Bao Huu Lam
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Bao Huu Lam has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Patrick P. Mercier
Department of Electrical and Computer Engineering, University of California, San Diego, La Jolla, CA, USA
2 shared publications Prasad Gudem
Department of Electrical and Computer Engineering, University of California San Diego, La Jolla, CA, USA
2 shared publications- Ahmed Gharib Gadel-Karim
Department of Electrical and Computer Engineering, University of California San Diego, La Jolla, CA, USA
1 shared publication - Dae-Woong Park
Department of Semiconductor Engineering, Seoul National University of Science and Technology, 232, Gongneung-ro, Nowon-gu, Seoul 01811, Republic of Korea
1 shared publication - Dzuhri Radityo Utomo
Department of Electrical and Information Engineering, Universitas Gadjah Mada (UGM), Yogyakarta, Indonesia
1 shared publication - Hongyu Lu
Department of Electrical and Computer Engineering, University of California at San Diego, La Jolla, CA, USA
1 shared publication
Latest Publications
- 2 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Solid-State Circuits Letters
- Vol. 6, 5-8
A 0.11-mW 2.4-GHz Receiver Employing a Q-Boosted Impedance Transformer and Regenerative Amplifier Achieving −101-dBm Sensitivity and −28-dB SIR
This letter presents a 2.4 GHz OOK receiver that employs a Q-boosted impedance transformer and a regenerative amplifiers (RA) to provide high gain and sharp filtering prior to demodulation. A differential envelope detector (ED) is also used to increase the conversion gain further to help nullify the noise contribution of the subsequent baseband stages. Fabricated in 65 nm, the receiver achieves a sensitivity of -101 dBm at a data rate of 5 kbps, all while consuming 112 µW. The sharp RF filtering helps enable a signal-to-interference ratio (SIR) of -28 dB.
- 2 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Solid-State Circuits Letters
- Vol. 6, 5-8
A 0.11-mW 2.4-GHz Receiver Employing a Q-Boosted Impedance Transformer and Regenerative Amplifier Achieving −101-dBm Sensitivity and −28-dB SIR
This letter presents a 2.4 GHz OOK receiver that employs a Q-boosted impedance transformer and a regenerative amplifiers (RA) to provide high gain and sharp filtering prior to demodulation. A differential envelope detector (ED) is also used to increase the conversion gain further to help nullify the noise contribution of the subsequent baseband stages. Fabricated in 65 nm, the receiver achieves a sensitivity of -101 dBm at a data rate of 5 kbps, all while consuming 112 µW. The sharp RF filtering helps enable a signal-to-interference ratio (SIR) of -28 dB.
- 28 June 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 69 (10) , 4117-4127
Analysis and Measurement of Noise Suppression in a Nonlinear Regenerative Amplifier
This paper analyzes the ability to suppress in-band noise power of a regenerative amplifier (RA) operating in the nonlinear regime in response to a continuous wave (CW) input tone. As opposed to the linear regime where a CW tone and the noise floor experience the same transfer function, it is shown that the non-linear saturation behavior of an RA yields different transfer characteristics between a CW tone and noise, ultimately leading to an improvement in the output carrier-to-noise ratio (CNR). This is all thanks to the high gain, narrow bandwidth, and the compressive third-order nonlinearity of the RA. This non-linear noise suppression is first analyzed mathematically using single tones in the frequency domain to represent the signal and the noise. Then, simulation of an RA circuit model is shown to be in excellent agreement with the analytical results. Lastly, a discrete RA has been implemented to experimentally verify the noise-suppression phenomenon. The measurement results clearly demonstrate noise suppression and show an output CNR improvement of up to 3 dB. Potential applications of the RA with noise suppression are also discussed.
- 28 June 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 69 (10) , 4117-4127
Analysis and Measurement of Noise Suppression in a Nonlinear Regenerative Amplifier
This paper analyzes the ability to suppress in-band noise power of a regenerative amplifier (RA) operating in the nonlinear regime in response to a continuous wave (CW) input tone. As opposed to the linear regime where a CW tone and the noise floor experience the same transfer function, it is shown that the non-linear saturation behavior of an RA yields different transfer characteristics between a CW tone and noise, ultimately leading to an improvement in the output carrier-to-noise ratio (CNR). This is all thanks to the high gain, narrow bandwidth, and the compressive third-order nonlinearity of the RA. This non-linear noise suppression is first analyzed mathematically using single tones in the frequency domain to represent the signal and the noise. Then, simulation of an RA circuit model is shown to be in excellent agreement with the analytical results. Lastly, a discrete RA has been implemented to experimentally verify the noise-suppression phenomenon. The measurement results clearly demonstrate noise suppression and show an output CNR improvement of up to 3 dB. Potential applications of the RA with noise suppression are also discussed.
- 8 March 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 54 (6) , 1613-1623
A 230–260-GHz Wideband and High-Gain Amplifier in 65-nm CMOS Based on Dual-Peak $G_{{\mathrm{max}}}$ -Core- 8 March 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 54 (6) , 1613-1623
A 230–260-GHz Wideband and High-Gain Amplifier in 65-nm CMOS Based on Dual-Peak $G_{{\mathrm{max}}}$ -Core