuring dielectric permittivity, the ability to carry electric charge, of the substrate, which is proportional to the moisture content. However, most moisture sensors are not calibrated for seawater, which has a higher dielectric permittivity than freshwater, causing overestimation of the moisture content. Therefore, the goal of this study is to develop and demonstrate a laboratory calibration scheme to account for this overestimation, and thus to allow for more accurate measurements of moisture content in coastal environments.