BHBernhard Hofbeck

Bernhard Hofbeck

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Bernhard Hofbeck has a total of 12 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Quantitative Analysis of the Separate Influences of Material Composition and Local Defects on theVocof PV Devices: An Exemplary Study on CIGS

    by Johannes Hepp, Andreas Vetter, Bernhard Hofbeck, Umair Sultan, Jens A. Hauch, Christian Camus, Christoph J. Brabec

    A lot of effort is required in order to close the efficiency gap between laboratory record Cu(In,Ga)Se $_{2}$ (CIGS) solar cells and commercially produced modules. An obstacle easily overlooked is the fact that reduced module performance may have multiple root causes. Here, we show how to isolate two main factors that influence the open circuit voltage (V $_\text{oc}$ ) of photovoltaic devices, the material composition and the local defects, here shunts in particular, i.e., regions of significantly lowered resistivity. In order to characterize the material composition, we used electroluminescence spectroscopy. Additionally, we investigated the effect of local defects on the V $_\text{oc}$ , by the use of thermography. Which of both factors dominates the resulting V $_\text{oc}$ depends on the insolation intensity under which the device is operated. We established a model in order to estimate the V $_\text{oc}$ as a function of the luminescence peak wavelength, the quantification of the thermal hot spots caused by local defects, and the insolation intensity. Subsequently, we investigated how these factors affect the electrical conversion efficiency of the device. The combination of these two measurement techniques results in a more conclusive evaluation of the electrical parameters, thereby enabling an improved quality assessment to allow a successive process optimization. This approach is also applicable to other thin film PV technologies such as perovskite and organic solar cells.

  • Open Access

    Analysis of the LIF/Mie Ratio from Individual Droplets for Planar Droplet Sizing: Application to Gasoline Fuels and Their Mixtures with Ethanol

    by Matthias Koegl, Kevin Baderschneider, Florian J. Bauer, Bernhard Hofbeck, Edouard Berrocal, Stefan Will, Lars Zigan

    In this work, the possibility of using planar droplet sizing (PDS) based on laser-induced fluorescence (LIF) and Mie scattering was investigated within the framework of measuring the droplet Sauter mean diameter (SMD) of direct-injection spark-ignition (DISI) spray systems. For this purpose, LIF and Mie signals of monodisperse fuel droplets produced by a droplet generator were studied at engine relevant diameters (20–50 µm). The surrogate gasoline fuel Toliso (consisting of 65 vol. % isooctane, 35 vol. % toluene) and the biofuel blend E20 (consisting of 80 vol. % Toliso, 20 vol. % ethanol) were used and which were doped with the fluorescence dye “nile red”. The effects of ethanol admixture, dye concentration, laser power, and temperature variation on the LIF/Mie ratio were studied simultaneously at both macroscopic and microscopic scale. The deduced calibration curves of the LIF and Mie signals of both fuels showed volumetric and surface dependent behaviors, respectively, in accordance with the assumptions in the literature. The existence of glare points and morphology-dependent resonances (MDRs) lead to slightly higher LIF and Mie exponents of E20 in comparison to Toliso. In principle, these calibration curves enable the determination of the SMD from LIF/Mie ratio images of transient fuel sprays.