Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Ewa Popko has a total of 35 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Polar and Non-Polar Zn1−xMgxO:Sb Grown by MBE

    by Ewa Przezdziecka, Karolina M Paradowska, Rafal Jakiela, Serhii Kryvyi, Eunika Zielony, Ewa Placzek-Popko, Wojciech Lisowski, Piotr Sybilski, Dawid Jarosz, Abinash Adhikari, et al.

    The article presents a systematic study of Sb-doped Zn1−xMgxO layers, with various concentrations of Mg, that were successfully grown by plasma-assisted MBE on polar a- and c-oriented and non-polar r-oriented sapphire substrates. X-ray diffraction confirmed the polar c-orientation of alloys grown on c-and a-oriented sapphire and non-polar structures grown on r-oriented substrates. A uniform depth distribution of the Sb dopant at level of 2 × 1020 cm−3 was determined by SIMS measurements. Raman spectroscopy revealed the presence of Sb-related modes in all samples. It also showed that Mg alloying reduces the compressive strain associated with Sb doping in ZnO. XPS analysis indicates that the chemical state of Sb atoms in ZnMgO is 3+, suggesting a substitutional position of SbZn, probably associated with two VZn vacancies. Luminescence and transmission spectra were measured to determine the band gaps of the Zn1−xMgxO layers. The band gap energies extracted from the transmittance measurements differ slightly for the a, c, and r substrate orientations, and the differences increase with increasing Mg content, despite identical growth conditions. The differences between the energy gaps, determined from transmission and PL peaks, are closely correlated with the Stokes shift and increase with the Mg content in the analyzed series of ZnMgO layers.


  • Determination of the band structure diagram of semiconductor heterostructures applied in photovoltaics

    by Rafał Antoni Bogaczewicz, Ewa Popko, Katarzyna Renata Gwóźdź

    Recently it has been found that the heterostructures of n-ZnO/p-Si are promising photovoltaic alternatives to silicon homojunctions. It is well known that the energy band diagram of a heterostructure is crucial for the understanding of its operation. This paper analyzes the ZnO/p-Si heterostructure band by using free AMPS-1D computer program simulations. The obtained numerical results are compared with theoretical calculations based on the depletion region approximation model and the Poisson’s equation for electric potential. The results of the simulation are also compared with the experimental C-V characteristics of the test n-ZnO/p-Si heterostructure. The simulated C-V characteristics is qualitatively consistent with the experimental C-V curve, which confirms the correctness of the determined band diagram of the n-ZnO/p-Si heterostructure.

  • Open Access

    Dielectric Response of ZnTe–Ti/Al Schottky Junctions with CdTe Quantum Dots Studied by Impedance Spectroscopy

    by Eunika Zielony, Ewa Płaczek-Popko, Grzegorz Karczewski

    The electrical properties of ZnTe–Ti/Al Schottky junctions were investigated by the impedance spectroscopy (IS) method. Current-voltage (I-V) and capacitance-voltage (C-V) measurements were also performed. The studied samples were the CdTe quantum dot structures embedded in ZnTe matrix and a reference ZnTe sample without quantum dots. C-V characteristics confirmed the presence of quantum dots (QDs) in the structures. Electric modulus and impedance data were analyzed. IS studies proved that long-range conductivity governs the relaxation processes in the junctions. For both samples, the data were fitted with a simple RC circuit composed of a depletion layer capacitance in parallel with bulk resistance and a series resistance of contacts. The activation energy of the relaxation process observed for the reference sample obtained from the Arrhenius plot of the resistance, imaginary impedance, and electric modulus equals 0.4 eV at zero bias. For the quantum dot sample, the value of activation energy determined with the help of the same methods equals 0.2 eV. In conclusion, it was assumed that the relaxation processes for the reference sample are attributed to the trap present in ZnTe host material, whereas those observed for the QD structure are assigned to the deep level associated with defects located close to the QDs created during their growth.


  • Open Access

    Low-Cost CuIn1−xGaxSe2 Ultra-Thin Hole-Transporting Material Layer for Perovskite/CIGSe Heterojunction Solar Cells

    by Liann-Be Chang, Chzu-Chiang Tseng, Gwomei Wu, Wu-Shiung Feng, Ming-Jer Jeng, Lung-Chien Chen, Kuan-Lin Lee, Ewa Popko, Lucjan Jacak, Katarzyna Gwozdz

    This paper presents a new type of solar cellwith enhanced optical-current characteristics using an ultra-thin CuIn1−xGaxSe2 hole-transporting material (HTM) layer (3NH3PbI3 (MAPbI3) perovskite active absorbing material. It promoted carrier transportand led to an improved device with good ohmic-contacts. The solar cell was prepared as a bi-layer Mo/CuIn1−xGaxSe2/perovskite/C60/Ag multilayer of nano-structures on an FTO (fluorine-doped tin oxide) glass substrate. The ultra-thin CuIn1−xGaxSe2 HTM layers were annealed at various temperatures of 400, 500, and 600 °C. Scanning electron microscopy studies revealed that the nano-crystal grain size of CuIn1−xGaxSe2 increased with the annealing temperature. The solar cell results show an improved optical power conversion efficiency at ~14.2%. The application of the CuIn1−xGaxSe2 layer with the perovskite absorbing material could be used for designing solar cells with a reduced HTM thickness. The CuIn1−xGaxSe2 HTM has been evidenced to maintain a properopen circuit voltage, short-circuit current density and photovoltaic stability.


  • Open Access

    Phosphor-Free InGaN White Light Emitting Diodes Using Flip-Chip Technology

    by Ying-Chang Li, Liann-Be Chang, Hou-Jen Chen, Chia-Yi Yen, Ke-Wei Pan, Bohr-Ran Huang, Wen-Yu Kuo, Lee Chow, Dan Zhou, Ewa Popko

    Monolithic phosphor-free two-color gallium nitride (GaN)-based white light emitting diodes (LED) have the potential to replace current phosphor-based GaN white LEDs due to their low cost and long life cycle. Unfortunately, the growth of high indium content indium gallium nitride (InGaN)/GaN quantum dot and reported LED’s color rendering index (CRI) are still problematic. Here, we use flip-chip technology to fabricate an upside down monolithic two-color phosphor-free LED with four grown layers of high indium quantum dots on top of the three grown layers of lower indium quantum wells separated by a GaN tunneling barrier layer. The photoluminescence (PL) and electroluminescence (EL) spectra of this white LED reveal a broad spectrum ranging from 475 to 675 nm which is close to an ideal white-light source. The corresponding color temperature and color rendering index (CRI) of the fabricated white LED, operated at 350, 500, and 750 mA, are comparable to that of the conventional phosphor-based LEDs. Insights of the epitaxial structure and the transport mechanism were revealed through the TEM and temperature dependent PL and EL measurements. Our results show true potential in the Epi-ready GaN white LEDs for future solid state lighting applications.


  • Open Access

    Improving Efficiency of Multicrystalline Silicon and CIGS Solar Cells by Incorporating Metal Nanoparticles

    by Ming-Jer Jeng, Zih-Yang Chen, Yu-Ling Xiao, Liann-Be Chang, Jianping Ao, Yun Sun, Ewa Popko, Witold Jacak, Lee Chow

    This work studies the use of gold (Au) and silver (Ag) nanoparticles in multicrystalline silicon (mc-Si) and copper-indium-gallium-diselenide (CIGS) solar cells. Au and Ag nanoparticles are deposited by spin-coating method, which is a simple and low cost process. The random distribution of nanoparticles by spin coating broadens the resonance wavelength of the transmittance. This broadening favors solar cell applications. Metal shadowing competes with light scattering in a manner that varies with nanoparticle concentration. Experimental results reveal that the mc-Si solar cells that incorporate Au nanoparticles outperform those with Ag nanoparticles. The incorporation of suitable concentration of Au and Ag nanoparticles into mc-Si solar cells increases their efficiency enhancement by 5.6% and 4.8%, respectively. Incorporating Au and Ag nanoparticles into CIGS solar cells improve their efficiency enhancement by 1.2% and 1.4%, respectively. The enhancement of the photocurrent in mc-Si solar cells is lower than that in CIGS solar cells, owing to their different light scattering behaviors and material absorption coefficients.