Soroush Moallemi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Soroush Moallemi has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Jennifer Kitchen
School of Electrical, Computer and Energy Engineering, Arizona State University, Tempe, AZ, USA
3 shared publications - Payam Mehr
University of California, Los Angeles
2 shared publications - Trevor J. Thornton
School of Electrical, Computer and Energy Engineering, Arizona State University, Tempe, AZ, USA
2 shared publications - Kevin Grout
Connection One Research Center, Department of Electrical Engineering, Arizona State University, Tempe, AZ 85287 USA
1 shared publication - Sumit Bhardwaj
Amity University
1 shared publication William Lepkowski
School of Electrical, Computer and Energy Engineering, Arizona State University, Tempe, AZ, USA
1 shared publication
Latest Publications
- 2 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 38 (5) , 6036-6062
A Review of Hybrid Supply Modulators in CMOS Technologies for Envelope Tracking PAs
This article reviews trends, architectures, and recent developments in CMOS-based supply modulators (SM) used for envelope-tracking power amplifiers (ET-PAs). This review details the most commonly used hybrid supply modulator (HSM) architecture in CMOS and discusses its performance requirements and design challenges. The importance of efficiency, speed, linearity, and output power in HSM design is delineated and different methods that focus on maximizing these performance parameters are presented. Finally, the design challenges of envelope tracking systems are discussed, and an overview of device technologies for implementing SM and ET-PAs is given.
- 2 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 38 (5) , 6036-6062
A Review of Hybrid Supply Modulators in CMOS Technologies for Envelope Tracking PAs
This article reviews trends, architectures, and recent developments in CMOS-based supply modulators (SM) used for envelope-tracking power amplifiers (ET-PAs). This review details the most commonly used hybrid supply modulator (HSM) architecture in CMOS and discusses its performance requirements and design challenges. The importance of efficiency, speed, linearity, and output power in HSM design is delineated and different methods that focus on maximizing these performance parameters are presented. Finally, the design challenges of envelope tracking systems are discussed, and an overview of device technologies for implementing SM and ET-PAs is given.
- 6 May 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 67 (4) , 605-609
Adaptive Power Control Using Current Adjustment for Watt-Level Power Amplifiers in CMOS SOI
This paper demonstrates the effectiveness of utilizing a 4-bit current steering DAC as an adaptive power controller to adjust the DC quiescent current of a linear power amplifier as a function of the input signal power. A custom made metal-semiconductor field-effect transistor (MESFET), which is used as the amplifying transistor, and a current steering DAC have been integrated on the same substrate to minimize the power amplifier’s form factor and mismatches between the power tracker and the MESFET. This design has been implemented in a 45 nm CMOS SOI Global Foundries (GF) process with a nominal supply voltage of 0.9 V and provides 31.8 dBm of output power, 45% peak efficiency and 24 dB maximum power gain. Measurement results at 70 MHz reveal about 10% efficiency improvement at 6 dB power back-off with continuous wave and 5% for standard 16-PSK EDGE modulated signals. The amplifier shows EVM of 5% and ACPR of -56.9 dBc at 400 kHz offset from the carrier frequency without digital pre-distortion, while transmitting 27 dBm of modulated output power.
- 6 May 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 67 (4) , 605-609
Adaptive Power Control Using Current Adjustment for Watt-Level Power Amplifiers in CMOS SOI
This paper demonstrates the effectiveness of utilizing a 4-bit current steering DAC as an adaptive power controller to adjust the DC quiescent current of a linear power amplifier as a function of the input signal power. A custom made metal-semiconductor field-effect transistor (MESFET), which is used as the amplifying transistor, and a current steering DAC have been integrated on the same substrate to minimize the power amplifier’s form factor and mismatches between the power tracker and the MESFET. This design has been implemented in a 45 nm CMOS SOI Global Foundries (GF) process with a nominal supply voltage of 0.9 V and provides 31.8 dBm of output power, 45% peak efficiency and 24 dB maximum power gain. Measurement results at 70 MHz reveal about 10% efficiency improvement at 6 dB power back-off with continuous wave and 5% for standard 16-PSK EDGE modulated signals. The amplifier shows EVM of 5% and ACPR of -56.9 dBc at 400 kHz offset from the carrier frequency without digital pre-distortion, while transmitting 27 dBm of modulated output power.
- 28 August 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Semiconductor Manufacturing
- Vol. 32 (1) , 14-22
CMOS-Compatible MESFETs for High Power RF Integrated Circuits
Metal semiconductor field effect transistors (MESFETs) have been fabricated using a 45 nm SOI CMOS technology available from Global Foundries. MESFETs with gate lengths of 200 nm show good manufacturability with well-controlled run-to-run variations. The DC and RF performance of devices with different drain access lengths are compared to illustrate the design trades between high breakdown voltage and high frequency operation. Two applications of the MESFETs for RF integrated circuit (RFIC) design are presented. The first demonstrates integrated n-channel MOSFET-MESFET cascode amplifiers that combine the enhanced voltage operation of the MESFET with the high frequency capability of the scaled MOSFET. The resulting small-signal amplifiers demonstrate cut-off frequencies of 50 GHz when operated with supply voltages of 6 V, significantly higher than the nominal 1 V breakdown voltage of the CMOS transistors. The second application demonstrates a watt-level MESFET power amplifier integrated with a CMOS current steering digital-to-analog converter (DAC). The MESFET serves as the RF output device, while the 4-bit CMOS DAC enables average power tracking. Both examples demonstrate the design flexibility enabled by the CMOS-compatible MESFETs.
- 28 August 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Semiconductor Manufacturing
- Vol. 32 (1) , 14-22
CMOS-Compatible MESFETs for High Power RF Integrated Circuits
Metal semiconductor field effect transistors (MESFETs) have been fabricated using a 45 nm SOI CMOS technology available from Global Foundries. MESFETs with gate lengths of 200 nm show good manufacturability with well-controlled run-to-run variations. The DC and RF performance of devices with different drain access lengths are compared to illustrate the design trades between high breakdown voltage and high frequency operation. Two applications of the MESFETs for RF integrated circuit (RFIC) design are presented. The first demonstrates integrated n-channel MOSFET-MESFET cascode amplifiers that combine the enhanced voltage operation of the MESFET with the high frequency capability of the scaled MOSFET. The resulting small-signal amplifiers demonstrate cut-off frequencies of 50 GHz when operated with supply voltages of 6 V, significantly higher than the nominal 1 V breakdown voltage of the CMOS transistors. The second application demonstrates a watt-level MESFET power amplifier integrated with a CMOS current steering digital-to-analog converter (DAC). The MESFET serves as the RF output device, while the 4-bit CMOS DAC enables average power tracking. Both examples demonstrate the design flexibility enabled by the CMOS-compatible MESFETs.