AHAdele Hilico

Adele Hilico

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Adele Hilico has a total of 15 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Capture de forces à atomes piégés dans un réseau optique : caractérisation des performances

    by Adèle Hilico

    Ce mémoire présente la réalisation d'un dispositif expérimental de deuxième génération pour le projet FORCA-G (FORce de CAsimir et Gravitation à courte distance). L'objectif de ce projet est la mesure des interactions à faible distance entre un atome et une surface massive. La mesure de force est réalisée à l'aide d'interféromètres atomiques utilisant des atomes confinés dans un réseau optique 1D vertical basé sur le déplacement des atomes de puits en puits. La dégénérescence des niveaux d'énergies des atomes dans les puits du réseau est levée par la force que l'on cherche à mesurer. Des transitions Raman permettent de séparer les atomes dans des puits adjacents, puis de les recombiner, créant ainsi un interféromètre atomique qui permet de mesurer la différence d'énergie entre puits, liée à la fréquence de Bloch nu B du réseau. Ce travail présente la mise en place d'un dispositif proprement dédié au projet, qui permettra à terme de mesurer les forces à faible distance. Il rend compte des améliorations obtenues en configuration de gravimètre sur la sensibilité court terme de la mesure qui atteint 5. 10^-6 à 1 s. Il regroupe l'étude des limitations de la sensibilité, de l'exactitude et l'étude de la perte de contraste des interféromètres. Il présente aussi la mise en place d'une étape supplémentaire : l'implémentation d'un piège dipolaire visant obtenir un échantillon d'atomes plus dense et plus froid.

  • Influence of Pump Properties on the Tunability of 1.5 μm Low-Noise Single Frequency Fiber Amplifier

    by Dia Darwich, Yves-Vincent Bardin, Mathieu Goeppner, Clement Dixneuf, Germain Guiraud, Nicholas Traynor, Giorgio Santarelli, Adele Hilico

    In this work, we investigate the impact of the pump configuration (wavelength and pump scheme i.e., backward forward) on the tuning range in a watt level low intensity noise single-frequency Erbium/Ytterbium doped fiber amplifier. Two different pump wavelengths, 976 nm and 940 nm, and three different pumping schemes were numerically and experimentally investigated. Tunability over 47 nm (1533 nm-1580 nm) with relative intensity noise level as low as −155 dB/Hz is achieved using an unconventional pumping scheme where the active fiber is pumped in both directions with two different pump wavelengths.


  • Multi-Watt Low Noise All-Fiber 997nm-1017nm Tunable Laser

    by B. Gouhier, C. Dixneuf, A. Hilico, G. Guiraud, N. Traynor, G. Santarelli

    Motivated by significant research efforts focused on overcoming technological challenges, fiber-based lasers are very convincing choices for numerous applications requiring high-power, low-noise laser light [1,2]. Using a master oscillator power amplifier (MOPA) architecture, it is also possible to achieve single-frequency (SF) operation at high power.


  • Low Intensity Noise High-Power Tunable Fiber-Based Laser Around 1007 nm

    by Benoit Gouhier, Clement Dixneuf, Adele Hilico, Germain Guiraud, Nicholas Traynor, Giorgio Santarelli

    We report the development of a tunable, low-noise, all-fiber, single-frequency, linearly polarized high-power master oscillator power amplifier operating over 20 nm, from 1017 nm down to 997 nm. Using Ytterbium highly-doped silica fiber with large mode area, more than 3 W of 997 nm signal was obtained with less than 2% of ASE. These figures keep improving with operating wavelength, to reach more than 16 W and 0.03% of ASE at 1017 nm. The optical signal to noise ratio exceeds 40 dB for the worst case up to more than 60 dB. In addition, relative intensity noise remains very low over the whole tuning range (-130 dBc@10 kHz) down to -160 dBc at 10 MHz. This robust laser has a strong potential to be a new workhorse for demanding applications in this spectral range.


  • Atomic multiwave interferometer in an optical lattice

    by Min-Kang Zhou, Bruno Pelle, Adèle Hilico, Franck Pereira dos Santos

    A multiwave atom interferometer using multiple Wannier-Stark states is experimentally realized in a vertical optical lattice. Atoms are coherently driven by stimulated Raman transitions into a superposition of several adjacent lattice sites, in which they evolve at multiples of Bloch frequency in the same internal state to form an interference pattern. We observe coherent evolution for more than 500 Bloch periods. The noise analysis shows that the phase resolution of this interferometer is detection noise limited. This multiwave interferometer could be a potential instrument for gravimetry and short-range forces measurement. DOI: http://dx.doi.org/10.1103/PhysRevA.88.013604 ©2013 American Physical Society